| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6qdl-ds.dtsi | 238 link-frequencies = /bits/ 64 <70000000>;
|
| H A D | imx6dl-b1x5pv2.dtsi | 17 /* Do not allow frequencies above 800MHz */
|
| H A D | imx7s-warp.dts | 213 link-frequencies = /bits/ 64 <330000000>;
|
| /openbmc/linux/arch/arm64/boot/dts/marvell/ |
| H A D | cn9130-db.dtsi | 318 /* On-board MUX does not allow higher frequencies */
|
| /openbmc/phosphor-dbus-interfaces/yaml/xyz/openbmc_project/Led/ |
| H A D | README.md | 16 to **Blink** set of LEDs in different frequencies. Few more systems may have a
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-g-tuner.rst | 221 - When set, tuning frequencies are expressed in units of 62.5 Hz
295 - When set, tuning frequencies are expressed in units of 1 Hz
|
| /openbmc/linux/Documentation/driver-api/ |
| H A D | regulator.rst | 102 frequencies but does not require that the supply voltage be lowered). Where
|
| /openbmc/linux/Documentation/power/ |
| H A D | opp.rst | 130 High level framework such as cpufreq operates on frequencies. To map the
302 frequencies in a table, the main processor can notify as following::
|
| /openbmc/linux/arch/arm/boot/dts/ti/davinci/ |
| H A D | da850-evm.dts | 197 * point by default. Higher frequencies must be enabled for custom boards with
|
| /openbmc/linux/Documentation/admin-guide/pm/ |
| H A D | cpufreq.rst | 141 frequencies supported by the hardware, the table of available frequencies (if
230 CPU frequencies, that limit will be reported through this attribute (if
460 It generally selects CPU frequencies proportional to the estimated load, so that
548 from running at higher CPU frequencies.
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | am437x-gp-evm.dts | 491 link-frequencies = /bits/ 64 <70000000>;
525 link-frequencies = /bits/ 64 <70000000>;
|
| /openbmc/linux/drivers/net/wireless/ath/ath9k/ |
| H A D | Kconfig | 93 transmitters operating at frequencies from 300 kHz to 100 GHz.
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | qoriq-clock.txt | 5 multiple phase locked loops (PLL) to create a variety of frequencies
|
| /openbmc/linux/Documentation/scheduler/ |
| H A D | sched-capacity.rst | 142 On an SMP system with fixed frequencies, 100% utilization suggests the task is a
144 spends more time sleeping than executing. Variable CPU frequencies and
|
| /openbmc/linux/drivers/clk/qcom/ |
| H A D | Kconfig | 27 the CPU with frequencies above 1GHz.
28 Say Y if you want to support higher CPU frequencies on MSM8916
35 frequencies above 1GHz.
36 Say Y if you want to support higher CPU frequencies on SDX55 and SDX65
|
| /openbmc/openbmc/meta-openembedded/meta-multimedia/recipes-multimedia/dvb-apps/files/dvb-scan-table/atsc/ |
| H A D | us-Cable-IRC-center-frequencies-QAM256 | 1 # US Cable center frequencies
|
| H A D | us-Cable-HRC-center-frequencies-QAM256 | 1 # US Cable center frequencies
|
| H A D | us-Cable-EIA-542-IRC-center_frequencies-QAM256 | 1 # US Cable EIA-542 center frequencies
|
| H A D | us-Cable-EIA-542-HRC-center-frequencies-QAM256 | 1 # US EIA-542 Cable center frequencies
|
| H A D | us-Cable-Standard-center-frequencies-QAM256 | 1 # US EIA/NCTA Standard Cable center frequencies
|
| /openbmc/openbmc/meta-openembedded/meta-multimedia/recipes-multimedia/dvb-apps/files/dvb-scan-table/dvb-t/ |
| H A D | it-All | 1 # This file lists all frequencies used in Western Europe for DVB-T.
|
| /openbmc/linux/arch/arm/boot/dts/ti/keystone/ |
| H A D | keystone-clocks.dtsi | 414 * for which real frequencies have to be defined in board files.
|
| /openbmc/linux/drivers/net/can/ |
| H A D | Kconfig | 77 source clock frequencies. Disabling saves some space, but then the
|
| /openbmc/linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3399-kobol-helios64.dts | 237 * frequencies until this problem is properly understood and resolved.
|
| /openbmc/linux/Documentation/devicetree/bindings/opp/ |
| H A D | opp-v2-base.yaml | 54 array of frequencies. The OPP binding doesn't provide any provisions
|