Searched hist:"76 d1d169" (Results 1 – 4 of 4) sorted by relevance
| /openbmc/u-boot/board/liebherr/display5/ |
| H A D | spl.c | 76d1d169 Fri May 11 09:51:09 CDT 2018 Lukasz Majewski <lukma@denx.de> display5: wdt: Enable WDT support (both SPL and u-boot)
Test case:
The fitImage gets corrupted:
truncate -c -s 3M fitImage
run tftp_mmc_fitImg
setenv boot_os y
reset
[board shall hang in SPL with
"Trying to boot from MMC1" information]
Then after X seconds WDT is causing board to reset. After N boot attempts
we enter recovery mode.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
|
| /openbmc/u-boot/include/configs/ |
| H A D | display5.h | 76d1d169 Fri May 11 09:51:09 CDT 2018 Lukasz Majewski <lukma@denx.de> display5: wdt: Enable WDT support (both SPL and u-boot)
Test case:
The fitImage gets corrupted:
truncate -c -s 3M fitImage
run tftp_mmc_fitImg
setenv boot_os y
reset
[board shall hang in SPL with
"Trying to boot from MMC1" information]
Then after X seconds WDT is causing board to reset. After N boot attempts
we enter recovery mode.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
|
| /openbmc/u-boot/configs/ |
| H A D | display5_factory_defconfig | 76d1d169 Fri May 11 09:51:09 CDT 2018 Lukasz Majewski <lukma@denx.de> display5: wdt: Enable WDT support (both SPL and u-boot)
Test case:
The fitImage gets corrupted:
truncate -c -s 3M fitImage
run tftp_mmc_fitImg
setenv boot_os y
reset
[board shall hang in SPL with
"Trying to boot from MMC1" information]
Then after X seconds WDT is causing board to reset. After N boot attempts
we enter recovery mode.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
|
| H A D | display5_defconfig | 76d1d169 Fri May 11 09:51:09 CDT 2018 Lukasz Majewski <lukma@denx.de> display5: wdt: Enable WDT support (both SPL and u-boot)
Test case:
The fitImage gets corrupted:
truncate -c -s 3M fitImage
run tftp_mmc_fitImg
setenv boot_os y
reset
[board shall hang in SPL with
"Trying to boot from MMC1" information]
Then after X seconds WDT is causing board to reset. After N boot attempts
we enter recovery mode.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
|