Searched full:wilink (Results 1 – 13 of 13) sorted by relevance
/openbmc/linux/drivers/net/wireless/ti/wl1251/ |
H A D | acx.h | 53 * The WiLink firmware version, an ASCII string x.x.x.x, 69 * This 4 byte field specifies the WiLink hardware version. 71 * bits 16 - 23: Version ID - The WiLink version ID 73 * bits 24 - 31: Chip ID - The WiLink chip ID. 198 * 10 SSID Filter Enable - When set, the WiLink discards all beacon, 202 * When clear, the WiLink receives frames with any SSID. 203 * 9 Broadcast Filter Enable - When set, the WiLink discards all 204 * broadcast frames. When clear, the WiLink receives all received 207 * 5 BSSID Filter Enable - When set, the WiLink discards any frames 210 * When clear, the WiLink receives frames from any BSSID. [all …]
|
H A D | cmd.h | 123 * The host issues this command to read the WiLink device memory/registers. 131 * The host issues this command to write the WiLink device memory/registers. 144 /* The amount of data in bytes to read from or write to the WiLink 148 /* The actual value read from or written to the Wilink. The source 149 of this field is the Host in WRITE command or the Wilink in READ
|
H A D | reg.h | 584 Interrupt Trigger Register (Host -> WiLink)
|
/openbmc/linux/Documentation/devicetree/bindings/net/ |
H A D | ti,bluetooth.yaml | 18 * TI WiLink 7/8 (wl12xx/wl18xx) Shared Transport BT/FM/GPS devices 20 TI WiLink devices have a UART interface for providing Bluetooth, FM radio, 24 TI WiLink devices also have a separate WiFi interface as described in
|
/openbmc/linux/drivers/net/wireless/ti/wl18xx/ |
H A D | Kconfig | 8 WiLink 8 chipsets.
|
/openbmc/linux/drivers/net/wireless/ti/wl12xx/ |
H A D | wl12xx.h | 13 /* WiLink 6/7 chip IDs */
|
/openbmc/linux/Documentation/devicetree/bindings/net/wireless/ |
H A D | ti,wlcore.yaml | 7 title: Texas Instruments Wilink 6/7/8 (wl12xx/wl18xx) Wireless LAN Controller
|
/openbmc/linux/drivers/net/wireless/ti/wlcore/ |
H A D | acx.h | 19 Host Interrupt Register (WiLink -> Host) 389 * When set, the WiLink transmits the frames with a short preamble and 390 * when cleared, the WiLink transmits the frames with a long preamble.
|
H A D | sdio.c | 391 dev_err(dev, "no wilink module was probed\n"); in wl1271_suspend()
|
H A D | wlcore.h | 592 Interrupt Trigger Register (Host -> WiLink)
|
H A D | spi.c | 170 * by the wilink family in order to successfully enter WSPI mode. in wl12xx_spi_init()
|
/openbmc/linux/include/linux/ |
H A D | ti_wilink_st.h | 18 * enum proto-type - The protocol on WiLink chips which share a
|
/openbmc/linux/ |
H A D | MAINTAINERS | 21712 TI WILINK WIRELESS DRIVERS
|