Searched full:p27 (Results 1 – 7 of 7) sorted by relevance
| /openbmc/linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun6i-a31s-sinovoip-bpi-m2.dts | 276 "CN7-P28", "CN7-P27", "CN7-P32", "", "", "", "", "", "",
288 "CN9-P19", "CN9-P21", "CN9-P23", "CN9-P25", "CN9-P27",
297 "CN6-P21", "CN6-P23", "CN6-P25", "CN6-P27", "CN6-P29",
|
| H A D | sun8i-h2-plus-bananapi-m2-zero.dts | 202 "CON2-P12", "CON2-P37", "CON2-P28", "CON2-P27",
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-pca95xx.yaml | 200 "fault1", "p26", "p27";
|
| /openbmc/linux/drivers/ata/ |
| H A D | pata_ep93xx.c | 277 * edge of the DIORN signal. (EP93xx UG p27-14) in ep93xx_pata_read()
310 * DIOWN is low. (EP93xx UG p27-13) in ep93xx_pata_write()
788 * (EP93xx UG p27-17) in ep93xx_pata_dma_status()
|
| /openbmc/linux/arch/arm64/boot/dts/amlogic/ |
| H A D | meson-sm1-bananapi.dtsi | 289 "CON1-P27", /* GPIOA_14 */
|
| /openbmc/linux/arch/arm64/boot/dts/ti/ |
| H A D | k3-j721s2-common-proc-board.dts | 276 J721S2_WKUP_IOPAD(0x0f8, PIN_INPUT, 0) /* (P27) MCU_ADC1_AIN3 */
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/sensors/phosphor-virtual-sensor/sbp1/ |
| H A D | virtual_sensor_config.json | 1620 "ParamName": "P27",
1663 "Expression": "sumIgnoreNaN(P1, P2, P3, P4, P5, P6, P7, P8, P9, P10, P11, P12, P13, P14, P15, P16, P17, P18, P19, P20, P21, P22, P23, P24, P25, P26, P27, P28, P29, P30, P31, P32)"
|