Searched refs:board (Results 2951 – 2975 of 3830) sorted by relevance
1...<<111112113114115116117118119120>>...154
/openbmc/u-boot/arch/arm/cpu/armv8/fsl-layerscape/doc/ |
H A D | README.lsch3 | 189 With these two images in NAND device, the board can boot from NAND. 202 to match board NAND device with 4KB/page, block size 512KB. 248 With these two images in SD/eMMC device, the board can boot from SD/eMMC.
|
/openbmc/linux/Documentation/devicetree/bindings/phy/ |
H A D | nvidia,tegra186-xusb-padctl.yaml | 28 settings on a per-board basis. 90 If set to "disabled", the pad will not be used on the given board. In 227 If set to "disabled", the port will not be used on the given board. In
|
/openbmc/linux/Documentation/devicetree/bindings/ |
H A D | trivial-devices.yaml | 100 # DH electronics GmbH on-board CPLD trivial SPI device 101 - dh,dhcom-board 250 # Menlo on-board CPLD trivial SPI device
|
/openbmc/u-boot/doc/ |
H A D | README.armada-secureboot | 201 The Kirkwook architecture in U-Boot employs a special board-specific 236 reading configuration values from Kconfig options or from the board config 238 mechanisms (see board/gdsys/a38x/Makefile as an example for this approach). 279 | board won't boot anymore, and recovery is likely |
|
/openbmc/linux/drivers/input/keyboard/ |
H A D | Kconfig | 24 board-specific setup logic must also provide a configuration data 242 directly to such GPIO pins. Your board-specific 257 directly to such GPIO pins. Your board-specific 272 TCA6416/TCA6408A IO expander. Your board-specific setup logic 718 LED control for the Exynos5433 TM2 board. 728 Say Y here if your board use the keypad controller on
|
/openbmc/linux/arch/powerpc/boot/dts/ |
H A D | ep88xc.dts | 59 board-control@3,400000 {
|
/openbmc/linux/Documentation/hwmon/ |
H A D | w83795.rst | 31 This can be useful to convert data provided by board manufacturers
|
/openbmc/linux/arch/arm64/boot/dts/bitmain/ |
H A D | bm1880-sophon-edge.dts | 14 * anything the board)
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | stm32f469-disco.dts | 48 model = "STMicroelectronics STM32F469i-DISCO board";
|
H A D | armada-3720-espressobin.dts | 2 * Device Tree file for Marvell Armada 3720 community board
|
H A D | rk3288-veyron-jerry.dts | 3 * Google Veyron Jerry Rev 3+ board device tree source
|
H A D | sun8i-a23-evb.dts | 124 * need to solder R207 on the back of the board in order to close the
|
H A D | sun7i-a20-itead-ibox.dts | 71 simple-audio-card,name = "On-board SPDIF";
|
/openbmc/u-boot/board/theobroma-systems/puma_rk3399/ |
H A D | README | 80 rkdeveloptool allows to flash the on-board eMMC via the USB OTG interface with
|
/openbmc/u-boot/board/amlogic/q200/ |
H A D | README.khadas-vim2 | 44 the git tree published by the board vendor:
|
/openbmc/u-boot/board/seco/mx6quq7/ |
H A D | mx6quq7-2g.cfg | 16 * spi, sd (the board has no nand neither onenand)
|
/openbmc/u-boot/board/amlogic/p212/ |
H A D | README.khadas-vim | 43 the git tree published by the board vendor:
|
/openbmc/qemu/docs/system/arm/ |
H A D | nuvoton.rst | 16 - ``npcm750-evb`` Nuvoton NPCM750 Evaluation board
|
H A D | vexpress.rst | 5 board family:
|
/openbmc/linux/drivers/net/ethernet/freescale/ |
H A D | Kconfig | 57 If your board uses an external PHY connected to FEC, enable this.
|
/openbmc/linux/arch/arm/boot/dts/allwinner/ |
H A D | sun7i-a20-itead-ibox.dts | 71 simple-audio-card,name = "On-board SPDIF";
|
/openbmc/linux/Documentation/devicetree/bindings/regulator/ |
H A D | ti,tps65219.yaml | 51 where the board has a button wired to the pin and triggers
|
/openbmc/linux/arch/arm64/boot/dts/qcom/ |
H A D | sdm450-motorola-ali.dts | 18 qcom,board-id = <0x43 0xc200>;
|
/openbmc/linux/Documentation/devicetree/bindings/sound/ |
H A D | ti,j721e-cpb-audio.yaml | 15 The audio support on the board is using pcm3168a codec connected to McASP10
|
/openbmc/linux/Documentation/devicetree/bindings/net/ |
H A D | ti,k3-am654-cpts.yaml | 102 PPS events generation. Platform/board specific.
|
1...<<111112113114115116117118119120>>...154