Searched +full:ocp +full:- +full:max +full:- +full:retries (Results 1 – 4 of 4) sorted by relevance
| /openbmc/linux/arch/arm/boot/dts/qcom/ |
| H A D | pm8941.dtsi | 1 // SPDX-License-Identifier: GPL-2.0
2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
3 #include <dt-bindings/interrupt-controller/irq.h>
4 #include <dt-bindings/spmi/spmi.h>
8 thermal-zones {
9 pm8941-thermal {
10 polling-delay-passive = <100>;
11 polling-delay = <0>;
12 thermal-sensors = <&pm8941_temp>;
40 compatible = "qcom,pm8941", "qcom,spmi-pmic";
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/regulator/ |
| H A D | qcom,spmi-regulator.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/regulator/qcom,spmi-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Robert Marko <robimarko@gmail.com>
15 - qcom,pm6125-regulators
16 - qcom,pm660-regulators
17 - qcom,pm660l-regulators
18 - qcom,pm8004-regulators
19 - qcom,pm8005-regulators
[all …]
|
| /openbmc/linux/drivers/regulator/ |
| H A D | qcom_spmi-regulator.c | 1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (c) 2012-2015, The Linux Foundation. All rights reserved.
8 #include <linux/devm-helpers.h>
57 * struct spmi_regulator_init_data - spmi-regulator initialization data
365 * struct spmi_voltage_range - regulator set point voltage mapping description
380 * (max_uV - min_uV) % step_uV == 0
381 * (set_point_min_uV - min_uV) % step_uV == 0*
382 * (set_point_max_uV - min_uV) % step_uV == 0*
383 * n_voltages = (set_point_max_uV - set_point_min_uV) / step_uV + 1
441 const char *ocp; member
[all …]
|
| /openbmc/linux/drivers/bus/ |
| H A D | ti-sysc.c | 1 // SPDX-License-Identifier: GPL-2.0
3 * ti-sysc.c - Texas Instruments sysc interconnect target driver
24 #include <linux/platform_data/ti-sysc.h>
26 #include <dt-bindings/bus/ti-sysc.h>
96 * struct sysc - TI sysc interconnect target module registers and capabilities
102 * @mdata: ti-sysc to hwmod translation data for a module
120 * @pre_reset_quirk: module specific pre-reset quirk
121 * @post_reset_quirk: module specific post-reset quirk
166 if (ddata->cfg.quirks & SYSC_QUIRK_16BIT) { in sysc_write()
167 writew_relaxed(value & 0xffff, ddata->module_va + offset); in sysc_write()
[all …]
|