Home
last modified time | relevance | path

Searched refs:J22 (Results 1 – 8 of 8) sorted by relevance

/openbmc/u-boot/board/freescale/mpc8349itx/
H A DREADME21 Guide. Of particular interest to U-Boot developers is jumper J22:
34 Jumper J22.E is only for the ITX, and it decides the configuration
35 of the flash chips. If J22.E is ON (i.e. jumpered), then flash chip
37 If J22.E is OFF, then U7 is at FE000000 and U4 is at FE800000.
39 For U-Boot development, J22.E can be used to switch back-and-forth
60 On the ITX, jumper J22.E is used to determine which flash chips are
61 at which address. When J22.E is switched, addresses from FE000000
/openbmc/u-boot/doc/
H A DREADME.at9138 0xD0000000 - Dxxxxxxx Atmel Dataflash card (J22)
/openbmc/linux/arch/arm64/boot/dts/ti/
H A Dk3-am625-sk.dts132 AM62X_IOPAD(0x028, PIN_INPUT, 0) /* (J22) OSPI0_D7 */
H A Dk3-am62-phycore-som.dtsi164 AM62X_IOPAD(0x028, PIN_INPUT, 0) /* (J22) OSPI0_D7 */
H A Dk3-am625-beagleplay.dts256 AM62X_IOPAD(0x0028, PIN_INPUT, 7) /* (J22) OSPI0_D7.GPIO0_10 */
H A Dk3-am62-verdin.dtsi604 AM62X_IOPAD(0x0028, PIN_INPUT, 1) /* (J22) OSPI0_D7.SPI1_D1 */ /* SODIMM 198 */
/openbmc/linux/drivers/pinctrl/aspeed/
H A Dpinctrl-aspeed-g6.c179 #define J22 17 macro
180 SIG_EXPR_LIST_DECL_SESG(J22, RGMII3TXCTL, RGMII3, SIG_DESC_SET(SCU410, 17),
182 SIG_EXPR_LIST_DECL_SESG(J22, RMII3TXEN, RMII3, SIG_DESC_SET(SCU410, 17),
184 PIN_DECL_2(J22, GPIOC1, RGMII3TXCTL, RMII3TXEN);
250 FUNC_GROUP_DECL(RGMII3, H24, J22, H22, H23, G22, F22, G23, G24, F23, F26, F25,
252 FUNC_GROUP_DECL(RMII3, H24, J22, H22, H23, G23, F23, F26, F25, E26);
1844 ASPEED_PINCTRL_PIN(J22),
/openbmc/linux/arch/arm64/boot/dts/freescale/
H A Dimx8mp-evk.dts486 /* I2C on expansion connector J22. */