Home
last modified time | relevance | path

Searched full:sdo (Results 1 – 25 of 55) sorted by relevance

123

/openbmc/linux/include/linux/platform_data/
H A Dad5449.h14 * enum ad5449_sdo_mode - AD5449 SDO pin configuration
15 * @AD5449_SDO_DRIVE_FULL: Drive the SDO pin with full strength.
16 * @AD5449_SDO_DRIVE_WEAK: Drive the SDO pin with not full strength.
17 * @AD5449_SDO_OPEN_DRAIN: Operate the SDO pin in open-drain mode.
18 * @AD5449_SDO_DISABLED: Disable the SDO pin, in this mode it is not possible to
30 * @sdo_mode: SDO pin mode
/openbmc/linux/drivers/iio/chemical/
H A Dbme680_i2c.c8 * - 0x76 if SDO is pulled to GND
9 * - 0x77 if SDO is pulled to VDDIO
11 * Note: SDO pin cannot be left floating otherwise I2C address
/openbmc/linux/Documentation/devicetree/bindings/iio/dac/
H A Dadi,ad3552r.yaml49 adi,sdo-drive-strength:
52 - 0: low SDO drive strength.
53 - 1: medium low SDO drive strength.
54 - 2: medium high SDO drive strength.
55 - 3: high SDO drive strength
/openbmc/linux/sound/pci/hda/
H A Dhda_tegra.c67 * Tegra194 does not reflect correct number of SDO lines. Below macro
291 * Tegra194 has 4 SDO lines and the STRIPE can be used to in hda_tegra_first_init()
292 * indicate how many of the SDO lines the stream should be in hda_tegra_first_init()
297 * 0 for 1 SDO, 1 for 2 SDO, 2 for 4 SDO lines. in hda_tegra_first_init()
302 dev_info(card->dev, "Override SDO lines to %u\n", in hda_tegra_first_init()
360 * 4 SDO lines due to legacy design limitation. Following in hda_tegra_first_init()
362 * control striping of the stream across multiple SDO lines in hda_tegra_first_init()
368 * ratio must be greater than 8. Since number of SDO lines is in hda_tegra_first_init()
/openbmc/linux/drivers/comedi/drivers/
H A Dadv_pci_dio.c104 struct diosubd_data sdo[PCI_DIO_MAX_DO_SUBDEVS]; member
119 .sdo[0] = { 16, 0x02, }, /* DO 0-15 */
120 .sdo[1] = { 16, 0x00, }, /* ISO DO 0-15 */
136 .sdo[1] = { 32, 0x00, }, /* ISO DO 0-31 */
143 .sdo[0] = { 32, 0x00, }, /* DO 0-31 */
151 .sdo[1] = { 16, 0x00, }, /* ISO DO 0-15 */
164 .sdo[1] = { 16, 0x00, }, /* ISO DO 0-15 */
175 .sdo[0] = { 32, 0x00, }, /* DO 0-31 */
176 .sdo[1] = { 32, 0x04, }, /* DO 32-63 */
203 .sdo[1] = { 32, 0x04, }, /* DO 0-31 */
[all …]
/openbmc/linux/drivers/iio/imu/bmi160/
H A Dbmi160_i2c.c8 * - 0x68 if SDO is pulled to GND
9 * - 0x69 if SDO is pulled to VDDIO
/openbmc/linux/Documentation/devicetree/bindings/pinctrl/
H A Dmarvell,armada-370-pinctrl.txt22 mpp6 6 gpio, ge0(txd0), sata0(prsnt), tdm(rst), audio(sdo)
67 mpp46 46 gpo, dev(ad7), audio(sdo)
85 audio(sdo)
H A Dmarvell,kirkwood-pinctrl.txt52 mpp40 40 gpio, audio(sdo)
138 mpp24 24 gpio, ge1(rxd0), ts(mp4), tdm(spi-cs0), audio(sdo)
187 mpp24 24 gpio, ge1(rxd0), ts(mp4), tdm(spi-cs0), audio(sdo)
203 mpp40 40 gpio, ts(mp4), tdm(spi-sck), audio(sdo)
251 mpp24 24 gpio, ge1(rxd0), ts(mp4), tdm(spi-cs0), audio(sdo),
273 mpp40 40 gpio, ts(mp4), tdm(spi-sck), audio(sdo), lcd(d20)
H A Dmarvell,armada-375-pinctrl.txt27 mpp11 11 gpio, dev(a0), led(c2), audio(sdo)
H A Dmarvell,armada-38x-pinctrl.txt69 mpp51 51 gpio, tdm(dtx), audio(sdo), dram(deccerr), ptp(trig)
H A Dmarvell,armada-39x-pinctrl.txt73 mpp51 51 gpio, tdm(dtx) [2], audio(sdo) [2], dram(deccerr), ua2(txd)
/openbmc/linux/sound/soc/codecs/
H A Dsma1303.c869 SND_SOC_DAPM_INPUT("SDO"),
880 SND_SOC_DAPM_SWITCH_E("SDO Enable", SND_SOC_NOPM, 0, 0,
906 {"SDO Enable", "Switch", "AIF IN"},
907 {"AIF OUT Source", "Disable", "SDO Enable"},
908 {"AIF OUT Source", "After_FmtC", "SDO Enable"},
909 {"AIF OUT Source", "After_Mixer", "SDO Enable"},
910 {"AIF OUT Source", "After_DSP", "SDO Enable"},
911 {"AIF OUT Source", "After_Post", "SDO Enable"},
912 {"AIF OUT Source", "Clk_PLL", "SDO Enable"},
913 {"AIF OUT Source", "Clk_OSC", "SDO Enable"},
/openbmc/u-boot/include/dt-bindings/pinctrl/
H A Dpads-imx8qxp.h33 … 24 /* CONN.USDHC1.VSELECT, CONN.NAND.RE_P, ADMA.SPI2.SDO, CONN.NAND.RE_B, LS…
79 #define SC_P_SPI3_SDO 70 /* ADMA.SPI3.SDO, ADMA.LCDIF.D14, LSIO.GPIO0.IO…
85 … 76 /* ADMA.ACM.MCLK_OUT0, ADMA.ESAI0.TX_HF_CLK, ADMA.LCDIF.CLK, ADMA.SPI2.SDO, LSIO.GPIO0.IO20 */
91 #define SC_P_SAI0_TXD 82 /* ADMA.SAI0.TXD, ADMA.SAI1.RXC, ADMA.SPI1.SDO,…
99 #define SC_P_SPI2_SDO 90 /* ADMA.SPI2.SDO, LSIO.GPIO1.IO01 */
104 #define SC_P_SPI0_SDO 95 /* ADMA.SPI0.SDO, ADMA.SAI0.TXFS, M40.I2C0.SDA,…
156 … 147 /* CI_PI.MCLK, MIPI_CSI0.I2C0.SDA, ADMA.SPI1.SDO, LSIO.GPIO3.IO01 */
/openbmc/linux/drivers/iio/accel/
H A Dbma400_i2c.c7 * I2C address is either 0x14 or 0x15 depending on SDO
/openbmc/linux/drivers/pinctrl/mvebu/
H A Dpinctrl-armada-370.c49 MPP_FUNCTION(0x5, "audio", "sdo")),
243 MPP_FUNCTION(0x2, "audio", "sdo")),
314 MPP_FUNCTION(0x5, "audio", "sdo")),
/openbmc/linux/Documentation/devicetree/bindings/iio/imu/
H A Dst,lsm6dsx.yaml85 connected through a pull-up with other chip lines (e.g. SDO/SA0).
/openbmc/linux/drivers/pinctrl/berlin/
H A Dberlin-bg2.c38 BERLIN_PINCTRL_FUNCTION(0x0, "spi1"), /* CLK/SDI/SDO */
188 BERLIN_PINCTRL_FUNCTION(0x1, "spi2"), /* CLK/SDO */
H A Dberlin-bg2q.c60 BERLIN_PINCTRL_FUNCTION(0x0, "spi1"), /* CLK/SDI/SDO */
314 BERLIN_PINCTRL_FUNCTION(0x1, "spi2"), /* CLK/SDO */
H A Dberlin-bg2cd.c79 BERLIN_PINCTRL_FUNCTION(0x0, "spi1"), /* SDI/SDO */
/openbmc/linux/drivers/staging/fbtft/
H A Dfb_hx8357d.c37 /* setRGB which also enables SDO */ in init_display()
/openbmc/u-boot/drivers/video/
H A Dssd2828.h30 * Moreover, the 'sdo' pin may be even not wired up in some devices.
/openbmc/u-boot/drivers/spi/
H A Dmscc_bb_spi.c52 ICPU_SW_MODE_SW_SPI_SDO_OE); /* SDO OE */ in mscc_bb_spi_cs_activate()
/openbmc/linux/sound/hda/
H A Dhdac_stream.c79 /* stripe value: 0 for 1SDO, 1 for 2SDO, 2 for 4SDO lines */ in snd_hdac_get_stream_stripe_ctl()
/openbmc/linux/drivers/gpu/drm/tiny/
H A Dhx8357d.c71 /* setRGB which also enables SDO */ in yx240qv29_enable()
/openbmc/linux/arch/arm/mach-omap1/
H A Ddevices.c249 * are normally used) and SCLK/SDI/SDO (each has two choices). in omap_init_uwire()

123