Searched refs:Responder (Results 1 – 13 of 13) sorted by relevance
6 TEST(Responder, track_untrack_one) in TEST() argument25 TEST(Responder, untrack_none) in TEST() argument36 TEST(Responder, track_one_untrack_bad) in TEST() argument60 TEST(Responder, track_untrack_two) in TEST() argument
7 title: IBM I2C Responder virtual FSI master13 The I2C Responder (I2CR) is a an I2C device that's connected to an FSI CFAM
24 the System Responder/Requestor addresses. The System Requestor26 the I/O range); the System Responder address is the address real-mode29 Typical values for the System Responder address are addresses larger
66 tristate "IBM I2C Responder virtual FSI master"70 behind an IBM I2C Responder (I2CR) chip. The I2CR is an I2C device98 tristate "IBM I2C Responder SCOM driver"101 This option enables an I2C Responder based SCOM device driver. The
8 given nonce and measurements of the SPDM Responder.58 The SPDM version used by the SPDM Responder to generate the
33 @echo "Responder daemon done"48 $(BUILDDIR)/mDNSResponderPosix: $(COMMONOBJ) $(TLSOBJS) $(OBJDIR)/Responder.c.o
238 -// It's also exported so that the Standalone Responder (mDNSResponderPosix)239 +// This is exported so that the Standalone Responder (mDNSResponderPosix)
473 configured as a Responder and the other PC is configured as an Initiator.474 Once the Initiator is started, it sends data frames to the Responder which485 connection to act as the Responder. Run the CS8900/20 Setup Utility486 and select 'Diagnostics -> Network Test -> Responder' from the main487 menu. Hit ENTER to start the Responder.495 You may stop the test on the Initiator at any time while allowing the Responder498 Responder.
24 For the Responder function:
4 ... The Cold reset command directs the Responder to perform
144 Responder : Address of the responder
166 #### Receiver/Responder
518 #### Responder subsubsection