| /openbmc/linux/Documentation/translations/zh_CN/infiniband/ |
| H A D | opa_vnic.rst | 78 0-7 L4 type (=0x78 ETHERNET)
87 16-31 L4 头
104 L4头字段包含VNIC端口所属的虚拟以太网交换机ID。在接收端，该字段用于将收
|
| /openbmc/linux/drivers/cpufreq/ |
| H A D | s5pv210-cpufreq.c | 110 L0, L1, L2, L3, L4, enumerator
129 {0, L4, 100*1000},
161 [L4] = {
268 if ((index == L4) || (priv_index == L4)) in s5pv210_target()
456 if (index != L4) { in s5pv210_target()
|
| /openbmc/linux/arch/riscv/lib/ |
| H A D | tishift.S | 37 blez a5, .L4
46 .L4: label
|
| /openbmc/linux/lib/ |
| H A D | test_dynamic_debug.c | 92 enum cat_level_names { L0 = 22, L1, L2, L3, L4, L5, L6, L7 }; enumerator
136 prdbg(L4); in do_levels()
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/omap/ |
| H A D | l4.txt | 1 L4 interconnect bindings
3 These bindings describe the OMAP SoCs L4 interconnect bus.
|
| /openbmc/linux/arch/arm/boot/dts/gemini/ |
| H A D | gemini-wbd111.dts | 51 label = "wbd111:green:L4";
57 label = "wbd111:red:L4";
|
| H A D | gemini-wbd222.dts | 50 label = "wbd111:green:L4";
56 label = "wbd111:red:L4";
|
| /openbmc/phosphor-webui/app/assets/images/ |
| H A D | icon-caret-down-disabled.svg | 1 <svg xmlns="http://www.w3.org/2000/svg" width="8" height="4" fill="#999999"><path d="M8 0L4 4 0 0z"…
|
| H A D | icon-caret-down.svg | 1 <svg xmlns="http://www.w3.org/2000/svg" width="8" height="4" fill="#2d60e5"><path d="M8 0L4 4 0 0z"…
|
| /openbmc/linux/arch/m68k/lib/ |
| H A D | udivsi3.S | 108 L4: lsrl IMM (1), d1 /* shift divisor */ label
111 jcc L4
|
| /openbmc/linux/arch/sparc/net/ |
| H A D | bpf_jit_64.h | 24 #define L4 0x14 macro
|
| /openbmc/linux/arch/xtensa/lib/ |
| H A D | memset.S | 88 bbci.l a4, 1, .L4
92 .L4: label
|
| H A D | memcopy.S | 162 bbsi.l a4, 1, .L4
171 bbsi.l a4, 1, .L4
174 .L4: label
|
| H A D | usercopy.S | 182 bbci.l a4, 1, .L4
188 .L4: label
|
| /openbmc/linux/Documentation/networking/device_drivers/ethernet/microsoft/ |
| H A D | netvsc.rst | 29 For TCP & UDP, we can switch hash level between L3 and L4 by ethtool
31 hash level is L4. We currently only allow switching TX hash level
34 On Azure, fragmented UDP packets have high loss rate with L4
|
| /openbmc/linux/Documentation/infiniband/ |
| H A D | opa_vnic.rst | 69 0-7 L4 type (=0x78 ETHERNET)
78 16-31 L4 header
97 The L4 header field contains the virtual Ethernet switch id the VNIC port
|
| /openbmc/phosphor-webui/app/assets/icons/ |
| H A D | icon-config.svg | 1 …3.55a9.36 9.36 0 0 1-2.7-1.57L6.79 24l-2.36-4 2.72-2.4a8.9 8.9 0 0 1 0-3.13L4.43 12l2.36-4 3.43 1.…
|
| /openbmc/linux/Documentation/bpf/ |
| H A D | prog_sk_lookup.rst | 84 * L4 protocol identifier (``IPPROTO_TCP`` or ``IPPROTO_UDP``),
86 * source and destination L4 port,
|
| /openbmc/qemu/hw/net/ |
| H A D | trace-events | 60 net_rx_pkt_l4_csum_validate_entry(void) "Starting L4 checksum validation"
66 net_rx_pkt_l4_csum_calc_entry(void) "Starting L4 checksum calculation"
72 …_csum(size_t l4hdr_off, uint16_t csl, uint32_t cntr, uint16_t csum) "L4 Checksum: L4 header offset…
74 net_rx_pkt_l4_csum_fix_entry(void) "Starting L4 checksum correction"
75 net_rx_pkt_l4_csum_fix_tcp(uint32_t l4_cso) "TCP packet, L4 cso: %u"
76 net_rx_pkt_l4_csum_fix_udp(uint32_t l4_cso) "UDP packet, L4 cso: %u"
80 net_rx_pkt_l4_csum_fix_csum(uint32_t cso, uint16_t csum) "L4 Checksum: Offset: %u, value 0x%X"
175 …_proto, uint32_t mrqc, bool tcpipv4_enabled, bool ipv4_enabled) "RSS IPv4: L4 header protocol %d, …
177 … ipv6ex_enabled, bool ipv6_enabled) "RSS IPv6: ex_dis: %d, new_ex_dis: %d, L4 header protocol %d, …
189 e1000e_rx_metadata_l4_csum_validation_failed(void) "Cannot validate L4 checksum"
|
| /openbmc/linux/Documentation/networking/device_drivers/ethernet/freescale/dpaa2/ |
| H A D | ethernet-driver.rst | 182 traffic based on a 5-tuple key: src IP, dst IP, IP proto, L4 src port,
183 L4 dst port. No user configuration is supported for now.
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap4460.dtsi | 86 /* Only some L4 CFG interconnect ranges are different on 4460 */
|
| /openbmc/linux/Documentation/networking/device_drivers/ethernet/aquantia/ |
| H A D | atlantic.rst | 263 3. 8 L3/L4 5-Tuple rules
281 - Locations 32 - 39 for L3/L4 5-tuple filters (locations 32, 36 for IPv6)
283 The L3/L4 5-tuple (protocol, source and destination IP address, source and
360 RX Flow L3/L4 rule may be used.
|
| /openbmc/u-boot/arch/x86/include/asm/arch-braswell/ |
| H A D | gpio.h | 35 L4, enumerator
|
| /openbmc/linux/Documentation/locking/ |
| H A D | rt-mutex-design.rst | 139 Mutexes: L1, L2, L3, L4
147 D owns L4
148 E blocked on L4
152 E->L4->D->L3->C->L2->B->L1->A
166 E->L4->D->L3->C->L2-+
185 E->L4->D->L3->C-+
|
| /openbmc/linux/drivers/pinctrl/aspeed/ |
| H A D | pinctrl-aspeed-g4.c | 1471 #define L4 177 macro
1472 SIG_EXPR_LIST_DECL_SINGLE(L4, GPIOW1, GPIOW1, SIG_DESC_SET(SCUA0, 25));
1473 SIG_EXPR_LIST_DECL_SINGLE(L4, ADC1, ADC1);
1474 PIN_DECL_(L4, SIG_EXPR_LIST_PTR(L4, GPIOW1), SIG_EXPR_LIST_PTR(L4, ADC1));
1475 FUNC_GROUP_DECL(ADC1, L4);
2055 ASPEED_PINCTRL_PIN(L4),
2494 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_PULL_DOWN, L4, L4, SCUA8, 5),
2495 ASPEED_SB_PINCONF(PIN_CONFIG_BIAS_DISABLE, L4, L4, SCUA8, 5),
|
