xref: /openbmc/linux/drivers/phy/st/Kconfig (revision 7bc057dd)
1# SPDX-License-Identifier: GPL-2.0-only
2#
3# Phy drivers for STMicro platforms
4#
5config PHY_MIPHY28LP
6	tristate "STMicroelectronics MIPHY28LP PHY driver for STiH407"
7	depends on ARCH_STI
8	select GENERIC_PHY
9	help
10	  Enable this to support the miphy transceiver (for SATA/PCIE/USB3)
11	  that is part of STMicroelectronics STiH407 SoC.
12
13config PHY_ST_SPEAR1310_MIPHY
14	tristate "ST SPEAR1310-MIPHY driver"
15	select GENERIC_PHY
16	depends on MACH_SPEAR1310 || COMPILE_TEST
17	help
18	  Support for ST SPEAr1310 MIPHY which can be used for PCIe and SATA.
19
20config PHY_ST_SPEAR1340_MIPHY
21	tristate "ST SPEAR1340-MIPHY driver"
22	select GENERIC_PHY
23	depends on MACH_SPEAR1340 || COMPILE_TEST
24	help
25	  Support for ST SPEAr1340 MIPHY which can be used for PCIe and SATA.
26
27config PHY_STIH407_USB
28	tristate "STMicroelectronics USB2 picoPHY driver for STiH407 family"
29	depends on RESET_CONTROLLER
30	depends on ARCH_STI || COMPILE_TEST
31	select GENERIC_PHY
32	help
33	  Enable this support to enable the picoPHY device used by USB2
34	  and USB3 controllers on STMicroelectronics STiH407 SoC families.
35
36config PHY_STM32_USBPHYC
37	tristate "STMicroelectronics STM32 USB HS PHY Controller driver"
38	depends on ARCH_STM32 || COMPILE_TEST
39	depends on COMMON_CLK
40	select GENERIC_PHY
41	help
42	  Enable this to support the High-Speed USB transceivers that are part
43	  of some STMicroelectronics STM32 SoCs.
44
45	  This driver controls the entire USB PHY block: the USB PHY controller
46	  (USBPHYC) and the two 8-bit wide UTMI+ interfaces. First interface is
47	  used by an HS USB Host controller, and the second one is shared
48	  between an HS USB OTG controller and an HS USB Host controller,
49	  selected by a USB switch.
50