Lines Matching +full:zynq +full:- +full:gpio +full:- +full:1
23 Enable old-style I2C functions for compatibility with existing code.
41 ---help---
43 often dealt with by using an I2C pass-through interface provided by
44 the EC. On some unfortunate models (e.g. Spring) the pass-through
70 Enable the i2c bus driver emulation by using the GPIOs. The bus GPIO
71 configuration is given by the device tree. Kernel-style device tree
73 Binding info: doc/device-tree-bindings/i2c/i2c-gpio.txt
82 i2c-gpio driver unless your system can cope with this limitation.
83 Binding info: doc/device-tree-bindings/i2c/i2c-at91.txt
97 e.g. used by Xilinx Zynq.
141 Only single master mode is supported and only byte-by-byte
167 both 7-bit and 10-bit addresses.
180 Add support for NXP MXC I2C Controller 1.
181 Required for SoCs which have I2C MXC controller 1 eg LS1088A, LS2080A
228 int "I2C Channel 1 speed"
232 MXC I2C Channel 1 speed
349 default 1
403 _ Standard-mode (up to 100 kHz)
404 _ Fast-mode (up to 400 kHz)
405 _ Fast-mode Plus (up to 1 MHz)
406 _ 7-bit and 10-bit addressing mode
407 _ Multiple 7-bit slave addresses (2 addresses, 1 with configurable mask)
408 _ All 7-bit addresses acknowledge mode
427 is used on PH1-LD4, PH1-sLD8 or older UniPhier SoCs.
430 bool "UniPhier FIFO-builtin I2C driver"
434 Support for UniPhier FIFO-builtin I2C controller driver.
435 This I2C controller is used on PH1-Pro4 or newer UniPhier SoCs.
452 bool "Enable Tegra186 BPMP-based I2C driver"