| /openbmc/linux/Documentation/devicetree/bindings/pwm/ |
| H A D | vt8500-pwm.txt | 1 VIA/Wondermedia VT8500/WM8xxx series SoC PWM controller
9 - clocks: phandle to the PWM source clock
|
| H A D | brcm,bcm7038-pwm.yaml | 7 title: Broadcom BCM7038 PWM controller (BCM7xxx Set Top Box PWM controller)
|
| H A D | iqs620a-pwm.yaml | 7 title: Azoteq IQS620A PWM Generator
13 The Azoteq IQS620A multi-function sensor generates a fixed-frequency PWM
|
| H A D | nxp,pca9685-pwm.txt | 1 NXP PCA9685 16-channel 12-bit PWM LED controller
8 The index 16 is the ALLCALL channel, that sets all PWM channels at the same
|
| H A D | kontron,sl28cpld-pwm.yaml | 7 title: PWM driver for the sl28cpld board management controller
16 The controller supports one PWM channel and supports only four distinct
|
| H A D | mxs-pwm.yaml | 7 title: Freescale MXS PWM controller
29 description: u32 value representing the number of PWM devices
|
| H A D | pwm-omap-dmtimer.txt | 1 * OMAP PWM for dual-mode timers
5 - ti,timers: phandle to PWM capable OMAP timer. See timer/ti,timer-dm.yaml for info
|
| H A D | clk-pwm.yaml | 7 title: Clock based PWM controller
16 suitable for generating PWM signal.
|
| /openbmc/u-boot/doc/device-tree-bindings/pwm/ |
| H A D | tegra20-pwm.txt | 8 - #pwm-cells: On Tegra the number of cells used to specify a PWM is 2. The
9 first cell specifies the per-chip index of the PWM to use and the second
|
| /openbmc/linux/Documentation/devicetree/bindings/leds/irled/ |
| H A D | pwm-ir-tx.yaml | 7 title: IR LED connected through PWM pin
13 IR LED connected through PWM pin which is used as remote controller
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | gxp-fan-ctrl.rst | 18 PWM control.
25 pwm[0-7] Fan 0 to 7 respective PWM value (0-255)
|
| H A D | g762.rst | 4 The GMT G762 Fan Speed PWM Controller is connected directly to a fan
6 modes - PWM or DC - are supported by the device.
55 set or get fan driving mode: 1 for PWM mode, 0 for DC mode.
58 get or set PWM fan control value in open-loop mode. This is an
62 Both in PWM mode ('pwm1_mode' set to 1) and DC mode ('pwm1_mode' set to 0),
|
| H A D | nzxt-smart2.rst | 15 Besides typical speed monitoring and PWM duty cycle control, voltage and current
49 pwm[1-3] Controls fan speed: PWM duty cycle for PWM-controlled
58 pwm[1-3]_mode Read-only, 1 for PWM-controlled fans, 0 for other fans
|
| H A D | vt1211.rst | 60 connected to the PWM outputs of the VT1211 :-().
175 The VT1211 provides 2 programmable PWM outputs to control the speeds of 2
177 PWM controller in automatic mode. There is only a single controller that
178 controls both PWM outputs but each PWM output can be individually enabled and
181 Each PWM has 4 associated distinct output duty-cycles: full, high, low and
184 pwm[1-2]_auto_point[2-3]_pwm. Each PWM output can be associated with a
194 PWM Auto Point PWM Output Duty-Cycle
212 PWM output duty-cycle based on the input temperature:
|
| H A D | max31785.rst | 21 features are provided, including PWM frequency control, temperature hysteresis,
57 1: Manual PWM control
58 2: Automatic PWM (tach-feedback RPM fan-control)
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6ull-colibri-aster.dts | 50 /* PWM <B> */
56 /* PWM <C> */
|
| H A D | imx6ull-colibri-wifi-aster.dts | 50 /* PWM <B> */
56 /* PWM <C> */
|
| /openbmc/linux/Documentation/devicetree/bindings/hwmon/ |
| H A D | pwm-fan.yaml | 7 title: Fan connected to PWM lines
18 description: PWM duty cycle values corresponding to thermal cooling states.
44 description: The PWM that is used to control the fan.
|
| /openbmc/linux/Documentation/devicetree/bindings/mfd/ |
| H A D | st,stm32-timers.yaml | 10 This hardware block provides 3 types of timer along with PWM functionality:
12 by a programmable prescaler, break input feature, PWM outputs and
13 complementary PWM outputs channels.
15 driven by a programmable prescaler and PWM outputs.
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | pwm-clock.yaml | 7 title: An external clock signal driven by a PWM pin.
20 description: Exact output frequency, in case the PWM period is not exact
|
| /openbmc/phosphor-pid-control/ |
| H A D | meson.options | 3 …oolean', value: false, description: 'Set the fans strictly at the failsafe PWM when in failsafe mo…
4 … type: 'boolean', value: false, description: 'Set the fans at the failsafe PWM when reloading or t…
|
| /openbmc/linux/Documentation/devicetree/bindings/timer/ |
| H A D | loongson,ls1x-pwmtimer.yaml | 7 title: Loongson-1 PWM timer
13 Loongson-1 PWM timer can be used for system clock source
|
| /openbmc/linux/Documentation/leds/ |
| H A D | leds-qcom-lpg.rst | 11 number of PWM channels, a programmable pattern lookup table and a RGB LED
15 individual LEDs, grouped together as RGB LEDs or otherwise be accessed as PWM
16 channels. The output of each PWM channel is routed to other hardware
19 The each PWM channel can operate with a period between 27us and 384 seconds and
|
| /openbmc/linux/Documentation/userspace-api/media/rc/ |
| H A D | lirc-set-rec-carrier.rst | 29 Frequency of the carrier that modulates PWM data, in Hz.
34 Set receive carrier used to modulate IR PWM pulses and spaces.
|
| /openbmc/linux/arch/arm64/boot/dts/allwinner/ |
| H A D | sun50i-a64-pinephone-1.1.dts | 16 * PWM backlight circuit on this PinePhone revision was changed since
17 * 1.0, and the lowest PWM duty cycle that doesn't lead to backlight
|