Home
last modified time | relevance | path

Searched refs:signaling (Results 1 – 25 of 73) sorted by relevance

123

/openbmc/linux/arch/arm/nwfpe/
H A Dsoftfloat-specialize91 Returns 1 if the single-precision floating-point value `a' is a signaling
105 `a' to the canonical NaN format. If `a' is a signaling NaN, the invalid
138 signaling NaN, the invalid exception is raised.
183 Returns 1 if the double-precision floating-point value `a' is a signaling
199 `a' to the canonical NaN format. If `a' is a signaling NaN, the invalid
235 signaling NaN, the invalid exception is raised.
286 signaling NaN; otherwise returns 0.
307 point NaN `a' to the canonical NaN format. If `a' is a signaling NaN, the
344 `b' is a signaling NaN, the invalid exception is raised.
/openbmc/linux/Documentation/devicetree/bindings/mmc/
H A Dnvidia,tegra20-sdhci.yaml114 signaling modes.
119 automatic calibration times out on a 1.8 V signaling mode.
124 signaling modes.
129 automatic calibration times out on a 3.3 V signaling mode.
142 signaling modes.
147 automatic calibration times out on a 1.8 V signaling mode.
152 signaling modes.
164 automatic calibration times out on a 3.3 V signaling mode.
/openbmc/linux/arch/arm/boot/dts/ti/omap/
H A Dtwl4030_omap3.dtsi26 * this file. For proper idle mode signaling with sys_clkreq and sys_off_mode
28 * sys_nvmode2 signaling.
H A Dam5729-beagleboneai.dts556 /* DS: Default speed (DS) up to 25 MHz, including 1- and 4-bit modes (3.3 V signaling). */
557 /* HS: High speed up to 50 MHz (3.3 V signaling). */
558 /* SDR12: SDR up to 25 MHz (1.8 V signaling). */
559 /* SDR25: SDR up to 50 MHz (1.8 V signaling). */
560 /* SDR50: SDR up to 100 MHz (1.8 V signaling). */
561 /* SDR104: SDR up to 208 MHz (1.8 V signaling) */
562 /* DDR50: DDR up to 50 MHz (1.8 V signaling). */
/openbmc/u-boot/arch/arm/dts/
H A Dtwl4030_omap3.dtsi29 * this file. For proper idle mode signaling with sys_clkreq and sys_off_mode
31 * sys_nvmode2 signaling.
/openbmc/linux/Documentation/devicetree/bindings/arm/tegra/
H A Dnvidia,tegra186-pmc.yaml73 state and signaling voltage. A pad can be either in active or
74 power down mode. The support for power state and signaling voltage
76 1.8 V signaling voltages are supported on pins where software
77 controllable signaling voltage switching is available.
131 signaling voltages: sdmmc2-hv, dmic-hv, sdmmc1-hv, sdmmc3-hv,
H A Dnvidia,tegra20-pmc.yaml277 and signaling voltage. A pad can be either in active or power down mode.
278 The support for power state and signaling voltage configuration varies
279 depending on the pad in question. 3.3V and 1.8V signaling voltages
280 are supported on pins where software controllable signaling voltage
317 TEGRA_IO_PAD_VOLTAGE_3V3 to select between signaling voltages.
321 pads. None of the Tegra124 or Tegra132 pads support signaling
/openbmc/qemu/fpu/
H A Dsoftfloat-specialize.c.inc84 * signaling NaNs (so all NaNs are treated as quiet).
95 /* Define how the architecture discriminates signaling NaNs.
317 | Returns 1 if the bfloat16 value `a' is a signaling
397 * 1. A if it is signaling
398 * 2. B if it is signaling
410 * 1. A if it is signaling
411 * 2. B if it is signaling
414 * A signaling NaN is always silenced before returning it.
429 * A signaling NaN is always silenced before returning it.
773 | `b' is a signaling NaN, the invalid exception is raised.
[all …]
/openbmc/linux/drivers/gpu/host1x/
H A Dfence.c77 if (atomic_xchg(&f->signaling, 1)) { in host1x_fence_signal()
104 if (atomic_xchg(&f->signaling, 1)) { in do_fence_timeout()
H A Dfence.h12 atomic_t signaling; member
/openbmc/linux/Documentation/driver-api/gpio/
H A Dintro.rst51 other value (notably, "open drain" signaling).
55 cases (to support bidirectional signaling). GPIO controllers may have
96 driven) signaling. That term applies to CMOS transistors; "open collector" is
105 don't. When you need open drain signaling but your hardware doesn't directly
115 The same logic can be applied to emulate open source signaling, by driving the
123 delays the rising edge of SCK, and the I2C master adjusts its signaling rate
/openbmc/linux/Documentation/devicetree/bindings/mailbox/
H A Dst,stm32-ipcc.yaml10 The IPCC block provides a non blocking signaling mechanism to post and
12 It provides the signaling for N bidirectionnal channels. The number of
/openbmc/openbmc/meta-openembedded/meta-python/recipes-devtools/python/
H A Dpython3-blinker_1.7.0.bb1 DESCRIPTION = "Fast, simple object-to-object and broadcast signaling."
/openbmc/linux/net/atm/
H A DMakefile6 atm-y := addr.o pvc.o signaling.o svc.o ioctl.o common.o atm_misc.o raw.o resources.o atm_sysfs.o
/openbmc/linux/Documentation/ABI/testing/
H A Dsysfs-devices-power_resources_wakeup7 require ACPI power resources for wakeup signaling.
/openbmc/linux/arch/arm64/boot/dts/freescale/
H A Dimx8qm-apalis.dtsi328 * issues with certain SD cards, disable 1.8V signaling for now.
337 * issues with certain SD cards, disable 1.8V signaling for now.
/openbmc/linux/drivers/platform/x86/intel/wmi/
H A DKconfig10 tristate "Intel WMI Slim Bootloader firmware update signaling driver"
/openbmc/qemu/target/loongarch/insn_trans/
H A Dtrans_fcmp.c.inc6 /* bit0(signaling/quiet) bit1(lt) bit2(eq) bit3(un) bit4(neq) */
/openbmc/linux/Documentation/devicetree/bindings/phy/
H A Dqcom,snps-eusb2-repeater.yaml13 eUSB2 repeater converts between eUSB2 and USB 2.0 signaling levels and
/openbmc/linux/Documentation/devicetree/bindings/i2c/
H A Di2c-arb-gpio-challenge.yaml32 * OUR_CLAIM: output from us signaling to other hosts that we want the bus
33 * THEIR_CLAIMS: output from others signaling that they want the bus
/openbmc/linux/Documentation/devicetree/bindings/misc/
H A Difm-csi.txt7 of the interrupt line signaling frame valid events
/openbmc/linux/Documentation/devicetree/bindings/sound/
H A Dinfineon,peb2466.yaml22 The PEB2466 codec also supports 28 gpios (signaling pins).
/openbmc/linux/Documentation/leds/
H A Dledtrig-oneshot.rst5 This is a LED trigger useful for signaling the user of an event where there are
/openbmc/linux/Documentation/devicetree/bindings/soc/qcom/
H A Dqcom,rpm.yaml47 Three entries specifying the outgoing ipc bit used for signaling the RPM.
/openbmc/linux/Documentation/devicetree/bindings/usb/
H A Dmicrochip,usb5744.yaml13 (LS) USB signaling, offering complete coverage of all defined USB operating

123