Searched hist:b479bc3c (Results 1 – 1 of 1) sorted by relevance
| /openbmc/qemu/net/ |
| H A D | vhost-vdpa.c | b479bc3c Mon Jul 03 22:34:33 CDT 2023 Hawkins Jiawei <yin31149@gmail.com> vdpa: Return -EIO if device ack is VIRTIO_NET_ERR in _load_mac()
According to VirtIO standard, "The class, command and
command-specific-data are set by the driver,
and the device sets the ack byte.
There is little it can do except issue a diagnostic
if ack is not VIRTIO_NET_OK."
Therefore, QEMU should stop sending the queued SVQ commands and
cancel the device startup if the device's ack is not VIRTIO_NET_OK.
Yet the problem is that, vhost_vdpa_net_load_mac() returns 1 based on
`*s->status != VIRTIO_NET_OK` when the device's ack is VIRTIO_NET_ERR.
As a result, net->nc->info->load() also returns 1, this makes
vhost_net_start_one() incorrectly assume the device state is
successfully loaded by vhost_vdpa_net_load() and return 0, instead of
goto `fail` label to cancel the device startup, as vhost_net_start_one()
only cancels the device startup when net->nc->info->load() returns a
negative value.
This patch fixes this problem by returning -EIO when the device's
ack is not VIRTIO_NET_OK.
Fixes: f73c0c43ac ("vdpa: extract vhost_vdpa_net_load_mac from vhost_vdpa_net_load")
Signed-off-by: Hawkins Jiawei <yin31149@gmail.com>
Acked-by: Jason Wang <jasowang@redhat.com>
Acked-by: Eugenio Pérez <eperezma@redhat.com>
Message-Id: <a21731518644abbd0c495c5b7960527c5911f80d.1688438055.git.yin31149@gmail.com>
Tested-by: Lei Yang <leiyang@redhat.com>
Reviewed-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
|