/openbmc/u-boot/tools/kermit/ |
H A D | send_image | 3 # e.g. send_image output.bin 1F00000 15 set window 5
|
/openbmc/u-boot/doc/ |
H A D | README.uniphier | 238 5. Compile U-Boot again 295 Data Size: 5264365 Bytes = 5 MiB 429 bit 5 ----> SERIAL_SEL[1] 440 bit 5 Don't Care Reserve 450 0b00 15MB RAM / 1MB Peri 00000000-00efffff 00f00000-00ffffff 451 0b01 31MB RAM / 1MB Peri 00000000-01efffff 01f00000-01ffffff 452 0b10 64MB RAM / 1MB Peri 00000000-03efffff 03f00000-03ffffff 453 0b11 127MB RAM / 1MB Peri 00000000-07efffff 07f00000-07ffffff
|
/openbmc/linux/Documentation/devicetree/bindings/clock/ |
H A D | qcom,sm6375-dispcc.yaml | 43 clock-controller@5f00000 {
|
H A D | qcom,sm6115-dispcc.yaml | 57 clock-controller@5f00000 {
|
H A D | qcom,qcm2290-dispcc.yaml | 68 clock-controller@5f00000 {
|
H A D | qcom,dispcc-sm6125.yaml | 79 clock-controller@5f00000 {
|
/openbmc/linux/Documentation/devicetree/bindings/bus/ |
H A D | socionext,uniphier-system-bus.yaml | 53 bank 0 to 0x42000000-0x43ffffff, bank 5 to 0x46000000-0x46ffffff 55 bank 0 to 0x48000000-0x49ffffff, bank 5 to 0x44000000-0x44ffffff 61 "^.*@[1-5],[1-9a-f][0-9a-f]+$": 88 <5 0x00000000 0x46000000 0x01000000>; 90 ethernet@1,1f00000 { 97 serial@5,200000 { 99 reg = <5 0x00200000 0x20>;
|
/openbmc/linux/arch/powerpc/boot/dts/ |
H A D | xcalibur1501.dts | 86 partition@6f00000 { 90 partition@7f00000 { 116 partition@6f00000 { 120 partition@7f00000 { 422 interrupts = <5 1>; 427 interrupts = <5 1>; 612 gpios = <&gpio0 5 1>;
|
H A D | pcm032.dts | 101 5 0 0xe6000000 0x02000000 124 partition@1f00000 { 167 * device@5,0 { 169 * reg = <5 0 0x02000000>;
|
H A D | xpedite5301.dts | 86 partition@6f00000 { 90 partition@7f00000 { 116 partition@6f00000 { 120 partition@7f00000 { 522 gpios = <&gpio0 5 1>;
|
H A D | xpedite5370.dts | 84 partition@6f00000 { 88 partition@7f00000 { 114 partition@6f00000 { 118 partition@7f00000 { 520 gpios = <&gpio0 5 1>;
|
H A D | xpedite5330.dts | 122 partition@6f00000 { 126 partition@7f00000 { 152 partition@6f00000 { 156 partition@7f00000 { 558 gpios = <&gpio0 5 1>;
|
H A D | lite5200b.dts | 79 // cell-index = <5>; 142 partition@1f00000 {
|
/openbmc/u-boot/include/configs/ |
H A D | ls1046aqds.h | 107 #define CONFIG_FLASH_SHOW_PROGRESS 45 /* count down from 45/5: 9..1 */ 126 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 435 #define CONFIG_ENV_OFFSET 0x500000 /* 5MB */ 462 "e0000 f00000 && bootm $kernel_load" 470 "e0000 f00000 && bootm $kernel_load"
|
/openbmc/linux/arch/arm/boot/dts/qcom/ |
H A D | qcom-apq8026-huawei-sturgeon.dts | 22 sbl_region: sbl@2f00000 { 47 modem_efs_region: modem-efs@7f00000 { 77 vibrator@5a {
|
/openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
H A D | imx25.dtsi | 78 bus@43f00000 { /* AIPS1 */ 85 aips1: bridge@43f00000 { 224 interrupts = <5>; 335 bus@53f00000 { /* AIPS2 */ 342 aips2: bridge@53f00000 {
|
H A D | imx31.dtsi | 66 aips1: bus@43f00000 { /* AIPS1 */ 228 bus@53f00000 { /* AIPS2 */ 366 5 0 0xb6000000 0x02000000>;
|
H A D | imx35.dtsi | 69 aips1: bus@43f00000 { 202 aips2: bus@53f00000 { 389 5 0 0xb6000000 0x2000000
|
/openbmc/linux/arch/arm/boot/dts/broadcom/ |
H A D | bcm47094-linksys-panamera.dts | 88 gpios = <&chipcommon 5 GPIO_ACTIVE_HIGH>; 235 port@5 { 292 partition@1f00000 {
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | fsl-ls1012a.dtsi | 146 compatible = "fsl-usb2-dr-v2.5", "fsl-usb2-dr"; 153 usb1: usb3@2f00000 {
|
/openbmc/linux/arch/arm/boot/dts/marvell/ |
H A D | kirkwood-c200-v1.dts | 103 led-5 { 230 partition@2f00000 { 237 partition@5a00000 {
|
H A D | armada-370-dlink-dns327l.dts | 302 partition@5d00000 { 304 /* 5 MiB */ 314 partition@7f00000 {
|
/openbmc/linux/arch/arm/boot/dts/nuvoton/ |
H A D | nuvoton-npcm730-gsj.dts | 174 reserved@1f00000 { 222 lm75@5c { 232 lm75@5c { 242 lm75@5c { 251 lm75@5c { 343 i2c_u25: i2c@5 { 346 reg = <5>;
|
/openbmc/linux/arch/mips/boot/dts/ingenic/ |
H A D | rs90.dts | 24 vmem: video-memory@1f00000 { 86 key-5 { 258 ingenic,nemc-tAH = <5>;
|
/openbmc/linux/arch/powerpc/boot/dts/fsl/ |
H A D | p1022ds.dtsi | 73 partition@7f00000 { 222 fsl,tclk-period = <5>;
|