| /openbmc/qemu/util/ |
| H A D | cpuinfo-ppc.c | 64 * always have both anyway, since VSX came with Power7 in cpuinfo_init()
65 * and crypto came with Power8. in cpuinfo_init()
|
| /openbmc/qemu/bsd-user/i386/ |
| H A D | target_arch_signal.h | 58 #define _MC_FPOWNED_FPU 0x20001 /* FP state came from FPU */
59 #define _MC_FPOWNED_PCB 0x20002 /* FP state came from PCB */
|
| /openbmc/qemu/bsd-user/x86_64/ |
| H A D | target_arch_signal.h | 68 #define _MC_FPOWNED_FPU 0x20001 /* FP state came from FPU */
69 #define _MC_FPOWNED_PCB 0x20002 /* FP state came from PCB */
|
| /openbmc/qemu/include/user/ |
| H A D | safe-syscall.h | 104 * (1) signal came in just before we took the host syscall (a race);
109 * (2) signal came in while the host syscall was blocking, and the
114 * The other situation to consider is when a signal came in while the
|
| /openbmc/u-boot/lib/libfdt/ |
| H A D | README | 2 source came from the Git repository:
|
| /openbmc/qemu/tests/tcg/multiarch/gdbstub/ |
| H A D | sha1.py | 23 # hopefully we came back
|
| H A D | memory.py | 37 # hopefully we came back
|
| /openbmc/u-boot/net/ |
| H A D | checksum.c | 44 * byte-swap the sum if it came from an odd offset; since the in add_ip_checksums()
|
| /openbmc/openbmc/poky/meta/files/common-licenses/ |
| H A D | DSSSL | 6 The original inspiration for these stylesheets came from the
|
| H A D | Vim | 30 …e this license for previous Vim releases instead of the license that they came with, at your optio…
|
| /openbmc/u-boot/doc/ |
| H A D | README.arm-caches | 51 2. invalidate_dcache_all() - invalid any entry that came to the cache
|
| /openbmc/phosphor-dbus-interfaces/yaml/xyz/openbmc_project/State/ |
| H A D | BMC.interface.yaml | 24 The last time at which the BMC came out of a reboot as determined by
|
| /openbmc/openbmc/meta-fii/meta-kudo/recipes-kudo/kudo-sys-utility/kudo-boot/ |
| H A D | init_once.sh | 44 set_gpio_ctrl HPM_STBY_RST_N 1 # on DVT this became HPM_STBY_RST_N (EVT1 came from CPLD)
|
| /openbmc/u-boot/doc/device-tree-bindings/gpio/ |
| H A D | gpio-pcf857x.txt | 8 low/high value, without knowing the last value written since the chip came out
|
| /openbmc/u-boot/arch/x86/dts/ |
| H A D | edison.dts | 117 * Initial configuration came from the firmware.
|
| /openbmc/witherspoon-pfault-analysis/power-sequencer/ |
| H A D | pgood_monitor.cpp | 107 // If PGOOD came up before we got here, we're done. in run()
|
| /openbmc/phosphor-power/power-sequencer/ |
| H A D | pgood_monitor.cpp | 106 // If PGOOD came up before we got here, we're done. in run()
|
| /openbmc/u-boot/board/logicpd/imx6/ |
| H A D | README | 10 On the intial release, the SOM came with either an i.MX6D or i.MX6Q.
|
| /openbmc/openbmc/meta-google/recipes-google/networking/gbmc-bridge/ |
| H A D | gbmc-br-dhcp-term.sh | 38 # case networking just came up
|
| /openbmc/openbmc/meta-openembedded/meta-gnome/recipes-gnome/gvfs/ |
| H A D | gvfs_1.57.2.bb | 81 # libexec ar missing executable permission flag. Not sure but it came up
|
| /openbmc/entity-manager/scripts/ |
| H A D | autojson.py | 20 # - Comments will get inserted back into the file in the line they came
|
| /openbmc/u-boot/arch/arm/mach-rockchip/ |
| H A D | spl-boot-order.c | 85 * stage, we need a SoC- or board-specific way to handshake with what 'came
|
| /openbmc/u-boot/drivers/gpio/ |
| H A D | pcf8575_gpio.c | 40 * came out of reset (if any). We can't read the latched output.
|
| /openbmc/phosphor-pid-control/dbus/ |
| H A D | dbuspassive.cpp | 232 // If a reading has came in, in getFailed()
245 // If a reading has came in, and it is not a bad reading, in getFailed()
|
| /openbmc/openbmc/poky/meta/recipes-devtools/python/python3/ |
| H A D | get_module_deps3.py | 86 # Check where each dependency came from
|