| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-driver-hid-ntrig | 7 start of activity (activating touch).
16 acknowledging the end of activity (deactivating touch).
50 activation and activity.
53 activation and activity.
73 (RO) The range for positions reported during activity.
|
| H A D | sysfs-block-device | 6 (RW) Used by drivers which support software controlled activity
12 0 OFF - the LED is not activated on activity
13 1 BLINK_ON - the LED blinks on every 10ms when activity is
16 every 10ms when activity is detected.
20 control the activity LED via the em_message file.
|
| /openbmc/linux/drivers/iio/accel/ |
| H A D | mma9553.c | 190 u8 activity; member
204 static enum iio_modifier mma9553_activity_to_mod(enum activity_level activity) in mma9553_activity_to_mod() argument
206 switch (activity) { in mma9553_activity_to_mod()
313 u8 *activity, u16 *stepcnt) in mma9553_read_activity_stepcnt() argument
327 *activity = mma9553_get_bits(buf[0], MMA9553_MASK_STATUS_ACTIVITY); in mma9553_read_activity_stepcnt()
363 ret = mma9553_read_activity_stepcnt(data, &data->activity, in mma9553_conf_gpio()
469 u8 activity; in mma9553_read_raw() local
497 activity = in mma9553_read_raw()
505 if (chan->channel2 == mma9553_activity_to_mod(activity)) in mma9553_read_raw()
1009 u8 activity; in mma9553_event_handler() local
[all …]
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-support/atop/ |
| H A D | atop_2.4.0.bb | 1 SUMMARY = "Monitor for system resources and process activity"
3 is capable of reporting the activity of all processes (even if processes have \
4 finished during the interval), daily logging of system and process activity for \
6 etc. At regular intervals, it shows system-level activity related to the CPU, \
|
| /openbmc/linux/drivers/net/ethernet/mellanox/mlxsw/ |
| H A D | spectrum1_acl_tcam.c | 208 bool *activity) in mlxsw_sp1_acl_tcam_region_entry_activity_get() argument
218 *activity = mlxsw_reg_ptce2_a_get(ptce2_pl); in mlxsw_sp1_acl_tcam_region_entry_activity_get()
225 bool *activity) in mlxsw_sp1_acl_tcam_entry_activity_get() argument
234 offset, activity); in mlxsw_sp1_acl_tcam_entry_activity_get()
|
| H A D | spectrum_acl_flex_actions.c | 65 bool *activity) in mlxsw_sp1_act_kvdl_set_activity_get() argument
71 bool *activity) in mlxsw_sp2_act_kvdl_set_activity_get() argument
81 mlxsw_reg_pefa_unpack(pefa_pl, activity); in mlxsw_sp2_act_kvdl_set_activity_get()
|
| H A D | core_acl_flex_actions.h | 19 bool *activity);
52 int mlxsw_afa_block_activity_get(struct mlxsw_afa_block *block, bool *activity);
|
| H A D | spectrum2_acl_tcam.c | 254 bool *activity) in mlxsw_sp2_acl_tcam_entry_activity_get() argument
258 return mlxsw_afa_block_activity_get(entry->act_block, activity); in mlxsw_sp2_acl_tcam_entry_activity_get()
|
| /openbmc/linux/Documentation/trace/ |
| H A D | events-kmem.rst | 25 Heavy activity for these events may indicate that a specific cache is
55 a simple indicator of page allocator activity. Pages may be allocated from
60 amounts of activity imply high activity on the zone->lock. Taking this lock
65 is triggered. Significant amounts of activity here could indicate that the
70 freed in batch with a page list. Significant amounts of activity here could
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-devtools/iptraf/ |
| H A D | iptraf-ng_1.2.1.bb | 7 and activity indicators, TCP/UDP traffic breakdowns, and LAN station \
12 packet counts, IP checksum errors, interface activity and packet size \
16 about their activity; TCP, UDP and other protocol display filters so \
|
| /openbmc/linux/drivers/leds/trigger/ |
| H A D | Kconfig | 39 This allows LEDs to be controlled by disk activity.
46 This allows LEDs to be controlled by MTD activity.
76 tristate "LED activity Trigger"
132 This allows LEDs to be controlled by network device activity.
153 This allows LEDs to be controlled by activity on ttys which includes
|
| H A D | Makefile | 10 obj-$(CONFIG_LEDS_TRIGGER_ACTIVITY) += ledtrig-activity.o
|
| /openbmc/linux/net/ipv6/ |
| H A D | calipso.c | 80 u32 activity; member
218 entry->activity += 1; in calipso_cache_check()
228 if (prev_entry->activity > 0) in calipso_cache_check()
229 prev_entry->activity -= 1; in calipso_cache_check()
230 if (entry->activity > prev_entry->activity && in calipso_cache_check()
231 entry->activity - prev_entry->activity > in calipso_cache_check()
|
| /openbmc/linux/Documentation/arch/arm64/ |
| H A D | amu.rst | 18 The activity monitors extension is an optional extension introduced by the
21 The activity monitors unit, implemented in each CPU, provides performance
53 activity monitors extension. Therefore, when CONFIG_ARM64_AMU_EXTN is
|
| /openbmc/qemu/ |
| H A D | gitdm.config | 5 # reports about development activity in the QEMU repo. The LWN gitdm
10 # A run to generate a report for the last year of activity would be
|
| /openbmc/linux/drivers/usb/common/ |
| H A D | Kconfig | 11 This option adds LED triggers for USB host and/or gadget activity.
14 LEDs and you want to use them as activity indicators for USB host or
|
| /openbmc/linux/Documentation/input/devices/ |
| H A D | ntrig.rst | 36 |min_width |both to decide activation and during activity |
39 | |propagating the end of activity events |
55 |sensor_logical_height, | the range for positions reported during activity |
87 seem to have different profiles. Ghost activity typically shows up as small
|
| /openbmc/openbmc-test-automation/systest/ |
| H A D | network_stability_test.robot | 36 # - Inject network activity on BMC
69 [Documentation] Start creating network activity over BMC network.
|
| /openbmc/u-boot/fs/yaffs2/ |
| H A D | Kconfig | 7 writes are sequential regardless of filesystem activity.
|
| /openbmc/linux/arch/arm/boot/dts/marvell/ |
| H A D | kirkwood-ns2lite.dts | 30 linux,default-trigger = "disk-activity";
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | kirkwood-ns2lite.dts | 30 linux,default-trigger = "disk-activity";
|
| /openbmc/linux/net/ipv4/ |
| H A D | cipso_ipv4.c | 69 u32 activity; member
252 entry->activity += 1; in cipso_v4_cache_check()
262 if (prev_entry->activity > 0) in cipso_v4_cache_check()
263 prev_entry->activity -= 1; in cipso_v4_cache_check()
264 if (entry->activity > prev_entry->activity && in cipso_v4_cache_check()
265 entry->activity - prev_entry->activity > in cipso_v4_cache_check()
|
| /openbmc/openbmc/poky/meta/recipes-devtools/expect/expect/ |
| H A D | 0002-tcl.m4.patch | 4 Upstream-Status: Inactive-Upstream [no activity since 2018; cvs server went read-only]
|
| H A D | 0001-Resolve-string-formatting-issues.patch | 6 Upstream-Status: Inactive-Upstream [no activity since 2018; cvs server went read-only]
|
| /openbmc/linux/arch/arm/boot/dts/sigmastar/ |
| H A D | mstar-infinity-breadbee-common.dtsi | 38 linux,default-trigger = "activity";
|