/* * board/renesas/stout/stout.c * This file is Stout board support. * * Copyright (C) 2015 Renesas Electronics Europe GmbH * Copyright (C) 2015 Renesas Electronics Corporation * Copyright (C) 2015 Cogent Embedded, Inc. * * SPDX-License-Identifier: GPL-2.0 */ #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include #include "qos.h" #include "cpld.h" DECLARE_GLOBAL_DATA_PTR; #define CLK2MHZ(clk) (clk / 1000 / 1000) void s_init(void) { struct rcar_rwdt *rwdt = (struct rcar_rwdt *)RWDT_BASE; struct rcar_swdt *swdt = (struct rcar_swdt *)SWDT_BASE; /* Watchdog init */ writel(0xA5A5A500, &rwdt->rwtcsra); writel(0xA5A5A500, &swdt->swtcsra); /* CPU frequency setting. Set to 1.4GHz */ if (rmobile_get_cpu_rev_integer() >= R8A7790_CUT_ES2X) { u32 stat = 0; u32 stc = ((1400 / CLK2MHZ(CONFIG_SYS_CLK_FREQ)) - 1) << PLL0_STC_BIT; clrsetbits_le32(PLL0CR, PLL0_STC_MASK, stc); do { stat = readl(PLLECR) & PLL0ST; } while (stat == 0x0); } /* QoS(Quality-of-Service) Init */ qos_init(); } #define TMU0_MSTP125 BIT(25) #define SD2CKCR 0xE6150078 #define SD2_97500KHZ 0x7 int board_early_init_f(void) { /* TMU0 */ mstp_clrbits_le32(MSTPSR1, SMSTPCR1, TMU0_MSTP125); /* * SD0 clock is set to 97.5MHz by default. * Set SD2 to the 97.5MHz as well. */ writel(SD2_97500KHZ, SD2CKCR); return 0; } #define ETHERNET_PHY_RESET 123 /* GPIO 3 31 */ int board_init(void) { /* adress of boot parameters */ gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; cpld_init(); /* Force ethernet PHY out of reset */ gpio_request(ETHERNET_PHY_RESET, "phy_reset"); gpio_direction_output(ETHERNET_PHY_RESET, 0); mdelay(20); gpio_direction_output(ETHERNET_PHY_RESET, 1); return 0; } int dram_init(void) { if (fdtdec_setup_memory_size() != 0) return -EINVAL; return 0; } int dram_init_banksize(void) { fdtdec_setup_memory_banksize(); return 0; } /* Stout has KSZ8041NL/RNL */ #define PHY_CONTROL1 0x1E #define PHY_LED_MODE 0xC0000 #define PHY_LED_MODE_ACK 0x4000 int board_phy_config(struct phy_device *phydev) { int ret = phy_read(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1); ret &= ~PHY_LED_MODE; ret |= PHY_LED_MODE_ACK; ret = phy_write(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1, (u16)ret); return 0; } const struct rmobile_sysinfo sysinfo = { CONFIG_ARCH_RMOBILE_BOARD_STRING }; enum env_location env_get_location(enum env_operation op, int prio) { const u32 load_magic = 0xb33fc0de; /* Block environment access if loaded using JTAG */ if ((readl(CONFIG_SPL_TEXT_BASE + 0x24) == load_magic) && (op != ENVOP_INIT)) return ENVL_UNKNOWN; if (prio) return ENVL_UNKNOWN; return ENVL_SPI_FLASH; }