Home
last modified time | relevance | path

Searched full:sends (Results 1 – 25 of 1271) sorted by relevance

12345678910>>...51

/openbmc/linux/Documentation/networking/
H A Dcan_ucan_protocol.rst22 The driver sends device management commands on this endpoint
25 The device sends CAN data frames and CAN error frames
28 The driver sends CAN data frames on the out endpoint
303 error frames (see ``uapi/linux/can/error.h``) and sends it using the
318 - Once Bus OFF recover is completed the device sends an error frame
328 #) Host sends command ``UCAN_COMMAND_RESET``, subcmd 0
329 #) Host sends command ``UCAN_COMMAND_GET``, subcmd ``UCAN_COMMAND_GET_INFO``
330 #) Device sends ``UCAN_IN_DEVICE_INFO``
331 #) Host sends command ``UCAN_OUT_SET_BITTIMING``
332 #) Host sends command ``UCAN_COMMAND_START``, subcmd 0, mode ``UCAN_MODE_BERR_REPORT``
/openbmc/qemu/docs/specs/
H A Divshmem-spec.rst143 - sends the ID and the file descriptor for the shared memory to the
145 - sends connect notifications for the new client to the other clients
147 - sends connect notifications for the other clients to the new client,
149 - sends interrupt setup messages to the new client (these contain file
154 When a client disconnects from the server, the server sends disconnect
179 The connection is one-way: the server sends messages to the client.
187 On connect, the server sends the following messages in order:
214 From then on, the server sends these kinds of messages:
/openbmc/linux/Documentation/sound/cards/
H A Dserial-u16550.rst18 sends the nonstandard MIDI command sequence F5 NN, where NN is the substream
37 module parameter is automatically set to 1. The driver sends the same data to
49 the outs module parameter is automatically set to 1. The driver sends
62 Out 3, and midiCnD8 to Out 4. Thus midiCnD15 sends the data to all 4 ports.
63 As a special case, midiCnD0 also sends to all ports, since it is not useful
/openbmc/linux/include/rdma/
H A Dib_cm.h374 * ib_send_cm_req - Sends a connection request to the remote node.
398 * ib_send_cm_rep - Sends a connection reply in response to a connection
409 * ib_send_cm_rtu - Sends a connection ready to use message in response
421 * ib_send_cm_dreq - Sends a disconnection request for an existing
434 * ib_send_cm_drep - Sends a disconnection reply to a disconnection request.
465 * ib_send_cm_rej - Sends a connection rejection message to the
486 * ib_send_cm_mra - Sends a message receipt acknowledgement to a connection
532 * ib_send_cm_sidr_req - Sends a service ID resolution request to the
553 * ib_send_cm_sidr_rep - Sends a service ID resolution reply to the
/openbmc/linux/include/linux/avf/
H A Dvirtchnl.h98 /* The PF sends status change events to VFs using
195 * VF sends this request to PF with no parameters
216 * Version 1.0 VF sends this request to PF with no parameters
217 * Version 1.1 VF sends this request to PF with u32 bitmap of its capabilities
284 * VF sends this message to set up parameters for one TX queue.
302 * VF sends this message to set up parameters for one RX queue.
335 * VF sends this message to set parameters for all active TX and RX queues
363 * VF sends this message to request the PF to allocate additional queues to
410 * VF sends these message to enable or disable TX/RX queue pairs.
429 * VF sends this message in order to add one or more unicast or multicast
[all …]
/openbmc/docs/designs/
H A Dpower-systems-memory-preserving-reboot.md168 #### 8 - Hypervisor Formats dump and sends notification to BMC
170 Once the hypervisor is started, it formats the dump and sends a notification to
181 NBD device id. PLDM sends the offload request to the hypervisor with the dump
190 #### 11 - Hypervisor sends down offload complete message
192 Hypervisor sends down offload complete message to BMC and BMC sends it to HMC.
197 HMC verifies the dump and send dump delete request to BMC BMC sends the dump
/openbmc/qemu/tests/qtest/
H A Dlibqtest.h129 * Sends a QMP message to QEMU with fds and returns the response.
143 * Sends a QMP message to QEMU and returns the response.
155 * Sends a QMP message to QEMU and leaves the response in the stream.
165 * Sends text to the QMP monitor verbatim. Need not be valid JSON;
190 * Sends a QMP message to QEMU with fds and returns the response.
205 * Sends a QMP message to QEMU and returns the response.
221 * Sends a QMP message to QEMU and leaves the response in the stream.
236 * Sends a QMP message to QEMU and leaves the response in the stream.
767 * Sends a QMP message to QEMU, asserts that a 'return' key is present in
782 * Sends a QMP message to QEMU and asserts that a 'return' key is present in
[all …]
/openbmc/linux/Documentation/staging/
H A Drpmsg.rst73 sends a message across to the remote processor on a given channel.
92 sends a message across to the remote processor on a given channel,
117 sends a message across to the remote processor, using the src and dst
139 sends a message across to the remote processor on a given channel.
156 sends a message across to the remote processor on a given channel,
178 sends a message across to the remote processor, using source and
263 The following is a simple rpmsg driver, that sends an "hello!" message
/openbmc/linux/sound/soc/xilinx/
H A DKconfig7 mode, IP receives audio in AES format, extracts PCM and sends
9 encapsulates PCM in AES format and sends AES data.
/openbmc/linux/Documentation/virt/hyperv/
H A Dvmbus.rst114 * Unidirectional: Either side sends a message and does not
116 * Request/response: One side (usually the guest) sends a message
122 sending a request. Hyper-V sends back the same transactionID in the
173 ring buffer transitions from empty to non-empty. If the guest sends
175 unnecessary. If a guest sends an excessive number of unnecessary
179 Similarly, the host will interrupt the guest when it sends a new
258 The guest then tells Hyper-V to "send offers". Hyper-V sends an
/openbmc/phosphor-host-ipmid/xyz/openbmc_project/Ipmi/Internal/
H A DSoftPowerOff.interface.yaml5 sends 'ReadEvent' command and BMC responds with an architected packet
16 'SoftOffReceived' and is set to 'HostShutdown' when Host sends a Power
/openbmc/libmctp/docs/bindings/
H A Dvendor-ibm-astlpc.md311 The host sends commands to the BMC to signal channel initialisation, begin
324 The BMC sends commands to the host to begin transmission of a packet or to
337 The BMC sends status updates to the host to signal loss of function, loss of
365 2. The Tx side sends a `Tx Begin` message, indicating that the buffer ownership
368 4. The Rx side sends a `Rx Complete` once done, indicating that the buffer
399 | 4 | ✓ | ✓ | ✓ | The host sends the `Initialise` command …
415 | 4 | ✓ | ✓ | ✓ | The host sends the `Tx Begin` command, transferring ownership of its Tx …
418 | 7 | ✓ | ✓ | ✓ | The BMC sends the `Rx Complete` command, transferring ownership of its R…
429 | 4 | ✓ | ✓ | ✓ | The BMC sends the `Tx Begin` command, transferring ownership of its Tx b…
432 | 7 | ✓ | ✓ | ✓ | The host sends the `Rx Complete` command, transferring ownership of its …
/openbmc/linux/Documentation/userspace-api/media/dvb/
H A Dfe-diseqc-send-master-cmd.rst13 FE_DISEQC_SEND_MASTER_CMD - Sends a DiSEqC command
35 Sends the DiSEqC command pointed by :c:type:`dvb_diseqc_master_cmd`
/openbmc/linux/Documentation/ABI/testing/
H A Ddebugfs-cxl7 attribute, the memdev driver sends an inject poison command to
28 attribute, the memdev driver sends a clear poison command to
H A Dsysfs-bus-fsi14 Sends an FSI BREAK command on a master's communication
24 Sends an FSI terminate command from the master to its
/openbmc/linux/include/drm/
H A Di915_gsc_proxy_mei_interface.h17 * @send: sends a proxy message from GSC FW to ME FW
24 * send - Sends a proxy message to ME FW.
/openbmc/linux/Documentation/driver-api/mei/
H A Diamt.rst45 When a local application sends a message addressed to the local Intel AMT host
89 and sends an event when the heartbeats stop.
91 configures the watchdog and sends the heartbeats.
/openbmc/linux/tools/perf/util/
H A Devents_stats.h12 * when possible sends this number in a PERF_RECORD_LOST event. The number of
17 * The kernel discards mixed up samples and sends the number in a
/openbmc/linux/Documentation/hid/
H A Dintel-ish-hid.rst194 independent. The sending side sends DMA_XFER message when the message is in
195 the respective host buffer (TX when host client sends, RX when FW client
196 sends). The recipient of DMA message responds with DMA_XFER_ACK, indicating
205 Here ISH acts as busmaster DMA controller. Hence when host sends DMA_XFER,
206 it's request to do host->ISH DMA transfer; when FW sends DMA_XFER, it means
243 - Host sends HOST_START_REQ_CMD, indicating that host ISHTP layer is up.
245 - Host sends HOST_ENUM_REQ_CMD (enumerate FW clients)
248 - For each FW ID found in that bitmap host sends
/openbmc/linux/include/linux/
H A Dspmi.h76 * @cmd: sends a non-data command sequence on the SPMI bus.
77 * @read_cmd: sends a register read command sequence on the SPMI bus.
78 * @write_cmd: sends a register write command sequence on the SPMI bus.
H A Dhil_mlc.h48 * is an IN or EXPECT, and then sends the given packet.
55 /* HILSE_OUT_LAST sends the given command packet to
60 /* HILSE_OUT_DISC sends the given command packet to
/openbmc/linux/Documentation/misc-devices/
H A Dibmvmc.rst152 RDMA of the HMC ID to the hypervisor, and then sends an Interface Open
154 hypervisor receives this information, it sends Add Buffer messages to the
156 connection. Finally, the hypervisor sends an Interface Open Response
181 and then sends a Signal Message. If a write() is attempted before VMC
185 state. When the hypervisor sends a message to the management, the data is
/openbmc/linux/Documentation/arch/sparc/
H A Dadi.rst105 first. Hypervisor creates a sun4v error report and sends a
106 resumable error (TT=0x7e) trap to the kernel. The kernel sends
125 exception is sent to the kernel with TT=0x1a. The kernel sends
143 on a memory address, processor sends an MCD disabled trap. This
147 sends the task SIGSEGV signal with following info::
/openbmc/linux/Documentation/admin-guide/
H A Dedid.rst18 - The monitor sends no or bogus EDID data.
19 - A KVM sends its own EDID data instead of querying the connected monitor.
/openbmc/linux/drivers/hwtracing/stm/
H A DKconfig54 This is a kernel space trace source that sends kernel log
63 This is a kernel space trace source that sends periodic

12345678910>>...51