// SPDX-License-Identifier: GPL-2.0-only /* * Copyright (C) 2015 - ARM Ltd * Author: Marc Zyngier */ #include #include #include struct tlb_inv_context { u64 tcr; }; static void __tlb_switch_to_guest(struct kvm_s2_mmu *mmu, struct tlb_inv_context *cxt) { if (cpus_have_final_cap(ARM64_WORKAROUND_SPECULATIVE_AT)) { u64 val; /* * For CPUs that are affected by ARM 1319367, we need to * avoid a host Stage-1 walk while we have the guest's * VMID set in the VTTBR in order to invalidate TLBs. * We're guaranteed that the S1 MMU is enabled, so we can * simply set the EPD bits to avoid any further TLB fill. */ val = cxt->tcr = read_sysreg_el1(SYS_TCR); val |= TCR_EPD1_MASK | TCR_EPD0_MASK; write_sysreg_el1(val, SYS_TCR); isb(); } __load_guest_stage2(mmu); } static void __tlb_switch_to_host(struct tlb_inv_context *cxt) { write_sysreg(0, vttbr_el2); if (cpus_have_final_cap(ARM64_WORKAROUND_SPECULATIVE_AT)) { /* Ensure write of the host VMID */ isb(); /* Restore the host's TCR_EL1 */ write_sysreg_el1(cxt->tcr, SYS_TCR); } } void __kvm_tlb_flush_vmid_ipa(struct kvm_s2_mmu *mmu, phys_addr_t ipa, int level) { struct tlb_inv_context cxt; dsb(ishst); /* Switch to requested VMID */ mmu = kern_hyp_va(mmu); __tlb_switch_to_guest(mmu, &cxt); /* * We could do so much better if we had the VA as well. * Instead, we invalidate Stage-2 for this IPA, and the * whole of Stage-1. Weep... */ ipa >>= 12; __tlbi_level(ipas2e1is, ipa, level); /* * We have to ensure completion of the invalidation at Stage-2, * since a table walk on another CPU could refill a TLB with a * complete (S1 + S2) walk based on the old Stage-2 mapping if * the Stage-1 invalidation happened first. */ dsb(ish); __tlbi(vmalle1is); dsb(ish); isb(); /* * If the host is running at EL1 and we have a VPIPT I-cache, * then we must perform I-cache maintenance at EL2 in order for * it to have an effect on the guest. Since the guest cannot hit * I-cache lines allocated with a different VMID, we don't need * to worry about junk out of guest reset (we nuke the I-cache on * VMID rollover), but we do need to be careful when remapping * executable pages for the same guest. This can happen when KSM * takes a CoW fault on an executable page, copies the page into * a page that was previously mapped in the guest and then needs * to invalidate the guest view of the I-cache for that page * from EL1. To solve this, we invalidate the entire I-cache when * unmapping a page from a guest if we have a VPIPT I-cache but * the host is running at EL1. As above, we could do better if * we had the VA. * * The moral of this story is: if you have a VPIPT I-cache, then * you should be running with VHE enabled. */ if (icache_is_vpipt()) __flush_icache_all(); __tlb_switch_to_host(&cxt); } void __kvm_tlb_flush_vmid(struct kvm_s2_mmu *mmu) { struct tlb_inv_context cxt; dsb(ishst); /* Switch to requested VMID */ mmu = kern_hyp_va(mmu); __tlb_switch_to_guest(mmu, &cxt); __tlbi(vmalls12e1is); dsb(ish); isb(); __tlb_switch_to_host(&cxt); } void __kvm_tlb_flush_local_vmid(struct kvm_s2_mmu *mmu) { struct tlb_inv_context cxt; /* Switch to requested VMID */ mmu = kern_hyp_va(mmu); __tlb_switch_to_guest(mmu, &cxt); __tlbi(vmalle1); dsb(nsh); isb(); __tlb_switch_to_host(&cxt); } void __kvm_flush_vm_context(void) { dsb(ishst); __tlbi(alle1is); /* * VIPT and PIPT caches are not affected by VMID, so no maintenance * is necessary across a VMID rollover. * * VPIPT caches constrain lookup and maintenance to the active VMID, * so we need to invalidate lines with a stale VMID to avoid an ABA * race after multiple rollovers. * */ if (icache_is_vpipt()) asm volatile("ic ialluis"); dsb(ish); }