Lines Matching +full:master +full:- +full:side
6 # NOTE: Gadget support ** DOES NOT ** depend on host-side CONFIG_USB !!
8 # - Host systems (like PCs) need CONFIG_USB (with "A" jacks).
9 # - Peripherals (like PDAs) need CONFIG_USB_GADGET (with "B" jacks).
10 # - Some systems have both kinds of controllers.
12 # With help from a special transceiver and a "Mini-AB" jack, systems with
13 # both kinds of controller can also support "USB On-the-Go" (CONFIG_USB_OTG).
19 USB is a master/slave protocol, organized with one master
22 you can't connect a "to-the-host" connector to a peripheral.
24 U-Boot can run in the host, or in the peripheral. In both cases
28 familiar host side controllers have names like "EHCI", "OHCI",
32 Enable this configuration option if you want to run U-Boot inside
34 peripheral/device side bus controller, and a "gadget driver" for
43 CDC-ACM (usbtty) for example.
57 default "U-Boot"
82 USBA is the integrated high-speed USB Device controller on
94 The Designware USB2.0 high-speed gadget controller
102 bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
104 Set the Designware USB2.0 high-speed OTG controller
117 int "Maximum VBUS Power usage (2-500 mA)"
127 milliAmperes. The permitted range of values is 2 - 500 mA;
130 This value will be used except for system-specific gadget
133 # Selected by UDC drivers that support high-speed operation.
148 Enable mass storage protocol support in U-Boot. It allows exporting
162 Enable Serial Download Protocol (SDP) device support in U-Boot. This
169 Enable Tizen's THOR download protocol support in U-Boot. It
181 (U-Boot) and the host (remote device) that can be used just like any
193 devices. The main ones are Microsoft's RNDIS and USB's CDC-Ethernet
194 (also called CDC-ECM). RNDIS is obviously compatible with Windows,
195 while CDC-ECM is not. Most other operating systems support both, so
196 if inter-operability is a concern, RNDIS is to be preferred.
199 bool "CDC-ECM Protocol"
220 Ethernet MAC address of the device-side (ie. local board's) MAC
227 Ethernet MAC address of the host-side (ie. remote device's) MAC