| /openbmc/u-boot/drivers/usb/common/ |
| H A D | common.c | 45 [USB_SPEED_FULL] = "full-speed",
|
| /openbmc/u-boot/drivers/usb/host/ |
| H A D | xhci-mem.c | 777 case USB_SPEED_FULL: in xhci_setup_addressable_virt_dev()
790 if (speed == USB_SPEED_LOW || speed == USB_SPEED_FULL) { in xhci_setup_addressable_virt_dev()
832 case USB_SPEED_FULL: in xhci_setup_addressable_virt_dev()
|
| H A D | xhci.c | 307 udev->speed == USB_SPEED_FULL ? "" : "micro"); in xhci_parse_exponent_interval()
309 if (udev->speed == USB_SPEED_FULL) { in xhci_parse_exponent_interval()
354 case USB_SPEED_FULL: in xhci_get_endpoint_interval()
1445 else if (udev->speed == USB_SPEED_FULL) in xhci_update_hub_device()
|
| H A D | usb-uclass.c | 215 ret = usb_scan_device(bus, 0, USB_SPEED_FULL, &dev); in usb_scan_bus()
|
| H A D | xhci-ring.c | 779 if (udev->speed == USB_SPEED_FULL) { in xhci_ctrl_tx()
|
| H A D | ehci-hcd.c | 290 if (udev->speed != USB_SPEED_LOW && udev->speed != USB_SPEED_FULL) in ehci_update_endpt2_dev_n_port()
1319 dev->speed == USB_SPEED_FULL) { in _ehci_create_int_queue()
|
| /openbmc/u-boot/drivers/usb/musb-new/ |
| H A D | musb_uboot.c | 207 USB_SPEED_FULL : USB_SPEED_LOW; in _musb_reset_root_port()
386 if (!driver || driver->speed < USB_SPEED_FULL || !driver->bind || in usb_gadget_register_driver()
|
| H A D | musb_gadget_ep0.c | 800 ? USB_SPEED_HIGH : USB_SPEED_FULL; in musb_g_ep0_irq()
|
| H A D | musb_host.c | 2000 case USB_SPEED_FULL:
2015 if (urb->dev->speed <= USB_SPEED_FULL) {
|
| /openbmc/qemu/include/hw/ |
| H A D | usb.h | 56 #define USB_SPEED_FULL 1 macro
61 #define USB_SPEED_MASK_FULL (1 << USB_SPEED_FULL)
|
| /openbmc/u-boot/drivers/usb/emul/ |
| H A D | sandbox_hub.c | 145 *speed = USB_SPEED_FULL; in hub_find_device()
|
| /openbmc/u-boot/drivers/usb/gadget/ |
| H A D | ci_udc.c | 339 if ((max > 64) && (controller.gadget.speed == USB_SPEED_FULL)) in ci_ep_enable()
814 int speed = USB_SPEED_FULL; in udc_irq()
1015 if (driver->speed != USB_SPEED_FULL && driver->speed != USB_SPEED_HIGH) in usb_gadget_register_driver()
|
| H A D | dwc2_udc_otg.c | 238 || (driver->speed != USB_SPEED_FULL in usb_gadget_register_driver()
524 dev->gadget.speed = USB_SPEED_FULL; in set_max_pktsize()
|
| H A D | pxa25x_udc.c | 1570 dev->gadget.speed = USB_SPEED_FULL; in pxa25x_udc_irq()
1906 || driver->speed < USB_SPEED_FULL in usb_gadget_register_driver()
|
| H A D | composite.c | 339 case USB_SPEED_FULL: in set_config()
|
| H A D | fotg210.c | 340 chip->gadget.speed = USB_SPEED_FULL; in fotg210_setup()
|
| H A D | ether.c | 208 #define DEVSPEED USB_SPEED_FULL
1089 case USB_SPEED_FULL: in eth_set_config()
|
| /openbmc/qemu/hw/usb/ |
| H A D | redirect.c | 1664 dev->dev.speed = USB_SPEED_FULL; in usbredir_device_connect()
1677 dev->dev.speed = USB_SPEED_FULL; in usbredir_device_connect()
1815 usbredir_mark_speed_incompatible(dev, USB_SPEED_FULL); in usbredir_ep_info()
1822 usbredir_mark_speed_incompatible(dev, USB_SPEED_FULL); in usbredir_ep_info()
2215 dev->dev.speed = USB_SPEED_FULL; in usbredir_post_load()
2224 dev->dev.speed = USB_SPEED_FULL; in usbredir_post_load()
|
| H A D | desc.c | 483 case USB_SPEED_FULL: in usb_desc_setdefaults()
501 dev->speed = USB_SPEED_FULL; in usb_desc_init()
|
| H A D | bus.c | 538 [ USB_SPEED_FULL ] = "12", in usb_speed()
|
| H A D | core.c | 36 USB_SPEED_FULL, in usb_pick_speed()
|
| /openbmc/u-boot/include/linux/usb/ |
| H A D | ch9.h | 952 USB_SPEED_LOW, USB_SPEED_FULL, /* usb 1.1 */ enumerator
|
| /openbmc/u-boot/common/ |
| H A D | usb_hub.c | 393 speed = USB_SPEED_FULL; in usb_hub_port_connect_change()
|
| H A D | usb.c | 972 if (do_read && dev->speed == USB_SPEED_FULL) { in usb_setup_descriptor()
|
| /openbmc/u-boot/drivers/usb/dwc3/ |
| H A D | gadget.c | 1486 case USB_SPEED_FULL: in dwc3_gadget_start()
2177 dwc->gadget.speed = USB_SPEED_FULL; in dwc3_gadget_conndone_interrupt()
|