Searched full:rtd3 (Results 1 – 12 of 12) sorted by relevance
49 - 3 # Remote Temperature Sensor or Voltage Sensor 3 ("RTD3")67 # For channels RTD1, RTD2 and RTD3, require sensor-type to be set.140 channel@3 { /* RTD3 */
232 /* This will read the BIOS WWAN RTD3 settings:306 /* Read WWAN RTD3 BIOS Setting in ipc_pcie_probe()
62 * @d3l2_support: Read WWAN RTD3 BIOS setting for D3L2 support
75 * @rpm: Does the controller support runtime PM (RTD3)79 * @veto: Is RTD3 veto in effect91 * @rtd3_veto: Handle RTD3 veto notification ICM message1637 /* Ice Lake always supports RTD3 */ in icm_icl_driver_ready()1668 tb_dbg(tb, "ICM rtd3 veto=0x%08x\n", pkg->veto_reason); in icm_icl_rtd3_veto()2091 * If RTD3 was vetoed before we entered system suspend allow it in icm_complete()2092 * again now before driver ready is sent. Firmware sends a new RTD3 in icm_complete()
1901 * in "redrive" mode. For this to work we cannot enter RTD3 so in tb_enter_redrive()
305 channel@3 { /* RTD3 */
252 channel@3 { /* RTD3 */
622 * @shutdown_latency: NVMe device's RTD3 Entry Latency1226 * which is equal that NVMe drive's RTD3 Entry Latency1227 * which has reported maximum RTD3 Entry Latency value
1216 * Update ioc->max_shutdown_latency to that NVMe drives RTD3 Entry Latency1282 * This device's RTD3 Entry Latency matches IOC's in _scsih_pcie_device_remove()1325 * This device's RTD3 Entry Latency matches IOC's in _scsih_pcie_device_remove_by_handle()8218 * Set IOC's max_shutdown_latency to drive's RTD3 Entry Latency in _scsih_pcie_add_device()8219 * if drive's RTD3 Entry Latency is greater then IOC's in _scsih_pcie_add_device()
402 /* XXX: figure out what to do about RTD3R/RTD3 */ in nvmet_execute_identify_ctrl()
1117 /* RTD3 only supports thermistor mode */ in nct7802_get_channel_config()
1403 "It's an RTD3 Ssid match event!\n"); in _rtl8821ae_get_wakeup_reason()