Lines Matching +full:- +full:- +full:pfuze3000
1 // SPDX-License-Identifier: GPL-2.0+
4 * Copyright 2017-2018 NXP
7 /dts-v1/;
13 compatible = "fsl,imx6ul-9x9-evk", "fsl,imx6ul";
20 stdout-path = &uart1;
28 compatible = "simple-bus";
29 #address-cells = <1>;
30 #size-cells = <0>;
33 compatible = "regulator-fixed";
35 regulator-name = "can-3v3";
36 regulator-min-microvolt = <3300000>;
37 regulator-max-microvolt = <3300000>;
41 reg_gpio_dvfs: regulator-gpio {
42 compatible = "regulator-gpio";
43 pinctrl-names = "default";
44 pinctrl-0 = <&pinctrl_dvfs>;
45 regulator-min-microvolt = <1300000>;
46 regulator-max-microvolt = <1400000>;
47 regulator-name = "gpio_dvfs";
48 regulator-type = "voltage";
54 compatible = "regulator-fixed";
55 regulator-name = "VSD_3V3";
56 regulator-min-microvolt = <3300000>;
57 regulator-max-microvolt = <3300000>;
59 off-on-delay = <20000>;
60 enable-active-high;
64 soft_spi: soft-spi {
65 compatible = "spi-gpio";
66 pinctrl-names = "default";
67 pinctrl-0 = <&pinctrl_spi4>;
68 pinctrl-assert-gpios = <&gpio5 8 GPIO_ACTIVE_LOW>;
70 gpio-sck = <&gpio5 11 0>;
71 gpio-mosi = <&gpio5 10 0>;
72 cs-gpios = <&gpio5 7 0>;
73 num-chipselects = <1>;
74 #address-cells = <1>;
75 #size-cells = <0>;
79 gpio-controller;
80 #gpio-cells = <2>;
82 registers-number = <1>;
83 registers-default = /bits/ 8 <0x57>;
84 spi-max-frequency = <100000>;
90 pinctrl-names = "default";
91 pinctrl-0 = <&pinctrl_enet1>;
92 phy-mode = "rmii";
93 phy-handle = <ðphy0>;
98 pinctrl-names = "default";
99 pinctrl-0 = <&pinctrl_enet2>;
100 phy-mode = "rmii";
101 phy-handle = <ðphy1>;
105 #address-cells = <1>;
106 #size-cells = <0>;
108 ethphy0: ethernet-phy@2 {
109 compatible = "ethernet-phy-ieee802.3-c22";
113 ethphy1: ethernet-phy@1 {
114 compatible = "ethernet-phy-ieee802.3-c22";
121 clock-frequency = <100000>;
122 pinctrl-names = "default", "gpio";
123 pinctrl-0 = <&pinctrl_i2c1>;
124 pinctrl-1 = <&pinctrl_i2c1_gpio>;
125 scl-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
126 sda-gpios = <&gpio1 29 GPIO_ACTIVE_HIGH>;
129 pmic: pfuze3000@08 {
130 compatible = "fsl,pfuze3000";
135 regulator-min-microvolt = <700000>;
136 regulator-max-microvolt = <3300000>;
137 regulator-boot-on;
138 regulator-always-on;
139 regulator-ramp-delay = <6250>;
144 regulator-min-microvolt = <700000>;
145 regulator-max-microvolt = <1475000>;
146 regulator-boot-on;
147 regulator-always-on;
148 regulator-ramp-delay = <6250>;
152 regulator-min-microvolt = <2500000>;
153 regulator-max-microvolt = <3300000>;
154 regulator-boot-on;
155 regulator-always-on;
159 regulator-min-microvolt = <900000>;
160 regulator-max-microvolt = <1650000>;
161 regulator-boot-on;
162 regulator-always-on;
166 regulator-min-microvolt = <5000000>;
167 regulator-max-microvolt = <5150000>;
171 regulator-min-microvolt = <1000000>;
172 regulator-max-microvolt = <3000000>;
173 regulator-boot-on;
174 regulator-always-on;
178 regulator-boot-on;
179 regulator-always-on;
183 regulator-min-microvolt = <1800000>;
184 regulator-max-microvolt = <3300000>;
185 regulator-always-on;
189 regulator-min-microvolt = <800000>;
190 regulator-max-microvolt = <1550000>;
191 regulator-always-on;
195 regulator-min-microvolt = <2850000>;
196 regulator-max-microvolt = <3300000>;
197 regulator-always-on;
201 regulator-min-microvolt = <2850000>;
202 regulator-max-microvolt = <3300000>;
203 regulator-always-on;
207 regulator-min-microvolt = <1800000>;
208 regulator-max-microvolt = <3300000>;
209 regulator-always-on;
213 regulator-min-microvolt = <1800000>;
214 regulator-max-microvolt = <3300000>;
215 regulator-always-on;
230 interrupt-parent = <&gpio5>;
237 pinctrl-names = "default", "gpio";
238 pinctrl-0 = <&pinctrl_i2c2>;
239 pinctrl-1 = <&pinctrl_i2c2_gpio>;
240 scl-gpios = <&gpio1 30 GPIO_ACTIVE_HIGH>;
241 sda-gpios = <&gpio1 31 GPIO_ACTIVE_HIGH>;
246 pinctrl-names = "default";
247 pinctrl-0 = <&pinctrl_hog_1>;
248 imx6ul-evk {
285 pinctrl_hog_1: hoggrp-1 {
408 pinctrl-names = "default";
409 pinctrl-0 = <&pinctrl_qspi>;
414 #address-cells = <1>;
415 #size-cells = <1>;
417 spi-max-frequency = <29000000>;
418 spi-nor,ddr-quad-read-dummy = <6>;
424 pinctrl-names = "default";
425 pinctrl-0 = <&pinctrl_uart1>;
430 pinctrl-names = "default";
431 pinctrl-0 = <&pinctrl_usb_otg1_id>;
433 srp-disable;
434 hnp-disable;
435 adp-disable;
441 disable-over-current;
446 pinctrl-names = "default", "state_100mhz", "state_200mhz";
447 pinctrl-0 = <&pinctrl_usdhc1>;
448 pinctrl-1 = <&pinctrl_usdhc1_100mhz>;
449 pinctrl-2 = <&pinctrl_usdhc1_200mhz>;
450 cd-gpios = <&gpio1 19 GPIO_ACTIVE_LOW>;
451 keep-power-in-suspend;
452 enable-sdio-wakeup;
453 vmmc-supply = <®_sd1_vmmc>;
458 pinctrl-names = "default";
459 pinctrl-0 = <&pinctrl_usdhc2>;
460 no-1-8-v;
461 non-removable;
462 keep-power-in-suspend;
463 enable-sdio-wakeup;
468 pinctrl-names = "default";
469 pinctrl-0 = <&pinctrl_wdog>;
470 fsl,ext-reset-output;