device-tree-bindings/net/fsl-tsec-phy.txt

1 * TSEC-compatible ethernet nodes
5   - compatible : Should be "fsl,tsec"
6   - reg : Offset and length of the register set for the device
7   - phy-handle : See ethernet.txt file in the same directory.
8   - phy-connection-type : See ethernet.txt file in the same directory. This
9     property is only really needed if the connection is of type "rgmii-id",
10     "rgmii-rxid" and "rgmii-txid" as all other connection types are detected
17 		phy-handle = <&phy0>;
18 		phy-connection-type = "sgmii";
21 Child nodes of the TSEC controller are typically the individual PHY devices
24 * MDIO IO device
26 The MDIO is a bus to which the PHY devices are connected.  For each
27 device that exists on this bus, a PHY node should be created.
30   - compatible : Should define the compatible device type for the
31     mdio. Currently supported string/device is "fsl,tsec-mdio".
32   - reg : Offset and length of the register set for the device
37 		compatible = "fsl,tsec-mdio";
40 		ethernet-phy@0 {
47 As of this writing, every tsec is associated with an internal TBI PHY.
48 This PHY is accessed through the local MDIO bus.  These buses are defined
52 with other PHYs on the bus.  The TBI PHYs are referred to by a "tbi-handle"
53 property under the tsec node, which has a similar meaning of "phy-handle".
57 		phy-handle = <&tbi1>;
61 		tbi1: tbi-phy@1f {