/openbmc/openpower-hw-diags/test/ |
H A D | test-tod-step-check-fault.cpp | 32 // TOD_PSS_MSS_STATUS[0:2] = 0b000 primary config is active in TEST() 39 // TOD_ERROR[21] = 0b1 step check on primary config slave select 1 in TEST() 42 // TOD_PSS_MSS_STATUS[0:2] = 0b000 primary config is active in TEST() 55 // TOD_ERROR(0)[21] step check error on slave select 1 in TEST() 56 libhei::Signature sig2{chip1, nodeId, 0, 21, libhei::ATTN_TYPE_CHIP_CS}; in TEST()
|
/openbmc/linux/Documentation/devicetree/bindings/clock/ |
H A D | imx1-clock.yaml | 38 clock-controller@21b000 {
|
/openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
H A D | imx1.dtsi | 199 clks: ccm@21b000 { 205 iomuxc: iomuxc@21c000 { 212 gpio1: gpio@21c000 { 222 gpio2: gpio@21c100 { 232 gpio3: gpio@21c200 { 242 gpio4: gpio@21c300 {
|
H A D | imx27.dtsi | 158 interrupts = <21>; 180 uart2: serial@1000b000 { 404 uart5: serial@1001b000 { 550 fec: ethernet@1002b000 {
|
/openbmc/linux/drivers/crypto/intel/qat/qat_common/ |
H A D | icp_qat_fw_comp.h | 180 #define ICP_QAT_FW_COMP_CNV_ERROR_BITPOS 21 182 #define ICP_QAT_FW_COMP_CNV_ERROR_NONE 0b000
|
/openbmc/linux/arch/arm/boot/dts/hisilicon/ |
H A D | hi3620.dtsi | 187 interrupts = <0 21 4>; 294 gpio5: gpio@80b000 { 330 gpio-ranges = < &pmx0 0 19 1 &pmx0 1 20 1 &pmx0 2 21 1 531 gpio21: gpio@81b000 {
|
/openbmc/linux/arch/arm/boot/dts/nxp/vf/ |
H A D | vfxxx.dtsi | 221 dmas = <&edma0 0 20>, <&edma0 0 21>; 272 adc0: adc@4003b000 { 340 gpio2: gpio@4004b000 { 435 clks: ccm@4006b000 {
|
/openbmc/linux/Documentation/powerpc/ |
H A D | transactional_memory.rst | 213 Date: Wed Mar 21 21:32:01 2018 +1100 269 if (MSR 29:31 ¬ = 0b010 | SRR1 29:31 ¬ = 0b000) then
|
/openbmc/linux/arch/powerpc/boot/dts/ |
H A D | mpc8379_rdb.dts | 371 sata@1b000 { 404 /* IRQ5 = 21 = 0x15, IRQ6 = 0x16, IRQ7 = 23 = 0x17 */ 410 0x7800 0x0 0x0 0x1 &ipic 21 0x8 416 0xE000 0x0 0x0 0x2 &ipic 21 0x8
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | omap3-beagle-xm.dts | 44 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */ 150 etb@5401b000 {
|
H A D | da850.dtsi | 416 power-domains = <&psc1 21>; 519 mmc1: mmc@21b000 { 654 pll1: clock-controller@21a000 { 737 <&pmx_core 21 34 1>, 742 <&pmx_core 26 21 1>,
|
/openbmc/linux/arch/arm/boot/dts/ti/omap/ |
H A D | omap3-beagle-xm.dts | 48 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */ 154 etb@5401b000 {
|
/openbmc/linux/drivers/net/ethernet/intel/ice/ |
H A D | ice_protocol_type.h | 296 /* MDID 21 335 * * b000 - not a VXLAN/Geneve/GRE tunnel 379 ICE_PKT_TUNNEL_MDID = 21,
|
/openbmc/linux/drivers/hwtracing/coresight/ |
H A D | coresight-etm4x.h | 165 #define TRCIDR5_TRACEIDSIZE_MASK GENMASK(21, 16) 222 #define TRCRSCTLRn_PAIRINV BIT(21) 349 CASE_##op((val), TRCRSCTLRn(21)) \ 610 #define ETM_MODE_ISTALL_EN BIT(21) 625 * 0b000 - Trace OS Lock is not implemented. 629 #define ETM_OSLOCK_NI 0b000 637 * Bits[31:21] - ARCHITECT = Always Arm Ltd. 639 * * Bits[27:21] = 0b0111011 649 #define ETM_DEVARCH_ARCHITECT_MASK GENMASK(31, 21) 650 #define ETM_DEVARCH_ARCHITECT_ARM ((0x4 << 28) | (0b0111011 << 21))
|
/openbmc/u-boot/doc/uImage.FIT/ |
H A D | x86-fit-boot.txt | 120 21 .exit.text 00001a80 81677cd8 01677cd8 00678cd8 2**0 122 22 .data..percpu 00007880 8167a000 0167a000 0067b000 2**12
|
/openbmc/linux/arch/arm/boot/dts/arm/ |
H A D | vexpress-v2m.dtsi | 53 <0 21 &gic GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>, 235 v2m_serial2: serial@b000 {
|
H A D | arm-realview-pb1176.dts | 407 pb1176_ssp: spi@1010b000 { 447 interrupts = <0 21 IRQ_TYPE_LEVEL_HIGH>;
|
/openbmc/linux/Documentation/arch/arm/pxa/ |
H A D | mfp.rst | 179 0b000 - fast 1mA 245 * bit 21..22 - Run Mode Pull State
|
/openbmc/linux/arch/arm64/boot/dts/allwinner/ |
H A D | sun50i-a100.dtsi | 138 pio: pinctrl@300b000 { 279 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
|
/openbmc/openpower-hw-diags/analyzer/plugins/ |
H A D | p10-tod-plugins.cpp | 211 // TOD_PSS_MSS_STATUS[0:2] == 0b000 means active topology is primary. in collectTodFaultData() 261 if (errorReg.isBitSet((0 == slavePathSelect) ? 16 : 21)) in collectTodFaultData()
|
/openbmc/linux/arch/arm/boot/dts/st/ |
H A D | stm32mp151.dtsi | 138 <&dmamux1 21 0x400 0x1>, 408 spi2: spi@4000b000 { 422 i2s2: audio-controller@4000b000 { 901 sai2: sai@4400b000 { 1430 <&mdma1 21 0x2 0x12000a0a 0x0 0x0>; 1779 gpioj: gpio@5000b000 {
|
H A D | stm32mp131.dtsi | 122 <&dmamux1 21 0x400 0x1>, 325 i2s2: audio-controller@4000b000 { 336 spi2: spi@4000b000 { 640 sai2: sai@4400b000 {
|
/openbmc/linux/arch/arm/boot/dts/nuvoton/ |
H A D | nuvoton-common-npcm7xx.dtsi | 76 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>; 327 rng: rng@b000 { 507 i2c11: i2c@8b000 {
|
/openbmc/linux/arch/arm/boot/dts/ti/davinci/ |
H A D | da850.dtsi | 462 power-domains = <&psc1 21>; 524 interrupts = <21>, <22>; 564 mmc1: mmc@21b000 { 696 pll1: clock-controller@21a000 { 775 <&pmx_core 21 34 1>, 780 <&pmx_core 26 21 1>,
|
/openbmc/linux/arch/mips/boot/dts/brcm/ |
H A D | bcm7435.dtsi | 287 brcm,gpio-bank-widths = <32 32 32 21>; 408 hif_l2_intc: interrupt-controller@41b000 {
|