Merge commit 'v2.6.34-rc1' into for-linus

Merge branch 'origin' into devel-stable

Conflicts:
arch/arm/mach-mx2/devices.c
arch/arm/mach-mx2/devices.h
sound/soc/pxa/pxa-ssp.c

Merge branch 'master' of /repos/git/linux-2.6

Conflicts:
net/ipv4/netfilter/nf_nat_core.c
net/netfilter/nf_conntrack_core.c
net/netfilter/nf_conntrack_netlink.c

Signed-off-by: Patrick McHardy <k

Merge branch 'master' of /repos/git/linux-2.6

Conflicts:
net/ipv4/netfilter/nf_nat_core.c
net/netfilter/nf_conntrack_core.c
net/netfilter/nf_conntrack_netlink.c

Signed-off-by: Patrick McHardy <kaber@trash.net>

show more ...

Merge branch 'writeback-for-2.6.34' into nfs-for-2.6.34

Merge branch 'tip/tracing/urgent' of git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/linux-2.6-trace into tracing/urgent

Merge with mainline to remove plat-omap/Kconfig conflict

Conflicts:
arch/arm/plat-omap/Kconfig

Merge branch 'linus' into core/rcu

Merge reason: Backmerge latest upstream to queue up dependent fix in the
scheduler.

Signed-off-by: Ingo Molnar <mingo@elte.hu>

Merge branch 'master' of /home/davem/src/GIT/linux-2.6/

Conflicts:
drivers/firmware/iscsi_ibft.c

Merge git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6: (187 commits)
sh: remove dead LED code for migo-r and ms7724se
sh

Merge git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6: (187 commits)
sh: remove dead LED code for migo-r and ms7724se
sh: ecovec build fix for CONFIG_I2C=n
sh: ecovec r-standby support
sh: ms7724se r-standby support
sh: SH-Mobile R-standby register save/restore
clocksource: Fix up a registration/IRQ race in the sh drivers.
sh: ms7724: modify scan_timing for KEYSC
sh: ms7724: Add sh_sir support
sh: mach-ecovec24: Add sh_sir support
sh: wire up SET/GET_UNALIGN_CTL.
sh: allow alignment fault mode to be configured at kernel boot.
sh: sh7724: Update FSI/SPU2 clock
sh: always enable sh7724 vpu_clk and set to 166MHz on Ecovec
sh: add sh7724 kick callback to clk_div4_table
sh: introduce struct clk_div4_table
sh: clock-cpg div4 set_rate() shift fix
sh: Turn on speculative return for SH7785 and SH7786
sh: Merge legacy and dynamic PMB modes.
sh: Use uncached I/O helpers in PMB setup.
sh: Provide uncached I/O helpers.
...

show more ...

sh: Fix an off-by-1 in SH7780 PCIC memory resource mapping.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh: Fix up early PCI PERR/SERR IRQ handling.

This adds support for handling early PERR/SERR triggering in between
controller registration and the initial bus scan. Buggy cards end up
asserting these

sh: Fix up early PCI PERR/SERR IRQ handling.

This adds support for handling early PERR/SERR triggering in between
controller registration and the initial bus scan. Buggy cards end up
asserting these as soon as the M66EN scan is undertaken, resulting in
an early crash.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Improved multi-resource handling for SH7780 PCI.

The SH7780 PCI controller supports 3 different ranges of PCI memory in
addition to its PCI I/O window. In the case of 29-bit mode, only 2 memory

sh: Improved multi-resource handling for SH7780 PCI.

The SH7780 PCI controller supports 3 different ranges of PCI memory in
addition to its PCI I/O window. In the case of 29-bit mode, only 2 memory
windows are supported, while in 32-bit mode all 3 are visible. This
attempts to make the resource handling completely dynamic and to permit
platforms to map in as many apertures as they can handle.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Hook up ERR/PERR/SERR detection for SH7780 PCI host controllers.

These were never handled before, so implement some common infrastructure
to support them, then make use of that in the SH7780-spe

sh: Hook up ERR/PERR/SERR detection for SH7780 PCI host controllers.

These were never handled before, so implement some common infrastructure
to support them, then make use of that in the SH7780-specific code. In
practice there is little here that can not be generalized for SH4 parts,
which will be an incremental change as the 7780/7751 code is gradually
unified.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Handle PCI controller resource conflicts.

register_pci_controller() can fail, but presently is a void function.
Change this over to an int so that we can bail early before continuing on
with pos

sh: Handle PCI controller resource conflicts.

register_pci_controller() can fail, but presently is a void function.
Change this over to an int so that we can bail early before continuing on
with post-registration initialization (such as throwing the controller in
to 66MHz mode in the case of the SH7780 host controller).

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Enable PCI66 support for SH7780 host controller.

This adds some helper glue for scanning the bus and determining if all
of the devices are 66MHz capable or not before flipping on 66MHz mode.
Thi

sh: Enable PCI66 support for SH7780 host controller.

This adds some helper glue for scanning the bus and determining if all
of the devices are 66MHz capable or not before flipping on 66MHz mode.
This isn't quite to spec, but it's fairly consistent with what other
embedded controllers end up having to do.

Scanning code cribbed from the MIPS txx9 PCI code.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Fix up large system memory handling for SH7780 PCI.

For systems that have more than 512MB we need to set up an additional
mapping, this fixes up the rounding to the next power of two and splits

sh: Fix up large system memory handling for SH7780 PCI.

For systems that have more than 512MB we need to set up an additional
mapping, this fixes up the rounding to the next power of two and splits
out the mapping accordingly between the two local bus mapping windows.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Kill off broken type 1 PCI config access checks.

The host controllers only support type 1, so there's not much else to
test for. Some of the older controllers also supported type 2 accesses,
but

sh: Kill off broken type 1 PCI config access checks.

The host controllers only support type 1, so there's not much else to
test for. Some of the older controllers also supported type 2 accesses,
but we've never supported those, and likely never will. Beyond that, the
P1SEG test is meaningless for 32-bit mode, so rather than refactoring it,
just kill the type 1 test off completely.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

sh: Reworked SH7780 PCI initialization.

This consolidates the PCI initialization code for all of the pci-sh7780
users, and sets up the memory window dynamically as opposed to using
hardcoded window

sh: Reworked SH7780 PCI initialization.

This consolidates the PCI initialization code for all of the pci-sh7780
users, and sets up the memory window dynamically as opposed to using
hardcoded window positions.

A number of bugs were fixed at the same time, including the PIO handling
and master abort timeout settings being incorrect.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

show more ...

Merge branch 'topic/asoc' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound-2.6 into upstream/wm8711

Merge branch 'linus' into tracing/hw-breakpoints

Conflicts:
arch/x86/Kconfig
arch/x86/kernel/traps.c
arch/x86/power/cpu.c
arch/x86/power/cpu_32.c
kernel/Makefile

Semantic conflict:
arch/x86/k

Merge branch 'linus' into tracing/hw-breakpoints

Conflicts:
arch/x86/Kconfig
arch/x86/kernel/traps.c
arch/x86/power/cpu.c
arch/x86/power/cpu_32.c
kernel/Makefile

Semantic conflict:
arch/x86/kernel/hw_breakpoint.c

Merge reason: Resolve the conflicts, move from put_cpu_no_sched() to
put_cpu() in arch/x86/kernel/hw_breakpoint.c.

Signed-off-by: Ingo Molnar <mingo@elte.hu>

show more ...

Merge branch 'next' into for-linus

Merge branch 'dmaengine' into async-tx-next

Conflicts:
crypto/async_tx/async_xor.c
drivers/dma/ioat/dma_v2.h
drivers/dma/ioat/pci.c
drivers/md/raid5.c

Merge commit 'v2.6.31-rc1' into dmaengine

Merge branch 'for-2.6.32' into mxc

Conflicts:
sound/soc/Makefile

Merge commit 'v2.6.31-rc4' into next