Home
last modified time | relevance | path

Searched refs:DDC (Results 1 – 25 of 79) sorted by relevance

1234

/openbmc/qemu/hw/display/
H A DKconfig1 config DDC config
31 select DDC
78 select DDC
132 select DDC
/openbmc/linux/Documentation/devicetree/bindings/display/mediatek/
H A Dmediatek,hdmi-ddc.yaml7 title: Mediatek HDMI DDC
14 The HDMI DDC i2c controller is used to interface with the HDMI DDC pins.
/openbmc/linux/Documentation/devicetree/bindings/gnss/
H A Du-blox,neo-6m.yaml16 The U-blox GNSS receivers can use UART, DDC (I2C), SPI and USB interfaces.
27 The DDC Slave Address, SPI chip select address, the number of the USB hub
29 depending on the bus used. Required for the DDC, SPI or USB busses.
/openbmc/linux/Documentation/devicetree/bindings/display/connector/
H A Dhdmi-connector.yaml32 description: phandle link to the I2C controller used for DDC EDID probing
36 description: GPIO signal to enable DDC bus
H A Dvga-connector.yaml19 description: phandle link to the I2C controller used for DDC EDID probing
H A Ddvi-connector.yaml23 description: phandle link to the I2C controller used for DDC EDID probing
/openbmc/linux/Documentation/devicetree/bindings/display/
H A Dallwinner,sun4i-a10-hdmi.yaml44 - description: The HDMI DDC clock
68 - description: DDC Transmission DMA Channel
69 - description: DDC Reception DMA Channel
H A Ddp-aux-bus.yaml16 particular, DP sinks support DDC over DP AUX which allows tunneling
17 a standard I2C DDC connection over the AUX channel.
H A Dbrcm,bcm2835-hdmi.yaml37 Phandle of the I2C controller used for DDC EDID probing
/openbmc/linux/Documentation/devicetree/bindings/display/rockchip/
H A Drockchip,dw-hdmi.yaml75 The HDMI DDC bus can be connected to either a system I2C master or the
89 The unwedge pinctrl entry shall drive the DDC SDA line low. This is
90 intended to work around a hardware errata that can cause the DDC I2C
/openbmc/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6q-prti6q.dts245 /* DDC */
466 /* NOTE: DDC is done via I2C2, so DON'T
467 * configure DDC pins for HDMI!
473 /* DDC */
H A Dimx6dl-alti6p.dts275 /* DDC */
460 /* NOTE: DDC is done via I2C2, so DON'T configure DDC
H A Dimx53-kp-ddc.dts11 model = "K+P imx53 DDC";
H A Dimx6qdl-mba6.dtsi215 /* DDC */
434 /* NOTE: DDC is done via I2C2, so DON'T
435 * configure DDC pins for HDMI!
/openbmc/linux/Documentation/devicetree/bindings/display/samsung/
H A Dsamsung,exynos-hdmi-ddc.yaml7 title: Samsung Exynos SoC HDMI DDC
H A Dsamsung,exynos-hdmi.yaml34 Phandle to the HDMI DDC node.
39 there is no power provided for DDC epprom, some TV-sets do not pulls up
/openbmc/linux/arch/arm64/boot/dts/freescale/
H A Dimx8qm-apalis.dtsi30 /* Apalis I2C2 (DDC) */
308 /* Apalis I2C2 (DDC) */
/openbmc/openbmc/meta-nuvoton/recipes-nuvoton/program-edid/
H A Dprogram-edid.bb2 DESCRIPTION = "Add program EDID data support for DDC to SMB internal \
/openbmc/u-boot/arch/arm/dts/
H A Dtegra30-tamonten.dtsi44 /* DDC */
H A Dmeson-gxbb-odroidc2.dts208 "HDMI HPD", "HDMI DDC SDA", "HDMI DDC SCL", "",
/openbmc/linux/arch/arm/boot/dts/nvidia/
H A Dtegra124-apalis-v1.2-eval.dts112 * I2C4 (DDC): I2C4_SDA/SCL (DDC) on MXM3 pin 205/207
H A Dtegra124-apalis-eval.dts100 * GEN2_I2C: I2C2_SDA/SCL (DDC) on MXM3 pin 205/207 (e.g. display EDID)
115 /* I2C4 (DDC): unused */
/openbmc/linux/arch/arm/boot/dts/marvell/
H A Ddove-sbc-a510.dts118 * - HDMI/DVI DDC channel
121 * - VGA DDC channel
/openbmc/u-boot/doc/device-tree-bindings/gpu/
H A Dnvidia,tegra20-host1x.txt128 - nvidia,ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
154 - nvidia,ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
190 - nvidia,ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
214 - nvidia,ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
/openbmc/linux/Documentation/fb/
H A Dintel810.rst54 - Supports EDID probing either by DDC/I2C or through the BIOS
250 e. If you want support for DDC/I2C probing (Plug and Play Displays),
251 set 'Enable DDC Support' to 'y'. To make this option appear, set

1234