Searched +full:mmc +full:- +full:pwrseq +full:- +full:sd8787 (Results 1 – 9 of 9) sorted by relevance
/openbmc/linux/Documentation/devicetree/bindings/mmc/ |
H A D | mmc-pwrseq-sd8787.yaml | 1 # SPDX-License-Identifier: GPL-2.0 3 --- 4 $id: http://devicetree.org/schemas/mmc/mmc-pwrseq-sd8787.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: Marvell SD8787 power sequence provider 10 - Ulf Hansson <ulf.hansson@linaro.org> 15 - mmc-pwrseq-sd8787 16 - mmc-pwrseq-wilc1000 18 powerdown-gpios: 23 reset-gpios: [all …]
|
/openbmc/linux/drivers/mmc/core/ |
H A D | pwrseq_sd8787.c | 1 // SPDX-License-Identifier: GPL-2.0-or-later 3 * pwrseq_sd8787.c - power sequence support for Marvell SD8787 BT + Wifi chip 23 #include <linux/mmc/host.h> 25 #include "pwrseq.h" 28 struct mmc_pwrseq pwrseq; member 33 #define to_pwrseq_sd8787(p) container_of(p, struct mmc_pwrseq_sd8787, pwrseq) 37 struct mmc_pwrseq_sd8787 *pwrseq = to_pwrseq_sd8787(host->pwrseq); in mmc_pwrseq_sd8787_pre_power_on() local 39 gpiod_set_value_cansleep(pwrseq->reset_gpio, 1); in mmc_pwrseq_sd8787_pre_power_on() 42 gpiod_set_value_cansleep(pwrseq->pwrdn_gpio, 1); in mmc_pwrseq_sd8787_pre_power_on() 47 struct mmc_pwrseq_sd8787 *pwrseq = to_pwrseq_sd8787(host->pwrseq); in mmc_pwrseq_sd8787_power_off() local [all …]
|
H A D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 3 # MMC core configuration 10 This selects Hardware reset support aka pwrseq-emmc for eMMC 17 tristate "HW reset support for SD8787 BT + Wifi module" 20 This selects hardware reset support for the SD8787 BT + Wifi 27 tristate "Simple HW reset support for MMC" 31 This selects simple hardware reset support aka pwrseq-simple for MMC 38 tristate "MMC block device driver" 43 Say Y here to enable the MMC block device driver support. 45 mount the filesystem. Almost everyone wishing MMC support [all …]
|
/openbmc/linux/Documentation/devicetree/bindings/net/wireless/ |
H A D | marvell-8xxx.txt | 1 Marvell 8787/8897/8978/8997 (sd8787/sd8897/sd8978/sd8997/pcie8997) SDIO/PCIE devices 2 ------ 10 - compatible : should be one of the following: 11 * "marvell,sd8787" 21 - marvell,caldata* : A series of properties with marvell,caldata prefix, 23 initialization. This is an array of unsigned 8-bit values. 26 "marvell,caldata-txpwrlimit-2g" (length = 566). 27 "marvell,caldata-txpwrlimit-5g-sub0" (length = 502). 28 "marvell,caldata-txpwrlimit-5g-sub1" (length = 688). 29 "marvell,caldata-txpwrlimit-5g-sub2" (length = 750). [all …]
|
/openbmc/linux/arch/arm/boot/dts/marvell/ |
H A D | mmp2-olpc-xo-1-75.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT 8 /dts-v1/; 10 #include <dt-bindings/gpio/gpio.h> 11 #include <dt-bindings/input/linux-event-codes.h> 12 #include <dt-bindings/interrupt-controller/irq.h> 13 #include <dt-bindings/clock/marvell,mmp2-audio.h> 16 model = "OLPC XO-1.75"; 17 compatible = "olpc,xo-1.75", "mrvl,mmp2"; 20 #address-cells = <1>; 21 #size-cells = <1>; [all …]
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | imx6q-cm-fx6.dts | 6 * This file is dual-licensed: you can use it either under the terms 44 /dts-v1/; 45 #include <dt-bindings/gpio/gpio.h> 49 model = "CompuLab CM-FX6"; 50 compatible = "compulab,cm-fx6", "fsl,imx6q"; 57 compatible = "gpio-leds"; 59 heartbeat-led { 62 linux,default-trigger = "heartbeat"; 66 awnh387_pwrseq: pwrseq { 67 pinctrl-names = "default"; [all …]
|
/openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
H A D | imx6q-cm-fx6.dts | 6 * This file is dual-licensed: you can use it either under the terms 44 /dts-v1/; 45 #include <dt-bindings/gpio/gpio.h> 46 #include <dt-bindings/sound/fsl-imx-audmux.h> 50 model = "CompuLab CM-FX6"; 51 compatible = "compulab,cm-fx6", "fsl,imx6q"; 59 compatible = "gpio-leds"; 61 heartbeat-led { 64 linux,default-trigger = "heartbeat"; 68 awnh387_pwrseq: pwrseq { [all …]
|
/openbmc/linux/ |
H A D | opengrok0.0.log | 1 2024-12-28 20:09:05.996-0600 FINEST t1171 PendingFileCompleter.doRename: Moved pending as file: '/opengrok/data/xref/openbmc/linux/drivers/staging/media/av7110/video-continue.rst.gz' 2 2024-12-28 20:09:05.942-0600 FINEST t1149 PendingFileCompleter.doRename: Moved pending as file: '/opengrok/data/xref/openbmc/u-boot/arch/sh/config.mk.gz' 3 2024-12-2 [all...] |
H A D | opengrok2.0.log | 1 2024-12-28 20:05:26.116-0600 FINEST t586 Statistics.logIt: Added: '/openbmc/linux/tools/testing/selftests/drivers/net/mlxsw/rtnetlink.sh' (ShAnalyzer) (took 79 ms) 2 2024-12-28 20:05:26.112-0600 FINER t592 IndexDatabase.createAnnotationCache: failed to create annotation: repository {dir='/opengrok/src/openbmc/qemu',type=git,historyCache=on,renamed=false,merge=true,annotationCache=off} does not allow to create annotation cache for '/opengrok/src/openbmc/qemu/chardev/spice.c' 3 2024-12-28 20:05:26.116-0600 FINEST t592 Statistics.logIt: Added: '/openbmc/qemu/chardev/spice.c' (CAnalyzer) (took 33 ms) 4 2024-1 [all...] |