| /openbmc/linux/Documentation/devicetree/bindings/media/ |
| H A D | si4713.txt | 4 supporting 76-108 MHz. It includes an RDS encoder and has both, a stereo-analog
6 DSP-mode format. It is programmable through an I2C interface.
|
| /openbmc/openbmc/poky/meta/conf/machine/include/x86/ |
| H A D | tune-i686.inc | 3 # It has as required feature flags: fpu tsc cx8 cmov.
5 # It is the minimum CPU required by the Debian i386 port.
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-dfl-devices-emif | 5 Description: Read-only. It indicates if the calibration failed on this
13 Description: Read-only. It indicates if the initialization completed on
|
| /openbmc/openbmc/poky/meta/recipes-support/libjitterentropy/ |
| H A D | libjitterentropy_3.4.1.bb | 3 It does not depend on any system resource other than a high-resolution time \
4 stamp. It is a small-scale, yet fast entropy source that is viable in almost \
|
| /openbmc/linux/Documentation/ABI/stable/ |
| H A D | sysfs-driver-dma-idxd | 53 It's not visible when the device does not support Read Buffer
128 It's not visible when the device does not support Read Buffer
152 occupies 4k size if the evl entry is 64 bytes. It's visible
229 It's not visible when the device does not support batch.
245 if set. It's visible only on platforms that support the
270 correlates to the operations allowed. It's visible only
285 It's not visible when the device does not support Read Buffer
295 It's not visible when the device does not support Read Buffer
305 It's not visible when the device does not support Read Buffer
317 the max value). It's visible only on platforms that support
[all …]
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | rw.rst | 18 efficient than other methods merely exchanging buffer pointers. It is
23 setup to exchange data. It permits command line stunts like this (the
39 It would be desirable if applications could depend on drivers
|
| H A D | metafmt-vivid.rst | 17 It sets Brightness, Saturation, Contrast and Hue, each of which maps to
20 It contains the following fields:
|
| /openbmc/linux/Documentation/devicetree/bindings/serial/ |
| H A D | rs485.yaml | 23 milliseconds. It corresponds to the delay before sending data.
27 It corresponds to the delay after sending data and actual release
46 description: enables the rs485 feature at boot time. It can be disabled
|
| /openbmc/linux/drivers/leds/ |
| H A D | TODO | 6 It is really an integer, as maximum is configurable. Get rid of it, or
38 Multicolor is not a good fit for RGB LED. It does not really know
51 white and to turn it into any arbitrary color. It is essential that
67 It would be also nice to have useful listing mode -- name, type,
|
| /openbmc/linux/Documentation/devicetree/bindings/ata/ |
| H A D | ahci-common.yaml | 15 controller implementation. It's hardware interface is supposed to
65 Spin-up or Mechanical Presence Switch support. It can be used to
79 It is optionally possible to describe the ports as sub-nodes so
117 for details). It can be used to initialize the HWinit fields of
|
| /openbmc/linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| H A D | firmware.txt | 14 firmware binary. It is a 64-bit number represented
17 It is an array of 8 32-bit numbers.
|
| /openbmc/u-boot/board/freescale/common/ |
| H A D | Kconfig | 30 functionality. It is used by common VID driver.
38 functionality. It is used by common VID driver.
|
| /openbmc/openbmc/meta-openembedded/meta-perl/recipes-perl/libxml/ |
| H A D | libxml-sax-writer-perl_0.57.bb | 4 strings, files, and other flat representations. It handles charset encodings, \
5 XML escaping conventions, and so forth. It is still considered alpha, \
|
| /openbmc/linux/drivers/platform/x86/intel/pmc/ |
| H A D | Kconfig | 14 exposed by the Power Management Controller. It also may perform some
16 It should be selected on all Intel platforms supported by the driver.
|
| /openbmc/skeleton/libopenbmc_intf/ |
| H A D | GPIOS.md | 10 It looks like:
47 It looks like:
|
| /openbmc/openbmc/meta-openembedded/meta-networking/recipes-support/http-parser/ |
| H A D | http-parser_2.9.4.bb | 2 DESCRIPTION = "This is a parser for HTTP messages written in C. It parses \
4 in performance HTTP applications. It does not make any \
|
| /openbmc/openbmc/poky/meta/recipes-devtools/python/ |
| H A D | python3-click_8.1.7.bb | 4 in a composable way with as little code as necessary. It's the "Command \
5 Line Interface Creation Kit". It's highly configurable but comes with \
|
| /openbmc/linux/drivers/net/ethernet/asix/ |
| H A D | Kconfig | 27 Say Y here to enable SPI transfer compression. It saves up
30 inherited by network interfaces during probe. It can be
|
| /openbmc/linux/drivers/firmware/tegra/ |
| H A D | Kconfig | 9 (Inter Processor Communication) framework on Tegra. It maintains the
21 It needs HSP as the HW synchronization and notification module and
|
| /openbmc/openbmc/meta-openembedded/meta-networking/recipes-support/fetchmail/ |
| H A D | fetchmail_6.4.38.bb | 5 connections). It supports every remote-mail protocol now in use on the Internet: POP2, POP3, \
6 RPOP, APOP, KPOP, all flavors of IMAP, ETRN, and ODMR. It can even support IPv6 and IPSEC."
|
| /openbmc/linux/Documentation/filesystems/ |
| H A D | gfs2-uevents.rst | 17 The ADD event occurs at mount time. It will always be the first
30 The ONLINE uevent is generated after a successful mount or remount. It
45 of journal recovery for one of the filesystems journals. It has
85 line (locktable=) or via fstab. It is used as a filesystem label
93 on the mount command line, or via fstab. It will be either
|
| /openbmc/linux/Documentation/networking/ |
| H A D | ipvs-sysctl.rst | 13 It sets the always mode drop rate, which is used in the mode 3
19 It sets the available memory threshold (in pages), which is
36 port reuse. It is a bitmap, with the values being:
61 that make use of connection tracking. It is a performance
75 address is not local (iph->daddr is RTN_UNICAST). It is mostly
157 packets when its destination server is not available. It may
200 It controls sending icmp error messages (ICMP_DEST_UNREACH)
225 It sets synchronization threshold, which is the minimum number
239 new sync message. It can be used to avoid sync messages for the
256 Hard limit for queued sync messages that are not sent yet. It
[all …]
|
| /openbmc/openbmc/poky/meta/recipes-extended/perl/ |
| H A D | libxml-sax-base-perl_1.09.bb | 4 PerlSAX drivers and filters. It's default behaviour is to pass \
5 the input directly to the output unchanged. It can be useful to \
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | ina209.rst | 25 of a D.C. power supply. It can perform measurements and calculations in the
26 background to supply readings at any time. It includes a programmable
37 sysfs. It does not support every feature of this chip.
97 Output pin programming is a board feature which depends on the BIOS. It is
|
| /openbmc/docs/designs/management-console/ |
| H A D | Authorities_List_Management.md | 16 1. It only allows replacing a single Authority object in dbus; however, Google's
19 2. It only extracts the first certificate given a PEM encoded file with multiple
80 It only extracts the first certificate even if the PEM contains multiple root
90 Certificates) and implement its standalone manager daemon. It has less impact in
|