Home
last modified time | relevance | path

Searched +full:nand +full:- +full:use +full:- +full:soft +full:- +full:ecc +full:- +full:engine (Results 1 – 15 of 15) sorted by relevance

/openbmc/linux/Documentation/devicetree/bindings/mtd/
H A Dnand-chip.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/nand-chip.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: NAND Chip Common Properties
10 - Miquel Raynal <miquel.raynal@bootlin.com>
13 - $ref: mtd.yaml#
16 This file covers the generic description of a NAND chip. It implies that the
17 bus interface should not be taken into account: both raw NAND devices and
18 SPI-NAND devices are concerned by this description.
[all …]
H A Datmel-nand.txt1 Atmel NAND flash controller bindings
3 The NAND flash controller node should be defined under the EBI bus (see
4 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt).
5 One or several NAND devices can be defined under this NAND controller.
6 The NAND controller might be connected to an ECC engine.
8 * NAND controller bindings:
11 - compatible: should be one of the following
12 "atmel,at91rm9200-nand-controller"
13 "atmel,at91sam9260-nand-controller"
14 "atmel,at91sam9261-nand-controller"
[all …]
H A Draw-nand-chip.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mtd/raw-nand-chip.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Raw NAND Chip Common Properties
10 - Miquel Raynal <miquel.raynal@bootlin.com>
13 - $ref: nand-chip.yaml#
16 The ECC strength and ECC step size properties define the user
18 they request the ECC engine to correct {strength} bit errors per
19 {size} bytes for a particular raw NAND chip.
[all …]
/openbmc/linux/drivers/mtd/nand/
H A Decc.c1 // SPDX-License-Identifier: GPL-2.0+
3 * Generic Error-Correcting Code (ECC) engine
10 * This file describes the abstraction of any NAND ECC engine. It has been
11 * designed to fit most cases, including parallel NANDs and SPI-NANDs.
13 * There are three main situations where instantiating this ECC engine makes
15 * - external: The ECC engine is outside the NAND pipeline, typically this
16 * is a software ECC engine, or an hardware engine that is
17 * outside the NAND controller pipeline.
18 * - pipelined: The ECC engine is inside the NAND pipeline, ie. on the
19 * controller's side. This is the case of most of the raw NAND
[all …]
/openbmc/linux/drivers/mtd/nand/raw/
H A Darasan-nand-controller.c1 // SPDX-License-Identifier: GPL-2.0
3 * Arasan NAND Flash Controller Driver
5 * Copyright (C) 2014 - 2020 Xilinx, Inc.
17 #include <linux/dma-mapping.h>
114 #define ANFC_MAX_PKT_SIZE (SZ_2K - 1)
124 * struct anfc_op - Defines how to execute an operation
150 * struct anand - Defines the NAND chip related information
151 * @node: Used to store NAND chips into a list
152 * @chip: NAND chip information structure
153 * @rb: Ready-busy line
[all …]
H A Ddavinci_nand.c1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * davinci_nand.c - NAND Flash Driver for DaVinci family chips
8 * Sander Huijsen <Shuijsen@optelecom-nkf.com>
23 #include <linux/platform_data/mtd-davinci.h>
24 #include <linux/platform_data/mtd-davinci-aemif.h>
27 * This is a device driver for the NAND flash controller found on the
32 * The 1-bit ECC hardware is supported, as well as the newer 4-bit ECC
33 * available on chips like the DM355 and OMAP-L137 and needed with the
34 * more error-prone MLC NAND chips.
36 * This driver assumes EM_WAIT connects all the NAND devices' RDY/nBUSY
[all …]
H A Dnand_base.c1 // SPDX-License-Identifier: GPL-2.0-only
4 * This is the generic MTD driver for NAND flash devices. It should be
5 * capable of working with almost all NAND chips currently available.
8 * http://www.linux-mtd.infradead.org/doc/nand.html
11 * 2002-2006 Thomas Gleixner (tglx@linutronix.de)
21 * Check, if mtd->ecctype should be set to MTD_ECC_HW
22 * if we have HW ECC support.
37 #include <linux/mtd/nand.h>
38 #include <linux/mtd/nand-ecc-sw-hamming.h>
39 #include <linux/mtd/nand-ecc-sw-bch.h>
[all …]
H A Ds3c2410.c1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright © 2004-2008 Simtec Electronics
7 * Samsung S3C2410/S3C2440/S3C2412 NAND driver
10 #define pr_fmt(fmt) "nand-s3c2410: " fmt
34 #include <linux/platform_data/mtd-nand-s3c2410.h>
71 /* new oob placement block for use with hardware ecc generation
77 return -ERANGE; in s3c2410_ooblayout_ecc()
79 oobregion->offset = 0; in s3c2410_ooblayout_ecc()
80 oobregion->length = 3; in s3c2410_ooblayout_ecc()
89 return -ERANGE; in s3c2410_ooblayout_free()
[all …]
/openbmc/linux/drivers/mtd/nand/raw/gpmi-nand/
H A Dgpmi-nand.c1 // SPDX-License-Identifier: GPL-2.0+
3 * Freescale GPMI NAND Flash Driver
5 * Copyright (C) 2010-2015 Freescale Semiconductor, Inc.
18 #include <linux/dma/mxs-dma.h>
19 #include "gpmi-nand.h"
20 #include "gpmi-regs.h"
21 #include "bch-regs.h"
23 /* Resource names for the GPMI NAND driver. */
24 #define GPMI_NAND_GPMI_REGS_ADDR_RES_NAME "gpmi-nand"
52 while ((readl(addr) & mask) && --timeout) in clear_poll_bit()
[all …]
/openbmc/u-boot/drivers/mtd/nand/raw/
H A Dnand_base.c3 * This is the generic MTD driver for NAND flash devices. It should be
4 * capable of working with almost all NAND chips currently available.
7 * http://www.linux-mtd.infradead.org/doc/nand.html
10 * 2002-2006 Thomas Gleixner (tglx@linutronix.de)
20 * Check, if mtd->ecctype should be set to MTD_ECC_HW
21 * if we have HW ECC support.
113 if (ofs & ((1ULL << chip->phys_erase_shift) - 1)) { in check_offs_len()
115 ret = -EINVAL; in check_offs_len()
119 if (len & ((1ULL << chip->phys_erase_shift) - 1)) { in check_offs_len()
121 ret = -EINVAL; in check_offs_len()
[all …]
/openbmc/linux/
H A Dopengrok0.0.log1 2024-12-28 20:09:05.996-0600 FINEST t1171 PendingFileCompleter.doRename: Moved pending as file: '/opengrok/data/xref/openbmc/linux/drivers/staging/media/av7110/video-continue.rst.gz'
2 2024-12-28 20:09:05.942-0600 FINEST t1149 PendingFileCompleter.doRename: Moved pending as file: '/opengrok/data/xref/openbmc/u-boot/arch/sh/config.mk.gz'
3 2024-12-2
[all...]
H A Dopengrok1.0.log1 2024-12-28 20:07:11.902-0600 FINER t583 IndexDatabase.createAnnotationCache: failed to create annotation: repository {dir='/opengrok/src/openbmc/linux',type=git,historyCache=on,renamed=false,merge=true,annotationCache=off} does not allow to create annotation cache for '/opengrok/src/openbmc/linux/drivers/net/ethernet/marvell/mvpp2/mvpp2_prs.c'
2 2024-12-28 20:07:11.913-0600 FINEST t583 Statistics.logIt: Added: '/openbmc/linux/drivers/net/ethernet/marvell/mvpp2/mvpp2_prs.c' (CAnalyzer) (took 116 ms)
3 2024-12-28 20:07:11.899-0600 FINER t593 IndexDatabase.createAnnotationCache: failed to create annotation: repository {dir='/opengrok/src/openbmc/linux',type=git,historyCache=on,renamed=false,merge=true,annotationCache=off} does not allow to create annotation cache for '/opengrok/src/openbmc/linux/tools/testing/selftests/powerpc/tm/tm-signa
[all...]
H A Dopengrok2.0.log1 2024-12-28 20:05:26.116-0600 FINEST t586 Statistics.logIt: Added: '/openbmc/linux/tools/testing/selftests/drivers/net/mlxsw/rtnetlink.sh' (ShAnalyzer) (took 79 ms)
2 2024-12-28 20:05:26.112-0600 FINER t592 IndexDatabase.createAnnotationCache: failed to create annotation: repository {dir='/opengrok/src/openbmc/qemu',type=git,historyCache=on,renamed=false,merge=true,annotationCache=off} does not allow to create annotation cache for '/opengrok/src/openbmc/qemu/chardev/spice.c'
3 2024-12-28 20:05:26.116-0600 FINEST t592 Statistics.logIt: Added: '/openbmc/qemu/chardev/spice.c' (CAnalyzer) (took 33 ms)
4 2024-1
[all...]
/openbmc/
Dopengrok1.0.log1 2025-03-28 03:00:39.864-0500 FINE t1 Executor.registerErrorHandler: Installing default uncaught exception handler
2 2025-03-28 03:00:39.984-0500 INFO t1 Indexer.parseOptions: Indexer options: [-c, /usr/local/bin/ctags, -T, 12, -s, /opengrok/src, -
[all...]
Dopengrok2.0.log1 2025-03-27 03:00:39.486-0500 FINE t1 Executor.registerErrorHandler: Installing default uncaught exception handler
2 2025-03-27 03:00:39.605-0500 INFO t1 Indexer.parseOptions: Indexer options: [-c, /usr/local/bin/ctags, -T, 12, -s, /opengrok/src, -
[all...]