xref: /openbmc/linux/arch/arm64/boot/dts/qcom/pmr735d.dtsi (revision 4e7b1126)
1// SPDX-License-Identifier: BSD-3-Clause
2/*
3 * Copyright (c) 2022, Linaro Limited
4 */
5
6#include <dt-bindings/interrupt-controller/irq.h>
7#include <dt-bindings/spmi/spmi.h>
8
9/ {
10	thermal-zones {
11		pmr735d-k-thermal {
12			polling-delay-passive = <100>;
13			polling-delay = <0>;
14
15			thermal-sensors = <&pmr735d_k_temp_alarm>;
16
17			trips {
18				trip0 {
19					temperature = <95000>;
20					hysteresis = <0>;
21					type = "passive";
22				};
23
24				trip1 {
25					temperature = <115000>;
26					hysteresis = <0>;
27					type = "hot";
28				};
29			};
30		};
31
32		pmr735d-l-thermal {
33			polling-delay-passive = <100>;
34			polling-delay = <0>;
35
36			thermal-sensors = <&pmr735d_l_temp_alarm>;
37
38			trips {
39				trip0 {
40					temperature = <95000>;
41					hysteresis = <0>;
42					type = "passive";
43				};
44
45				trip1 {
46					temperature = <115000>;
47					hysteresis = <0>;
48					type = "hot";
49				};
50			};
51		};
52	};
53};
54
55
56&spmi_bus {
57	pmr735d_k: pmic@a {
58		compatible = "qcom,pmr735d", "qcom,spmi-pmic";
59		reg = <0xa SPMI_USID>;
60		#address-cells = <1>;
61		#size-cells = <0>;
62
63		pmr735d_k_temp_alarm: temp-alarm@a00 {
64			compatible = "qcom,spmi-temp-alarm";
65			reg = <0xa00>;
66			interrupts = <0xa 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
67			#thermal-sensor-cells = <0>;
68		};
69
70		pmr735d_k_gpios: gpio@8800 {
71			compatible = "qcom,pmr735d-gpio", "qcom,spmi-gpio";
72			reg = <0x8800>;
73			gpio-controller;
74			gpio-ranges = <&pmr735d_k_gpios 0 0 2>;
75			#gpio-cells = <2>;
76			interrupt-controller;
77			#interrupt-cells = <2>;
78		};
79	};
80
81	pmr735d_l: pmic@b {
82		compatible = "qcom,pmr735d", "qcom,spmi-pmic";
83		reg = <0xb SPMI_USID>;
84		#address-cells = <1>;
85		#size-cells = <0>;
86
87		pmr735d_l_temp_alarm: temp-alarm@a00 {
88			compatible = "qcom,spmi-temp-alarm";
89			reg = <0xa00>;
90			interrupts = <0xb 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
91			#thermal-sensor-cells = <0>;
92		};
93
94		pmr735d_l_gpios: gpio@8800 {
95			compatible = "qcom,pmr735d-gpio", "qcom,spmi-gpio";
96			reg = <0x8800>;
97			gpio-controller;
98			gpio-ranges = <&pmr735d_l_gpios 0 0 2>;
99			#gpio-cells = <2>;
100			interrupt-controller;
101			#interrupt-cells = <2>;
102		};
103	};
104};
105