Home
last modified time | relevance | path

Searched full:en2 (Results 1 – 14 of 14) sorted by relevance

/openbmc/linux/Documentation/devicetree/bindings/net/nfc/
H A Dti,trf7970a.yaml27 en2-rf-quirk:
30 Specify that the trf7970a being used has the "EN2 RF" erratum
47 One or two GPIO entries used for 'EN' and 'EN2' pins on the TRF7970A. EN2
96 en2-rf-quirk;
/openbmc/u-boot/board/micronas/vct/
H A Ddcgu.c18 union dcgu_clk_en2 en2; in dcgu_set_clk_switch() local
34 en2.reg = reg_read(DCGU_CLK_EN2(DCGU_BASE)); in dcgu_set_clk_switch()
73 en2.bits.en_clkcpu = enable; in dcgu_set_clk_switch()
119 reg_write(DCGU_CLK_EN2(DCGU_BASE), en2.reg); in dcgu_set_clk_switch()
120 en2.reg = reg_read(DCGU_CLK_EN2(DCGU_BASE)); in dcgu_set_clk_switch()
/openbmc/qemu/net/
H A Dvmnet-bridged.m53 /* build list of strings like "en0 en1 en2 " */
/openbmc/linux/drivers/nfc/
H A Dtrf7970a.c32 * The trf7970a is very timing sensitive and the VIN, EN2, and EN
36 * version of the trf7970a that requires that EN2 remain low no matter
39 * when EN2 is left low. The 'en2-rf-quirk' device tree property
41 * that EN2 must be kept low.
2033 dev_info(trf->dev, "No EN2 GPIO property\n"); in trf7970a_probe()
2035 dev_err(trf->dev, "Error getting EN2 GPIO property: %ld\n", in trf7970a_probe()
2038 } else if (of_property_read_bool(np, "en2-rf-quirk")) { in trf7970a_probe()
/openbmc/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6dl-prtrvt.dts72 en2-rf-quirk;
/openbmc/linux/Documentation/devicetree/bindings/mfd/
H A Dmax77620.txt42 register to have a hardware enable source (EN1 or EN2) or a software enable
H A Dtps65910.txt71 control through external inputs [0 (not enabled), 1 (EN1), 2 (EN2) or 4(EN3)]
/openbmc/linux/arch/mips/include/asm/octeon/
H A Dcvmx-lmcx-defs.h2132 uint64_t en2:1; member
2134 uint64_t en2:1;
2164 uint64_t en2:1; member
2166 uint64_t en2:1;
2194 uint64_t en2:1; member
2196 uint64_t en2:1;
/openbmc/linux/drivers/regulator/
H A Dtps65910-regulator.c830 * Regulator can not be control from multiple external input EN1, EN2 in tps65910_set_ext_sleep_config()
865 /* External EN2 control */ in tps65910_set_ext_sleep_config()
874 "Error in configuring external control EN2\n"); in tps65910_set_ext_sleep_config()
/openbmc/linux/drivers/mtd/maps/
H A Desb2rom.c38 /* This became a 16-bit register, and EN2 has disappeared */
/openbmc/linux/arch/arm64/boot/dts/qcom/
H A Dsa8155p-adp.dts547 usb2phy_ac_en2_default: usb2phy-ac-en2-default-state {
/openbmc/linux/include/linux/mfd/
H A Dtps65910.h845 /* External sleep controls through EN1/EN2/EN3/SLEEP inputs */
/openbmc/linux/arch/arm/boot/dts/nvidia/
H A Dtegra124-apalis-v1.2.dtsi411 usb-vbus-en2-pff1 { /* D7 GPIO */
H A Dtegra124-apalis.dtsi408 usb-vbus-en2-pff1 { /* D7 GPIO */