Lines Matching refs:It
5 be placed in an image one by one to build up a final firmware image. It is
17 Note: This should not be used by itself. It is normally used as a parent
114 It can then read or write just a single area, instead of the whole flash.
313 It is also possible to put the string directly in the node:
382 This is the U-Boot ELF image. It does not include a device tree but can be
393 This is the U-Boot binary as a packaged image, in legacy format. It has a
408 to relocate itself at runtime. It does not include a device tree blob at
422 binary which loads before U-Boot proper, typically into on-chip SRAM. It is
447 the various used by SPL. It is set to 0 by SPL when it starts up. If you
450 This entry is useful in that case. It automatically pads out the entry size
476 This is the U-Boot SPL ELF image. It does not include a device tree but can
488 This is the U-Boot SPL binary, It does not include a device tree blob at
513 binary which loads before SPL, typically into on-chip SRAM. It is
570 the various microcode update nodes in the device tree. It is also unable
590 tree. It is referred to as 'collation' here.
596 It updates it with the address and size of the microcode so that
599 Contains u-boot.dtb. It stores the microcode in a
656 must be placed at a particular address. This entry holds that code. It is
673 must be placed at a particular address. This entry holds that code. It is
690 must be placed at a particular address. This entry holds that code. It is