drivers/net/e1000.c

6 tested on both gig copper and gig fiber boards
2650 * Copper link setup for e1000_phy_igp series.
2873 * Copper link setup for e1000_phy_gg82563 series.
3022 * Copper link setup for e1000_phy_m88 series.
3572  * software when a Copper PHY is used because autonegotiation is managed
3671 	/* Check for the case where we have copper media and auto-neg is  in e1000_config_fc_after_link_up()
3844 			    ("Copper PHY and Auto Neg has not completed.\r\n");  in e1000_config_fc_after_link_up()
3885 	/* If we have a copper PHY then we only want to go out to the PHY  in e1000_check_for_link()
3942 		/* At this point we know that we are on copper and we have  in e1000_check_for_link()
5105 	/* Media type - copper or fiber */  in e1000_sw_init()
5116 			DEBUGOUT("copper interface\n");  in e1000_sw_init()