if RAM || SPL_RAM

if ASPEED_AST2600
choice
	prompt "DDR4 target data rate"
	default ASPEED_DDR4_1600

config ASPEED_DDR4_400
	bool "DDR4 targets at 400Mbps"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	help
	  select DDR4 target data rate at 400M

config ASPEED_DDR4_800
	bool "DDR4 targets at 800Mbps"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	help
	  select DDR4 target data rate at 800M

config ASPEED_DDR4_1333
	bool "DDR4 targets at 1333Mbps"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	help
	  select DDR4 target data rate at 1333M

config ASPEED_DDR4_1600
	bool "DDR4 targets at 1600Mbps"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	help
	  select DDR4 target data rate at 1600M
endchoice

config ASPEED_DDR4_DUALX8
	bool "dual X8 DDR4 die"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	default n
	help
	  select dual X8 DDR4 die

config ASPEED_BYPASS_SELFTEST
	bool "bypass self test during DRAM initialization"
	default n
	help
	  Say Y here to bypass DRAM self test to speed up the boot time
endif

config ASPEED_ECC
	bool "aspeed SDRAM error correcting code"
	depends on DM && OF_CONTROL && ARCH_ASPEED
	default n
	help
	  enable SDRAM ECC function

if ASPEED_ECC
config ASPEED_ECC_SIZE
	int "ECC size: 0=driver auto-caluated"
	depends on ASPEED_ECC
	default 0
	help
	  SDRAM size with the error correcting code enabled. The unit is 
	  in Megabytes.  Noted that only the 8/9 of the configured size 
	  can be used by the system.  The remaining 1/9 will be used by 
	  the ECC engine.  If the size is set to 0, the sdram driver will 
	  calculate the SDRAM size and set the whole range be ECC enabled.
endif
endif