1 /* SPDX-License-Identifier: GPL-2.0 */ 2 /* Copyright (c) 2019 - 2022 Beijing WangXun Technology Co., Ltd. */ 3 4 #ifndef _NGBE_TYPE_H_ 5 #define _NGBE_TYPE_H_ 6 7 #include <linux/types.h> 8 #include <linux/netdevice.h> 9 10 /************ NGBE_register.h ************/ 11 /* Device IDs */ 12 #define NGBE_DEV_ID_EM_WX1860AL_W 0x0100 13 #define NGBE_DEV_ID_EM_WX1860A2 0x0101 14 #define NGBE_DEV_ID_EM_WX1860A2S 0x0102 15 #define NGBE_DEV_ID_EM_WX1860A4 0x0103 16 #define NGBE_DEV_ID_EM_WX1860A4S 0x0104 17 #define NGBE_DEV_ID_EM_WX1860AL2 0x0105 18 #define NGBE_DEV_ID_EM_WX1860AL2S 0x0106 19 #define NGBE_DEV_ID_EM_WX1860AL4 0x0107 20 #define NGBE_DEV_ID_EM_WX1860AL4S 0x0108 21 #define NGBE_DEV_ID_EM_WX1860LC 0x0109 22 #define NGBE_DEV_ID_EM_WX1860A1 0x010a 23 #define NGBE_DEV_ID_EM_WX1860A1L 0x010b 24 25 /* Subsystem ID */ 26 #define NGBE_SUBID_M88E1512_SFP 0x0003 27 #define NGBE_SUBID_OCP_CARD 0x0040 28 #define NGBE_SUBID_LY_M88E1512_SFP 0x0050 29 #define NGBE_SUBID_M88E1512_RJ45 0x0051 30 #define NGBE_SUBID_M88E1512_MIX 0x0052 31 #define NGBE_SUBID_YT8521S_SFP 0x0060 32 #define NGBE_SUBID_INTERNAL_YT8521S_SFP 0x0061 33 #define NGBE_SUBID_YT8521S_SFP_GPIO 0x0062 34 #define NGBE_SUBID_INTERNAL_YT8521S_SFP_GPIO 0x0064 35 #define NGBE_SUBID_LY_YT8521S_SFP 0x0070 36 #define NGBE_SUBID_RGMII_FPGA 0x0080 37 38 #define NGBE_OEM_MASK 0x00FF 39 40 #define NGBE_NCSI_SUP 0x8000 41 #define NGBE_NCSI_MASK 0x8000 42 #define NGBE_WOL_SUP 0x4000 43 #define NGBE_WOL_MASK 0x4000 44 45 /**************** EM Registers ****************************/ 46 /* chip control Registers */ 47 #define NGBE_MIS_PRB_CTL 0x10010 48 /* FMGR Registers */ 49 #define NGBE_SPI_ILDR_STATUS 0x10120 50 #define NGBE_SPI_ILDR_STATUS_PERST BIT(0) /* PCIE_PERST is done */ 51 #define NGBE_SPI_ILDR_STATUS_PWRRST BIT(1) /* Power on reset is done */ 52 53 /* Checksum and EEPROM pointers */ 54 #define NGBE_CALSUM_COMMAND 0xE9 55 #define NGBE_CALSUM_CAP_STATUS 0x10224 56 #define NGBE_EEPROM_VERSION_STORE_REG 0x1022C 57 #define NGBE_SAN_MAC_ADDR_PTR 0x18 58 #define NGBE_DEVICE_CAPS 0x1C 59 #define NGBE_EEPROM_VERSION_L 0x1D 60 #define NGBE_EEPROM_VERSION_H 0x1E 61 62 /* Media-dependent registers. */ 63 #define NGBE_MDIO_CLAUSE_SELECT 0x11220 64 65 /* GPIO Registers */ 66 #define NGBE_GPIO_DR 0x14800 67 #define NGBE_GPIO_DDR 0x14804 68 /*GPIO bit */ 69 #define NGBE_GPIO_DR_0 BIT(0) /* SDP0 Data Value */ 70 #define NGBE_GPIO_DR_1 BIT(1) /* SDP1 Data Value */ 71 #define NGBE_GPIO_DDR_0 BIT(0) /* SDP0 IO direction */ 72 #define NGBE_GPIO_DDR_1 BIT(1) /* SDP1 IO direction */ 73 74 /* Extended Interrupt Enable Set */ 75 #define NGBE_PX_MISC_IEN_DEV_RST BIT(10) 76 #define NGBE_PX_MISC_IEN_ETH_LK BIT(18) 77 #define NGBE_PX_MISC_IEN_INT_ERR BIT(20) 78 #define NGBE_PX_MISC_IEN_GPIO BIT(26) 79 #define NGBE_PX_MISC_IEN_MASK ( \ 80 NGBE_PX_MISC_IEN_DEV_RST | \ 81 NGBE_PX_MISC_IEN_ETH_LK | \ 82 NGBE_PX_MISC_IEN_INT_ERR | \ 83 NGBE_PX_MISC_IEN_GPIO) 84 85 #define NGBE_INTR_ALL 0x1FF 86 #define NGBE_INTR_MISC(A) BIT((A)->num_q_vectors) 87 88 #define NGBE_PHY_CONFIG(reg_offset) (0x14000 + ((reg_offset) * 4)) 89 #define NGBE_CFG_LAN_SPEED 0x14440 90 #define NGBE_CFG_PORT_ST 0x14404 91 92 /* Wake up registers */ 93 #define NGBE_PSR_WKUP_CTL 0x15B80 94 /* Wake Up Filter Control Bit */ 95 #define NGBE_PSR_WKUP_CTL_LNKC BIT(0) /* Link Status Change Wakeup Enable*/ 96 #define NGBE_PSR_WKUP_CTL_MAG BIT(1) /* Magic Packet Wakeup Enable */ 97 #define NGBE_PSR_WKUP_CTL_EX BIT(2) /* Directed Exact Wakeup Enable */ 98 #define NGBE_PSR_WKUP_CTL_MC BIT(3) /* Directed Multicast Wakeup Enable*/ 99 #define NGBE_PSR_WKUP_CTL_BC BIT(4) /* Broadcast Wakeup Enable */ 100 #define NGBE_PSR_WKUP_CTL_ARP BIT(5) /* ARP Request Packet Wakeup Enable*/ 101 #define NGBE_PSR_WKUP_CTL_IPV4 BIT(6) /* Directed IPv4 Pkt Wakeup Enable */ 102 #define NGBE_PSR_WKUP_CTL_IPV6 BIT(7) /* Directed IPv6 Pkt Wakeup Enable */ 103 104 #define NGBE_FW_EEPROM_CHECKSUM_CMD 0xE9 105 #define NGBE_FW_NVM_DATA_OFFSET 3 106 #define NGBE_FW_CMD_DEFAULT_CHECKSUM 0xFF /* checksum always 0xFF */ 107 #define NGBE_FW_CMD_ST_PASS 0x80658383 108 #define NGBE_FW_CMD_ST_FAIL 0x70657376 109 110 #define NGBE_MAX_FDIR_INDICES 7 111 112 #define NGBE_MAX_RX_QUEUES (NGBE_MAX_FDIR_INDICES + 1) 113 #define NGBE_MAX_TX_QUEUES (NGBE_MAX_FDIR_INDICES + 1) 114 115 #define NGBE_ETH_LENGTH_OF_ADDRESS 6 116 #define NGBE_MAX_MSIX_VECTORS 0x09 117 #define NGBE_RAR_ENTRIES 32 118 #define NGBE_RX_PB_SIZE 42 119 #define NGBE_MC_TBL_SIZE 128 120 #define NGBE_SP_VFT_TBL_SIZE 128 121 #define NGBE_TDB_PB_SZ (20 * 1024) /* 160KB Packet Buffer */ 122 123 /* TX/RX descriptor defines */ 124 #define NGBE_DEFAULT_TXD 512 /* default ring size */ 125 #define NGBE_DEFAULT_TX_WORK 256 126 #define NGBE_MAX_TXD 8192 127 #define NGBE_MIN_TXD 128 128 129 #define NGBE_DEFAULT_RXD 512 /* default ring size */ 130 #define NGBE_DEFAULT_RX_WORK 256 131 #define NGBE_MAX_RXD 8192 132 #define NGBE_MIN_RXD 128 133 134 extern char ngbe_driver_name[]; 135 136 #endif /* _NGBE_TYPE_H_ */ 137