Searched hist:c663e5f5 (Results 1 – 2 of 2) sorted by relevance
| /openbmc/linux/include/linux/gpio/ |
| H A D | driver.h | c663e5f5 Tue Mar 22 04:51:16 CDT 2016 Linus Walleij <linus.walleij@linaro.org> gpio: support native single-ended hardware drivers
Some GPIO controllers has a special hardware bit we can flip
to support open drain / source. This means that on these hardwares
we do not need to emulate OD/OS by setting the line to input
instead of actively driving it high/low. Add an optional vtable
callback to the driver set_single_ended() so that driver can
implement this in hardware if they have it.
We may need a pinctrl_gpio_set_config() call at some point to
propagate this down to a backing pin control device on systems
with split GPIO/pin control.
Reported-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
c663e5f5 Tue Mar 22 04:51:16 CDT 2016 Linus Walleij <linus.walleij@linaro.org> gpio: support native single-ended hardware drivers
Some GPIO controllers has a special hardware bit we can flip
to support open drain / source. This means that on these hardwares
we do not need to emulate OD/OS by setting the line to input
instead of actively driving it high/low. Add an optional vtable
callback to the driver set_single_ended() so that driver can
implement this in hardware if they have it.
We may need a pinctrl_gpio_set_config() call at some point to
propagate this down to a backing pin control device on systems
with split GPIO/pin control.
Reported-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
|
| /openbmc/linux/drivers/gpio/ |
| H A D | gpiolib.c | c663e5f5 Tue Mar 22 04:51:16 CDT 2016 Linus Walleij <linus.walleij@linaro.org> gpio: support native single-ended hardware drivers
Some GPIO controllers has a special hardware bit we can flip
to support open drain / source. This means that on these hardwares
we do not need to emulate OD/OS by setting the line to input
instead of actively driving it high/low. Add an optional vtable
callback to the driver set_single_ended() so that driver can
implement this in hardware if they have it.
We may need a pinctrl_gpio_set_config() call at some point to
propagate this down to a backing pin control device on systems
with split GPIO/pin control.
Reported-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
|