xref: /openbmc/linux/arch/sh/include/asm/sh7760fb.h (revision b2441318)
1 /* SPDX-License-Identifier: GPL-2.0 */
2 /*
3  * sh7760fb.h -- platform data for SH7760/SH7763 LCDC framebuffer driver.
4  *
5  * (c) 2006-2008 MSC Vertriebsges.m.b.H.,
6  * 			Manuel Lauss <mano@roarinelk.homelinux.net>
7  * (c) 2008 Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>
8  */
9 
10 #ifndef _ASM_SH_SH7760FB_H
11 #define _ASM_SH_SH7760FB_H
12 
13 /*
14  * some bits of the colormap registers should be written as zero.
15  * create a mask for that.
16  */
17 #define SH7760FB_PALETTE_MASK 0x00f8fcf8
18 
19 /* The LCDC dma engine always sets bits 27-26 to 1: this is Area3 */
20 #define SH7760FB_DMA_MASK 0x0C000000
21 
22 /* palette */
23 #define LDPR(x) (((x) << 2))
24 
25 /* framebuffer registers and bits */
26 #define LDICKR 0x400
27 #define LDMTR 0x402
28 /* see sh7760fb.h for LDMTR bits */
29 #define LDDFR 0x404
30 #define LDDFR_PABD (1 << 8)
31 #define LDDFR_COLOR_MASK 0x7F
32 #define LDSMR 0x406
33 #define LDSMR_ROT (1 << 13)
34 #define LDSARU 0x408
35 #define LDSARL 0x40c
36 #define LDLAOR 0x410
37 #define LDPALCR 0x412
38 #define LDPALCR_PALS (1 << 4)
39 #define LDPALCR_PALEN (1 << 0)
40 #define LDHCNR 0x414
41 #define LDHSYNR 0x416
42 #define LDVDLNR 0x418
43 #define LDVTLNR 0x41a
44 #define LDVSYNR 0x41c
45 #define LDACLNR 0x41e
46 #define LDINTR 0x420
47 #define LDPMMR 0x424
48 #define LDPSPR 0x426
49 #define LDCNTR 0x428
50 #define LDCNTR_DON (1 << 0)
51 #define LDCNTR_DON2 (1 << 4)
52 
53 #ifdef CONFIG_CPU_SUBTYPE_SH7763
54 # define LDLIRNR       0x440
55 /* LDINTR bit */
56 # define LDINTR_MINTEN (1 << 15)
57 # define LDINTR_FINTEN (1 << 14)
58 # define LDINTR_VSINTEN (1 << 13)
59 # define LDINTR_VEINTEN (1 << 12)
60 # define LDINTR_MINTS (1 << 11)
61 # define LDINTR_FINTS (1 << 10)
62 # define LDINTR_VSINTS (1 << 9)
63 # define LDINTR_VEINTS (1 << 8)
64 # define VINT_START (LDINTR_VSINTEN)
65 # define VINT_CHECK (LDINTR_VSINTS)
66 #else
67 /* LDINTR bit */
68 # define LDINTR_VINTSEL (1 << 12)
69 # define LDINTR_VINTE (1 << 8)
70 # define LDINTR_VINTS (1 << 0)
71 # define VINT_START (LDINTR_VINTSEL)
72 # define VINT_CHECK (LDINTR_VINTS)
73 #endif
74 
75 /* HSYNC polarity inversion */
76 #define LDMTR_FLMPOL (1 << 15)
77 
78 /* VSYNC polarity inversion */
79 #define LDMTR_CL1POL (1 << 14)
80 
81 /* DISPLAY-ENABLE polarity inversion */
82 #define LDMTR_DISPEN_LOWACT (1 << 13)
83 
84 /* DISPLAY DATA BUS polarity inversion */
85 #define LDMTR_DPOL_LOWACT (1 << 12)
86 
87 /* AC modulation signal enable */
88 #define LDMTR_MCNT (1 << 10)
89 
90 /* Disable output of HSYNC during VSYNC period */
91 #define LDMTR_CL1CNT (1 << 9)
92 
93 /* Disable output of VSYNC during VSYNC period */
94 #define LDMTR_CL2CNT (1 << 8)
95 
96 /* Display types supported by the LCDC */
97 #define LDMTR_STN_MONO_4       0x00
98 #define LDMTR_STN_MONO_8       0x01
99 #define LDMTR_STN_COLOR_4      0x08
100 #define LDMTR_STN_COLOR_8      0x09
101 #define LDMTR_STN_COLOR_12     0x0A
102 #define LDMTR_STN_COLOR_16     0x0B
103 #define LDMTR_DSTN_MONO_8      0x11
104 #define LDMTR_DSTN_MONO_16     0x13
105 #define LDMTR_DSTN_COLOR_8     0x19
106 #define LDMTR_DSTN_COLOR_12    0x1A
107 #define LDMTR_DSTN_COLOR_16    0x1B
108 #define LDMTR_TFT_COLOR_16     0x2B
109 
110 /* framebuffer color layout */
111 #define LDDFR_1BPP_MONO 0x00
112 #define LDDFR_2BPP_MONO 0x01
113 #define LDDFR_4BPP_MONO 0x02
114 #define LDDFR_6BPP_MONO 0x04
115 #define LDDFR_4BPP 0x0A
116 #define LDDFR_8BPP 0x0C
117 #define LDDFR_16BPP_RGB555 0x1D
118 #define LDDFR_16BPP_RGB565 0x2D
119 
120 /* LCDC Pixclock sources */
121 #define LCDC_CLKSRC_BUSCLOCK 0
122 #define LCDC_CLKSRC_PERIPHERAL 1
123 #define LCDC_CLKSRC_EXTERNAL 2
124 
125 #define LDICKR_CLKSRC(x) \
126        (((x) & 3) << 12)
127 
128 /* LCDC pixclock input divider. Set to 1 at a minimum! */
129 #define LDICKR_CLKDIV(x) \
130        ((x) & 0x1f)
131 
132 struct sh7760fb_platdata {
133 
134 	/* Set this member to a valid fb_videmode for the display you
135 	 * wish to use.  The following members must be initialized:
136 	 * xres, yres, hsync_len, vsync_len, sync,
137 	 * {left,right,upper,lower}_margin.
138 	 * The driver uses the above members to calculate register values
139 	 * and memory requirements. Other members are ignored but may
140 	 * be used by other framebuffer layer components.
141 	 */
142 	struct fb_videomode *def_mode;
143 
144 	/* LDMTR includes display type and signal polarity.  The
145 	 * HSYNC/VSYNC polarities are derived from the fb_var_screeninfo
146 	 * data above; however the polarities of the following signals
147 	 * must be encoded in the ldmtr member:
148 	 * Display Enable signal (default high-active)  DISPEN_LOWACT
149 	 * Display Data signals (default high-active)   DPOL_LOWACT
150 	 * AC Modulation signal (default off)           MCNT
151 	 * Hsync-During-Vsync suppression (default off) CL1CNT
152 	 * Vsync-during-vsync suppression (default off) CL2CNT
153 	 * NOTE: also set a display type!
154 	 * (one of LDMTR_{STN,DSTN,TFT}_{MONO,COLOR}_{4,8,12,16})
155 	 */
156 	u16 ldmtr;
157 
158 	/* LDDFR controls framebuffer image format (depth, organization)
159 	 * Use ONE of the LDDFR_?BPP_* macros!
160 	 */
161 	u16 lddfr;
162 
163 	/* LDPMMR and LDPSPR control the timing of the power signals
164 	 * for the display. Please read the SH7760 Hardware Manual,
165 	 * Chapters 30.3.17, 30.3.18 and 30.4.6!
166 	 */
167 	u16 ldpmmr;
168 	u16 ldpspr;
169 
170 	/* LDACLNR contains the line numbers after which the AC modulation
171 	 * signal is to toggle. Set to ZERO for TFTs or displays which
172 	 * do not need it. (Chapter 30.3.15 in SH7760 Hardware Manual).
173 	 */
174 	u16 ldaclnr;
175 
176 	/* LDICKR contains information on pixelclock source and config.
177 	 * Please use the LDICKR_CLKSRC() and LDICKR_CLKDIV() macros.
178 	 * minimal value for CLKDIV() must be 1!.
179 	 */
180 	u16 ldickr;
181 
182 	/* set this member to 1 if you wish to use the LCDC's hardware
183 	 * rotation function.  This is limited to displays <= 320x200
184 	 * pixels resolution!
185 	 */
186 	int rotate;		/* set to 1 to rotate 90 CCW */
187 
188 	/* set this to 1 to suppress vsync irq use. */
189 	int novsync;
190 
191 	/* blanking hook for platform. Set this if your platform can do
192 	 * more than the LCDC in terms of blanking (e.g. disable clock
193 	 * generator / backlight power supply / etc.
194 	 */
195 	void (*blank) (int);
196 };
197 
198 #endif /* _ASM_SH_SH7760FB_H */
199