Searched refs:ALE (Results 1 – 19 of 19) sorted by relevance
| /openbmc/qemu/hw/block/ |
| H A D | tc58128.c | 38 #define ALE 0x1000 macro
184 } else if (porta & ALE) { in tc58128_cb()
|
| /openbmc/linux/Documentation/devicetree/bindings/mtd/ |
| H A D | gpio-control-nand.txt | 15 GPIO references is: RDY, nCE, ALE, CLE, and nWP. nCE and nWP are optional.
40 <&banka 3 0>, /* ALE */
|
| H A D | orion-nand.txt | 10 - ale : Address line number connected to ALE. Default is 1
|
| H A D | fsmc-nand.txt | 18 byte 1 TAR : ALE to RE delay, 4 bits are valid. Same format as TCLR.
|
| H A D | davinci-nand.txt | 27 - ti,davinci-mask-ale: mask for ALE. Needed for executing address
|
| /openbmc/linux/arch/arm/boot/compressed/ |
| H A D | head-sharpsl.S | 137 orr r3, r3, #4 @ SET ALE
141 bic r3, r3, #4 @ CLR ALE
|
| /openbmc/linux/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | mvebu-devbus.txt | 53 ALE[0] to the cycle that the first read data is sampled
85 - devbus,ale-wr-ps: Defines the time delay from the ALE[0] negation cycle
|
| /openbmc/linux/Documentation/devicetree/bindings/mips/cavium/ |
| H A D | bootbus.txt | 62 - cavium,ale-mode: Optional. If present, ALE mode is selected.
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | cpsw.txt | 15 - ale_entries : Specifies No of entries ALE can hold
|
| H A D | ti,k3-am654-cpsw-nuss.yaml | 25 updated Address Lookup Engine (ALE).
|
| /openbmc/linux/arch/arm/boot/dts/microchip/ |
| H A D | at91-tse850-3.dts | 359 /* 20 */ "", "ALE", "CLE", "",
|
| H A D | sama5d4.dtsi | 1278 AT91_PIOC 17 AT91_PERIPH_A AT91_PINCTRL_PULL_UP /* PC17 ALE */
|
| /openbmc/linux/arch/powerpc/boot/dts/ |
| H A D | xpedite5200.dts | 432 ale-line = <0x10>; /* ALE tied to A4 */
|
| H A D | xpedite5200_xmon.dts | 436 ale-line = <0x10>; /* ALE tied to A4 */
|
| /openbmc/linux/Documentation/driver-api/ |
| H A D | mtdnand.rst | 166 case NAND_CTL_SETALE: /* Set ALE pin high */ break;
167 case NAND_CTL_CLRALE: /* Set ALE pin low */ break;
912 /* Select the address latch by setting ALE to high */
914 /* Deselect the address latch by setting ALE to low */
|
| /openbmc/linux/Documentation/driver-api/gpio/ |
| H A D | drivers-on-gpio.rst | 79 to a set of simple GPIO lines: RDY, NCE, ALE, CLE, NWP. It interacts with the
|
| /openbmc/linux/arch/mips/boot/dts/ingenic/ |
| H A D | ci20.dts | 427 * Only CLE/ALE are needed for the devices that are connected, rather
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | sama5d4.dtsi | 1737 AT91_PIOC 17 AT91_PERIPH_A AT91_PINCTRL_PULL_UP /* PC17 ALE */
|
| /openbmc/linux/Documentation/networking/ |
| H A D | arcnet-hardware.rst | 463 and another with ALE,LA17,LA18,LA19 these are undocumented..
|