1 /* SPDX-License-Identifier: (GPL-2.0 OR MIT) */
2 /*
3  * Siemens System Memory Buffer driver.
4  * Copyright(c) 2022, HiSilicon Limited.
5  */
6 
7 #ifndef _ULTRASOC_SMB_H
8 #define _ULTRASOC_SMB_H
9 
10 #include <linux/miscdevice.h>
11 #include <linux/spinlock.h>
12 
13 /* Offset of SMB global registers */
14 #define SMB_GLB_CFG_REG		0x00
15 #define SMB_GLB_EN_REG		0x04
16 #define SMB_GLB_INT_REG		0x08
17 
18 /* Offset of SMB logical buffer registers */
19 #define SMB_LB_CFG_LO_REG	0x40
20 #define SMB_LB_CFG_HI_REG	0x44
21 #define SMB_LB_INT_CTRL_REG	0x48
22 #define SMB_LB_INT_STS_REG	0x4c
23 #define SMB_LB_RD_ADDR_REG	0x5c
24 #define SMB_LB_WR_ADDR_REG	0x60
25 #define SMB_LB_PURGE_REG	0x64
26 
27 /* Set global config register */
28 #define SMB_GLB_CFG_BURST_LEN_MSK	GENMASK(11, 4)
29 #define SMB_GLB_CFG_IDLE_PRD_MSK	GENMASK(15, 12)
30 #define SMB_GLB_CFG_MEM_WR_MSK		GENMASK(21, 16)
31 #define SMB_GLB_CFG_MEM_RD_MSK		GENMASK(27, 22)
32 #define SMB_GLB_CFG_DEFAULT	(FIELD_PREP(SMB_GLB_CFG_BURST_LEN_MSK, 0xf) | \
33 				 FIELD_PREP(SMB_GLB_CFG_IDLE_PRD_MSK, 0xf) | \
34 				 FIELD_PREP(SMB_GLB_CFG_MEM_WR_MSK, 0x3) | \
35 				 FIELD_PREP(SMB_GLB_CFG_MEM_RD_MSK, 0x1b))
36 
37 #define SMB_GLB_EN_HW_ENABLE	BIT(0)
38 
39 /* Set global interrupt control register */
40 #define SMB_GLB_INT_EN		BIT(0)
41 #define SMB_GLB_INT_PULSE	BIT(1) /* Interrupt type: 1 - Pulse */
42 #define SMB_GLB_INT_ACT_H	BIT(2) /* Interrupt polarity: 1 - Active high */
43 #define SMB_GLB_INT_CFG		(SMB_GLB_INT_EN | SMB_GLB_INT_PULSE | \
44 				 SMB_GLB_INT_ACT_H)
45 
46 /* Set logical buffer config register lower 32 bits */
47 #define SMB_LB_CFG_LO_EN		BIT(0)
48 #define SMB_LB_CFG_LO_SINGLE_END	BIT(1)
49 #define SMB_LB_CFG_LO_INIT		BIT(8)
50 #define SMB_LB_CFG_LO_CONT		BIT(11)
51 #define SMB_LB_CFG_LO_FLOW_MSK		GENMASK(19, 16)
52 #define SMB_LB_CFG_LO_DEFAULT	(SMB_LB_CFG_LO_EN | SMB_LB_CFG_LO_SINGLE_END | \
53 				 SMB_LB_CFG_LO_INIT | SMB_LB_CFG_LO_CONT | \
54 				 FIELD_PREP(SMB_LB_CFG_LO_FLOW_MSK, 0xf))
55 
56 /* Set logical buffer config register upper 32 bits */
57 #define SMB_LB_CFG_HI_RANGE_UP_MSK	GENMASK(15, 8)
58 #define SMB_LB_CFG_HI_DEFAULT	FIELD_PREP(SMB_LB_CFG_HI_RANGE_UP_MSK, 0xff)
59 
60 /*
61  * Set logical buffer interrupt control register.
62  * The register control the validity of both real-time events and
63  * interrupts. When logical buffer status changes causes to issue
64  * an interrupt at the same time as it issues a real-time event.
65  * Real-time events are used in SMB driver, which needs to get the buffer
66  * status. Interrupts are used in debugger mode.
67  * SMB_LB_INT_CTRL_BUF_NOTE_MASK control which events flags or interrupts
68  * are valid.
69  */
70 #define SMB_LB_INT_CTRL_EN		BIT(0)
71 #define SMB_LB_INT_CTRL_BUF_NOTE_MSK	GENMASK(11, 8)
72 #define SMB_LB_INT_CTRL_CFG	(SMB_LB_INT_CTRL_EN | \
73 				 FIELD_PREP(SMB_LB_INT_CTRL_BUF_NOTE_MSK, 0xf))
74 
75 /* Set logical buffer interrupt status register */
76 #define SMB_LB_INT_STS_NOT_EMPTY_MSK	BIT(0)
77 #define SMB_LB_INT_STS_BUF_RESET_MSK	GENMASK(3, 0)
78 #define SMB_LB_INT_STS_RESET	FIELD_PREP(SMB_LB_INT_STS_BUF_RESET_MSK, 0xf)
79 
80 #define SMB_LB_PURGE_PURGED	BIT(0)
81 
82 #define SMB_REG_ADDR_RES	0
83 #define SMB_BUF_ADDR_RES	1
84 #define SMB_BUF_ADDR_LO_MSK	GENMASK(31, 0)
85 
86 /**
87  * struct smb_data_buffer - Details of the buffer used by SMB
88  * @buf_base:	Memory mapped base address of SMB.
89  * @buf_hw_base:	SMB buffer start Physical base address, only used 32bits.
90  * @buf_size:	Size of the buffer.
91  * @data_size:	Size of the available trace data for SMB.
92  * @buf_rdptr:	Current read position (index) within the buffer.
93  */
94 struct smb_data_buffer {
95 	void *buf_base;
96 	u32 buf_hw_base;
97 	unsigned long buf_size;
98 	unsigned long data_size;
99 	unsigned long buf_rdptr;
100 };
101 
102 /**
103  * struct smb_drv_data - specifics associated to an SMB component
104  * @base:	Memory mapped base address for SMB component.
105  * @csdev:	Component vitals needed by the framework.
106  * @sdb:	Data buffer for SMB.
107  * @miscdev:	Specifics to handle "/dev/xyz.smb" entry.
108  * @spinlock:	Control data access to one at a time.
109  * @reading:	Synchronise user space access to SMB buffer.
110  * @pid:	Process ID of the process being monitored by the
111  *		session that is using this component.
112  * @mode:	How this SMB is being used, perf mode or sysfs mode.
113  */
114 struct smb_drv_data {
115 	void __iomem *base;
116 	struct coresight_device	*csdev;
117 	struct smb_data_buffer sdb;
118 	struct miscdevice miscdev;
119 	spinlock_t spinlock;
120 	bool reading;
121 	pid_t pid;
122 	enum cs_mode mode;
123 };
124 
125 #endif
126