Lines Matching +full:i2c +full:- +full:tegra

45 	   Enable support for I2C connected Atmel's ATSHA204A
50         bool "Rockchip e-fuse support"
53 	  Enable (read-only) access for the e-fuse block found in Rockchip
55 	  or through child-nodes that are generated based on the e-fuse map
74 	  Enable command-line access to the Chrome OS EC (Embedded
76 	  a number of sub-commands for performing EC tasks such as
78 	  and talking to the I2C bus behind the EC (if there is one).
90 	bool "Enable Chrome OS EC I2C driver"
93 	  Enable I2C access to the Chrome OS EC. This is used on older
95 	  changed to SPI. The EC will accept commands across the I2C using
102 	  Enable I2C access to the Chrome OS EC. This is used on x86
112 	  keyboard (use the -l flag to enable the LCD), verified boot context,
121 	  ARM Chromebooks such as pit, pi and nyan-big. The SPI interface
122 	  provides a faster and more robust interface than I2C but the bugs
129 	  integrated 64-byte EEPROM, four programmable non-volatile I/O pins
131 	  connected over I2C.
163 	bool "Enable power-sequencing drivers"
166 	  Power-sequencing drivers provide support for controlling power for
172 	bool "Enable power-sequencing drivers for SPL"
175 	  Power-sequencing drivers provide support for controlling power for
184 	  is connected via I2C. So I2C needs to be enabled.
187 	hex "I2C address of PCA9551 LED controller"
191 	  The I2C address of the PCA9551 LED controller.
212 	bool "Enable support for the Tegra CAR driver"
215 	  The Tegra CAR (Clock and Reset Controller) is a HW module that
216 	  controls almost all clocks and resets in a Tegra SoC.
222 	  The Tegra BPMP (Boot and Power Management Processor) is a separate
223 	  auxiliary CPU embedded into Tegra to perform power management work,
225 	  PMIC I2C bus, etc. This driver provides the core low-level
226 	  communication path by which feature-specific drivers (such as clock)
250 	bool "Enable driver for generic I2C-attached EEPROMs"
253 	  Enable a generic driver for EEPROMs attached via I2C.
257 	bool "Enable driver for generic I2C-attached EEPROMs for SPL"
260 	  This option is an SPL-variant of the I2C_EEPROM option.
264 	hex "Set the I2C MAC offset"
268 	  Set the MAC offset for i2C.
277 	int "I2C bus of the EEPROM device."