Searched hist:b4214e41 (Results 1 – 3 of 3) sorted by relevance
| /openbmc/linux/arch/sh/kernel/cpu/sh2/ |
| H A D | smp-j2.c | b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
|
| H A D | Makefile | b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
|
| /openbmc/linux/arch/sh/ |
| H A D | Kconfig | b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
b4214e41 Mon Feb 15 12:36:13 CST 2016 Rich Felker <dalias@libc.org> sh: add SMP support for J2
Support is hooked up via a cpu start method specified in the device
tree, and also depends on DT nodes that describe the interfaces for
performing IPI and identifying which cpu execution is taking place on.
The currently used method is a form of spin table, where secondary
cpus are unblocked by writing to a special address.
Signed-off-by: Rich Felker <dalias@libc.org>
|