Lines Matching +full:phy +full:- +full:is +full:- +full:integrated
6 # NOTE: Gadget support ** DOES NOT ** depend on host-side CONFIG_USB !!
8 # - Host systems (like PCs) need CONFIG_USB (with "A" jacks).
9 # - Peripherals (like PDAs) need CONFIG_USB_GADGET (with "B" jacks).
10 # - Some systems have both kinds of controllers.
12 # With help from a special transceiver and a "Mini-AB" jack, systems with
13 # both kinds of controller can also support "USB On-the-Go" (CONFIG_USB_OTG).
19 USB is a master/slave protocol, organized with one master
21 The USB hardware is asymmetric, which makes it easier to set up:
22 you can't connect a "to-the-host" connector to a peripheral.
24 U-Boot can run in the host, or in the peripheral. In both cases
27 or are integrated with the CPU in a microcontroller. The more
29 or "UHCI", and are usually integrated into southbridges on PC
32 Enable this configuration option if you want to run U-Boot inside
43 CDC-ACM (usbtty) for example.
57 default "U-Boot"
60 This is usually either the manufacturer of the device or the SoC.
68 This is usually the board or SoC vendor's, unless you've registered
82 USBA is the integrated high-speed USB Device controller on
86 bool "Broadcom UDC OTG PHY"
94 The Designware USB2.0 high-speed gadget controller
95 integrated into many SoCs. Select this option if you want the
102 bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
104 Set the Designware USB2.0 high-speed OTG controller
105 PHY interface width to 8 bits, rather than the default (16 bits).
117 int "Maximum VBUS Power usage (2-500 mA)"
123 batteries. This is in addition to any local power supply,
127 milliAmperes. The permitted range of values is 2 - 500 mA;
130 This value will be used except for system-specific gadget
133 # Selected by UDC drivers that support high-speed operation.
148 Enable mass storage protocol support in U-Boot. It allows exporting
154 Rockusb protocol is widely used by Rockchip SoC based devices. It can
162 Enable Serial Download Protocol (SDP) device support in U-Boot. This
169 Enable Tizen's THOR download protocol support in U-Boot. It
181 (U-Boot) and the host (remote device) that can be used just like any
192 There is several models (protocols) to implement Ethernet over USB
193 devices. The main ones are Microsoft's RNDIS and USB's CDC-Ethernet
194 (also called CDC-ECM). RNDIS is obviously compatible with Windows,
195 while CDC-ECM is not. Most other operating systems support both, so
196 if inter-operability is a concern, RNDIS is to be preferred.
199 bool "CDC-ECM Protocol"
201 CDC (Communications Device Class) is the standard for Ethernet over
203 protocol is ECM (Ethernet Control Model). However, compatibility with
204 Windows is not that great.
209 The RNDIS (Remote Network Driver Interface Specification) is a
220 Ethernet MAC address of the device-side (ie. local board's) MAC
227 Ethernet MAC address of the host-side (ie. remote device's) MAC