Searched full:unresponsive (Results 1 – 25 of 43) sorted by relevance
12
12 debug data when the host is unresponsive or hung. These systems need the ability18 There is a situation at customer places/lab where the host goes unresponsive23 Whenever the host is unresponsive/running, Admin needs to trigger an NMI event32 fix any issues where they see host hang and unresponsive system.58 1. Host/OS is hung or unresponsive or one need to take kernel dump to debug some70 - Note: NMI can be sent to the host in any state, not just at an unresponsive
57 4. Unresponsive: The service fails to detect it cannot make progress and58 continues to run but is unresponsive70 unnecessary, while in the case of a unresponsive service the need to restart74 unresponsive state can only begin upon receiving external input.91 external interfaces becoming unresponsive and be viewed as a critical failure of101 unresponsive to the point that the BMC cannot be recovered except via external103 the host can detect the BMC is unresponsive on the in-band interface(s), an117 | Unresponsive | None |136 | Unresponsive | `hardlockup_panic`, `softlockup_panic` |166 | 2 | Forceful reboot request | Recovery from unresponsive platform data transport providers…[all …]
162 scenarios where the BMC is hanging or otherwise unresponsive. Note that this
101 progress when the existing maintainers become unresponsive.107 While all unresponsive maintainers are problematic maintainers to some extent,108 it's not true that all problematic maintainers are unresponsive maintainers.110 progress at the subproject scope in the face of unresponsive maintainers. It145 accommodate the review load][ed-is-only-human]. While unresponsive maintainers167 2. An unresponsive maintainer's knowledge of the codebase may age to the point185 2. Not removing rights of an unresponsive maintainer from the subproject exposes200 unresponsive maintainer should itself be notable.207 unresponsive maintainers, beyond recognising that they have met some bar of264 subproject are unresponsive at the project scope before the TOF may on-board new[all …]
4 unresponsive. When the signal is received it triggers a crash to collect debug17 system was externally unresponsive.
54 when it encounters an error and become unresponsive.58 it encounters critical failures or unresponsive.
3 operating system when host is unresponsive or hung.
81 or unresponsive.111 This helps to end testing when target is really dead, hanging or unresponsive.
2 DESCRIPTION = "Forcibly crash an unresponsive system to collect debug data"
6 Upstream-Status: Inappropriate [unresponsive contact email address]
9 Upstream-Status: Inappropriate [unresponsive contact email address]
8 unresponsive. In such situations, the debug data needs to be collected from
68 unresponsive or only processing a restricted set of commands.
90 either unresponsive or only processing a restricted set of
123 Verify Redfish Unresponsive URL paths
393 * gets unresponsive.