| /openbmc/linux/Documentation/RCU/Design/Expedited-Grace-Periods/ |
| H A D | Expedited-Grace-Periods.rst | 434 Expediting grace periods does nothing to speed things up when RCU
|
| /openbmc/linux/drivers/net/ethernet/tehuti/ |
| H A D | tehuti.c | 2118 ecmd->base.speed = SPEED_10000; in bdx_get_link_ksettings()
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6sx.dtsi | 1128 cpu_speed_grade: speed-grade@10 {
|
| /openbmc/linux/Documentation/driver-api/media/drivers/ |
| H A D | cx2341x-devel.rst | 2287 Playback stream at speed other than normal. There are two modes of
2293 desired speed.
|
| /openbmc/linux/drivers/tty/ |
| H A D | synclink_gt.c | 4863 u32 speed = info->params.data_rate; in irq_test() local
4893 info->params.data_rate = speed; in irq_test()
|
| /openbmc/linux/Documentation/block/ |
| H A D | bfq-iosched.rst | 109 Higher speed for code-development tasks
|
| /openbmc/linux/drivers/net/usb/ |
| H A D | smsc75xx.c | 1162 } else if (dev->udev->speed == USB_SPEED_HIGH) { in smsc75xx_reset()
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-fs-f2fs | 229 speed up. Default is 0.
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | dev-encoder.rst | 258 that can be played back at that speed. The frame interval for the
|
| /openbmc/linux/drivers/usb/gadget/function/ |
| H A D | f_tcm.c | 852 if (gadget->speed >= USB_SPEED_SUPER) in uasp_set_alt()
|
| /openbmc/linux/Documentation/process/ |
| H A D | 2.Process.rst | 465 kernel developers. It is possible to bring in-house developers up to speed
|
| /openbmc/linux/Documentation/spi/ |
| H A D | spi-summary.rst | 85 low speed "bitbanging" adapter. Very few systems will "hotplug" an SPI
|
| /openbmc/linux/drivers/net/ethernet/cavium/liquidio/ |
| H A D | lio_vf_main.c | 271 linfo->link.s.speed, in print_link_info()
|
| /openbmc/linux/Documentation/admin-guide/ |
| H A D | kernel-parameters.txt | 1044 [HW] Factor to multiply fan speed with.
1047 [HW] Maximum configurable fan speed.
1857 i2c_bus= [HW] Override the default board specific I2C bus speed
2840 * SATA link speed limit: 1.5Gbps or 3.0Gbps.
2894 * [no]setxfer: Indicate if transfer speed mode setting
4164 Set to non-zero if a chip is present that snoops speed
6835 high speed and super speed interrupt
7014 May slow down system boot speed, especially when
|
| /openbmc/linux/drivers/scsi/megaraid/ |
| H A D | megaraid_sas_base.c | 6024 u16 lnksta, speed; in megasas_init_fw() local
6244 speed = lnksta & PCI_EXP_LNKSTA_CLS; in megasas_init_fw()
6250 if (speed < 0x4) { in megasas_init_fw()
|
| /openbmc/linux/drivers/scsi/mpt3sas/ |
| H A D | mpt3sas_base.c | 3306 u16 lnksta, speed; in _base_check_and_enable_high_iops_queues() local
3321 speed = lnksta & PCI_EXP_LNKSTA_CLS; in _base_check_and_enable_high_iops_queues()
3323 if (speed < 0x4) { in _base_check_and_enable_high_iops_queues()
|
| /openbmc/linux/drivers/scsi/aic7xxx/ |
| H A D | aic79xx.reg | 3395 * Error detection mode, speed configuration,
4229 * to 0x7f for speed lower than U320 which will
|
| H A D | aic7xxx.reg | 605 * Error detection mode and speed configuration
|
| /openbmc/linux/drivers/net/ethernet/mellanox/mlxsw/ |
| H A D | spectrum.c | 1386 int mlxsw_sp_port_speed_get(struct mlxsw_sp_port *mlxsw_sp_port, u32 *speed) in mlxsw_sp_port_speed_get() argument
1403 *speed = port_type_speed_ops->from_ptys_speed(mlxsw_sp, eth_proto_oper); in mlxsw_sp_port_speed_get()
|
| /openbmc/linux/drivers/infiniband/hw/qedr/ |
| H A D | verbs.c | 169 static inline void get_link_speed_and_width(int speed, u16 *ib_speed, in get_link_speed_and_width() argument
172 switch (speed) { in get_link_speed_and_width()
|
| /openbmc/linux/tools/power/cpupower/po/ |
| H A D | de.po | 359 "The governor \"%s\" may decide which speed to use\n"
|
| /openbmc/ipmitool/ |
| H A D | ChangeLog | 237 * Added 'sdr fill sensors nosats' support to speed up SDR discovery
|
| /openbmc/linux/drivers/net/ethernet/sfc/falcon/ |
| H A D | efx.c | 919 link_state->speed, link_state->fd ? "full" : "half", in ef4_link_status_changed()
|
| /openbmc/linux/drivers/net/ethernet/chelsio/inline_crypto/chtls/ |
| H A D | chtls_cm.c | 1096 linkspeed = pi->link_cfg.speed; in chtls_set_tcp_window()
|
| /openbmc/linux/Documentation/trace/ |
| H A D | kprobes.rst | 50 can speed up unregistration process when you have to unregister
|