arm/dts/at91sam9m10g45ek.dts

2  * at91sam9m10g45ek.dts - Device Tree file for AT91SAM9M10G45-EK board
9 /dts-v1/;
11 #include <dt-bindings/pwm/pwm.h>
14 	model = "Atmel AT91SAM9M10G45-EK";
19 		stdout-path = "serial0:115200n8";
20 		u-boot,dm-pre-reloc;
29 		      clock-frequency = <32768>;
33 		      clock-frequency = <12000000>;
41 				u-boot,dm-pre-reloc;
45 				pinctrl-0 =
53 				phy-mode = "rmii";
62 					pinctrl-names = "default";
63 					pinctrl-0 = <&pinctrl_pck1_as_isi_mck &pinctrl_sensor_power &pinctrl_sensor_reset>;
64 					resetb-gpios = <&pioD 12 GPIO_ACTIVE_LOW>;
65 					pwdn-gpios = <&pioD 13 GPIO_ACTIVE_HIGH>;
67 					clock-names = "xvclk";
68 					assigned-clocks = <&pck1>;
69 					assigned-clock-rates = <25000000>;
73 							remote-endpoint = <&isi_0>;
74 							bus-width = <8>;
89 				pinctrl-0 = <
96 					bus-width = <4>;
97 					cd-gpios = <&pioD 10 GPIO_ACTIVE_HIGH>;
102 				pinctrl-0 = <
109 					bus-width = <4>;
110 					cd-gpios = <&pioD 11 GPIO_ACTIVE_HIGH>;
111 					wp-gpios = <&pioD 29 GPIO_ACTIVE_HIGH>;
117 					pinctrl_pck1_as_isi_mck: pck1_as_isi_mck-0 {
122 					pinctrl_sensor_reset: sensor_reset-0 {
127 					pinctrl_sensor_power: sensor_power-0 {
133 					pinctrl_board_mmc0: mmc0-board {
140 					pinctrl_board_mmc1: mmc1-board {
148 					pinctrl_pwm_leds: pwm-led {
158 				cs-gpios = <&pioB 3 0>, <0>, <0>, <0>;
161 					spi-max-frequency = <13000000>;
167 				atmel,vbus-gpio = <&pioB 19 GPIO_ACTIVE_HIGH>;
171 			adc0: adc@fffb0000 {
172 				pinctrl-names = "default";
173 				pinctrl-0 = <
182 				atmel,adc-ts-wires = <4>;
187 				pinctrl-names = "default";
188 				pinctrl-0 = <&pinctrl_isi_data_0_7>;
192 						remote-endpoint = <&ov2640_0>;
193 						bus-width = <8>;
194 						vsync-active = <1>;
195 						hsync-active = <1>;
203 				pinctrl-names = "default";
204 				pinctrl-0 = <&pinctrl_pwm_leds>;
208 				atmel,rtt-rtc-time-reg = <&gpbr 0x0>;
226 				bits-per-pixel = <32>;
227 				atmel,lcdcon-backlight;
230 				atmel,guard-time = <9>;
231 				atmel,lcd-wiring-mode = "RGB";
233 				display-timings {
234 					native-mode = <&timing0>;
236 						clock-frequency = <9000000>;
239 						hback-porch = <1>;
240 						hfront-porch = <1>;
241 						vback-porch = <40>;
242 						vfront-porch = <1>;
243 						hsync-len = <45>;
244 						vsync-len = <1>;
251 			nand-bus-width = <8>;
252 			nand-ecc-mode = "soft";
253 			nand-on-flash-bbt;
274 			num-ports = <2>;
275 			atmel,vbus-gpio = <&pioD 1 GPIO_ACTIVE_LOW
285 		compatible = "gpio-leds";
290 			linux,default-trigger = "heartbeat";
295 		compatible = "pwm-leds";
300 			max-brightness = <255>;
301 			linux,default-trigger = "nand-disk";
307 			max-brightness = <255>;
308 			linux,default-trigger = "mmc0";
313 		compatible = "gpio-keys";
319 			wakeup-source;
326 			wakeup-source;
330 			label = "Joystick Left";
336 			label = "Joystick Right";
342 			label = "Joystick Up";
348 			label = "Joystick Down";
354 			label = "Joystick Press";