Home
last modified time | relevance | path

Searched +full:tri +full:- +full:band (Results 1 – 10 of 10) sorted by relevance

/openbmc/linux/Documentation/devicetree/bindings/net/wireless/
H A Dieee80211.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
2 # Copyright (c) 2018-2019 The Linux Foundation. All rights reserved.
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Lorenzo Bianconi <lorenzo@kernel.org>
18 ieee80211-freq-limit:
19 $ref: /schemas/types.yaml#/definitions/uint32-matrix
26 chipset supports a wide wireless band but it is limited to some part of
28 can be tri-band wireless router with two identical chipsets used for two
35 - |
[all …]
/openbmc/linux/drivers/net/wireless/mediatek/mt76/mt7996/
H A DKconfig1 # SPDX-License-Identifier: ISC
10 This adds support for MT7996-based PCIe wireless devices,
11 which support concurrent tri-band operation at 6GHz, 5GHz,
12 and 2.4GHz IEEE 802.11be 4x4:4SS 4096-QAM, 320MHz channels.
/openbmc/linux/drivers/media/dvb-frontends/
H A Ddib0070.h1 /* SPDX-License-Identifier: GPL-2.0-only */
3 * Linux-DVB Driver for DiBcom's DiB0070 base-band RF Tuner.
5 * Copyright (C) 2005-7 DiBcom (http://www.dibcom.fr/)
31 u8 osc_buffer_state; /* 0= normal, 1= tri-state */
35 u8 invert_iq; /* invert Q - in case I or Q is inverted on the board */
37 u8 force_crystal_mode; /* if == 0 -> decision is made in the driver default: <24 -> 2, >=24 -> 1 */
H A Dbcm3510.c4 * Copyright (C) 2001-5, B2C2 inc.
8 * This driver is "hard-coded" to be used with the 1st generation of
9 * Technisat/B2C2's Air2PC ATSC PCI/USB cards/boxes. The pll-programming
13 * The driver works also with QAM64 DVB-C, but had an unreasonable high
17 * called "dvb-fe-bcm3510-01.fw".
68 MODULE_PARM_DESC(debug, "set debugging level (1=info,2=i2c (|-able)).");
85 …struct i2c_msg msg = { .addr = state->config->demod_address, .flags = 0, .buf = b, .len = len + 1 … in bcm3510_writebytes()
94 if ((err = i2c_transfer (state->i2c, &msg, 1)) != 1) { in bcm3510_writebytes()
97 __func__, state->config->demod_address, reg, err); in bcm3510_writebytes()
98 return -EREMOTEIO; in bcm3510_writebytes()
[all …]
/openbmc/linux/include/linux/mtd/
H A Drawnand.h1 /* SPDX-License-Identifier: GPL-2.0-only */
3 * Copyright © 2000-2010 David Woodhouse <dwmw2@infradead.org>
75 #define NAND_CMD_NONE -1
84 #define NAND_DATA_IFACE_CHECK_ONLY -1
98 * ecc.correct() returns -EBADMSG.
124 * Chip requires ready check on read (for auto-incremented sequential read).
142 #define NAND_HAS_SUBPAGE_READ(chip) ((chip->options & NAND_SUBPAGE_READ))
174 * In case your controller is implementing ->legacy.cmd_ctrl() and is relying
175 * on the default ->cmdfunc() implementation, you may want to let the core
225 * struct nand_parameters - NAND generic parameters from the parameter page
[all …]
/openbmc/linux/drivers/media/tuners/
H A Dtda18271-fe.c1 // SPDX-License-Identifier: GPL-2.0-or-later
3 tda18271-fe.c - driver for the Philips / NXP TDA18271 silicon tuner
9 #include "tda18271-priv.h"
17 MODULE_PARM_DESC(debug, "set debug level (info=1, map=2, reg=4, adv=8, cal=16 (or-able))");
19 static int tda18271_cal_on_startup = -1;
26 /*---------------------------------------------------------------------*/
30 struct tda18271_priv *priv = fe->tuner_priv; in tda18271_toggle_output()
33 priv->output_opt & TDA18271_OUTPUT_LT_OFF ? 1 : 0, in tda18271_toggle_output()
34 priv->output_opt & TDA18271_OUTPUT_XT_OFF ? 1 : 0); in tda18271_toggle_output()
41 priv->output_opt & TDA18271_OUTPUT_XT_OFF ? "off" : "on", in tda18271_toggle_output()
[all …]
/openbmc/linux/drivers/block/drbd/
H A Ddrbd_worker.c1 // SPDX-License-Identifier: GPL-2.0-only
7 Copyright (C) 2001-2008, LINBIT Information Technologies GmbH.
8 Copyright (C) 1999-2008, Philipp Reisner <philipp.reisner@linbit.com>.
9 Copyright (C) 2002-2008, Lars Ellenberg <lars.ellenberg@linbit.com>.
54 device = bio->bi_private; in drbd_md_endio()
55 device->md_io.error = blk_status_to_errno(bio->bi_status); in drbd_md_endio()
58 if (device->ldev) in drbd_md_endio()
65 * drbd_md_put_buffer() may allow us to finally try and re-attach. in drbd_md_endio()
71 * ASSERT(atomic_read(&device->md_io_in_use) == 1) there. in drbd_md_endio()
74 device->md_io.done = 1; in drbd_md_endio()
[all …]
/openbmc/linux/drivers/media/usb/gspca/
H A Dov519.c1 // SPDX-License-Identifier: GPL-2.0-or-later
5 * Copyright (C) 2008-2011 Jean-François Moine <moinejf@free.fr>
8 * This module is adapted from the ov51x-jpeg package, which itself
13 * Copyright (c) 1999-2006 Mark W. McClelland
20 * ov51x-jpeg original copyright is:
22 * Copyright (c) 2004-2007 Romain Beauxis <toots@rastageeks.org>
38 MODULE_AUTHOR("Jean-Francois Moine <http://moinejf.free.fr>");
482 /*jfm: this value does not work for 800x600 - see isoc_init */
536 #define OV7670_COM8_BFILT 0x20 /* Band filter enable */
539 #define OV7670_R14_COM9 0x14 /* Control 9 - gain ceiling */
[all …]
/openbmc/linux/drivers/net/wireless/broadcom/brcm80211/brcmfmac/
H A Dsdio.c1 // SPDX-License-Identifier: ISC
72 __le32 buf; /* Can't be pointer on (64-bit) hosts */
117 #define TXHI (TXQLEN - 256) /* turn on flow control above TXHI */
118 #define TXLOW (TXHI - 256) /* turn off flow control below TXLOW */
146 /* 1: isolate internal sdio signals, put external pads in tri-state; requires
151 /* Force SD->SB reset mapping (rev 11) */
247 #define SFC_ABORTALL (1 << 3) /* Abort all in-progress frames */
286 * Software-defined protocol header
417 uint fc_rcvd; /* Number of flow-control events received */
418 uint fc_xoff; /* Number which turned on flow-control */
[all …]
/openbmc/linux/drivers/net/ethernet/broadcom/bnx2x/
H A Dbnx2x_reg.h3 * Copyright (c) 2007-2013 Broadcom Corporation
13 * R - Read only
14 * RC - Clear on read
15 * RW - Read/Write
16 * ST - Statistics register (clear on read)
17 * W - Write only
18 * WB - Wide bus register - the size is over 32 bits and it should be
20 * WR - Write Clear (write 1 to clear the bit)
32 /* [RW 1] Initiate the ATC array - reset all the valid bits */
56 * BRB1_IND_FREE_LIST_PRS_CRDT+2 initialize parser initial credit. Warning -
[all …]