Searched hist:e85477f5 (Results 1 – 2 of 2) sorted by relevance
| /openbmc/linux/arch/powerpc/configs/83xx/ |
| H A D | mpc8313_rdb_defconfig | e85477f5 Thu Feb 05 14:10:40 CST 2009 Anton Vorontsov <avorontsov@ru.mvista.com> powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards
TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).
This patch fixes following failure during bootup:
mdio@24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
e85477f5 Thu Feb 05 14:10:40 CST 2009 Anton Vorontsov <avorontsov@ru.mvista.com> powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards
TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).
This patch fixes following failure during bootup:
mdio@24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
|
| /openbmc/linux/arch/powerpc/boot/dts/ |
| H A D | mpc8313erdb.dts | e85477f5 Thu Feb 05 14:10:40 CST 2009 Anton Vorontsov <avorontsov@ru.mvista.com> powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards
TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).
This patch fixes following failure during bootup:
mdio@24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
e85477f5 Thu Feb 05 14:10:40 CST 2009 Anton Vorontsov <avorontsov@ru.mvista.com> powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards
TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).
This patch fixes following failure during bootup:
mdio@24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
|